In order to investigate the effect of different loading models on the nonlinear variations in Global Positioning System (GPS) height time series, the characteristics of annual signals (amplitude and phase) of GPS time series, loading series from Deutsche GeoForschungsZentrum, Germany (GFZ) and School and Observatory of Earth Sciences, France (EOST) at 633 global GPS stations are processed and analyzed. The change characteristics of the root mean square (RMS) reduction rate, annual amplitude and phase of GPS time series after environmental loading corrections (ELCs) are then detected. Results show that ELCs have a positive effect on the reduction in the nonlinear deformation contained in most GPS stations around the world. RMS reduction rates are positive at 82.6% stations after GFZ correction and 87.4% after EOST correction, and the average reduction rates of all stations are 10.6% and 15.4%, respectively. As for the environmental loading series from GFZ and EOST, their average annual amplitudes are 2.7 and 3.1 mm, which explains ~40% annual amplitude of GPS height time series (7.2 mm). Further analysis of some specific stations indicates that the annual phase difference between GPS height time series and the environmental loading series is an important reason that affects the reduction rates of the RMS and annual amplitude. The linear relationship between the annual phase difference and the annual amplitude reduction rate is significant. The linear fitting results show that when there is no annual phase difference between GPS and loading series, the reduction rates of the RMS and annual amplitude will increase to the maximum of 15.6% and 41.6% for GFZ, and 22.0% and 46.6% for EOST.
The displacement of Global Navigation Satellite System (GNSS) station contains the information of surface elastic deformation caused by the variation of land water reserves. This paper selects the long-term coordinate series data of 671 International GNSS Service (IGS) reference stations distributed globally under the framework of World Geodetic System 1984 (WGS84) from 2000 to 2021. Different noise model combinations are used for noise analysis, and the optimal noise model for each station before and after hydrologic loading correction is calculated. The results show that the noise models of global IGS reference stations are diverse, and each component has different optimal noise model characteristics, mainly white noise + flicker noise (WN+FN), generalized Gauss–Markov noise (GGM) and white noise + power law noise (WN+PL). Through specific analysis between the optimal noise model and the time series velocity of the station, it is found that the maximum influence value of the vertical velocity can reach 1.8 mm when hydrological loading is considered. Different complex noise models also have a certain influence on the linear velocity and velocity uncertainty of the station. Among them, the influence of white noise + random walking noise is relatively obvious, and its maximum influence value in the elevation direction can reach over 2 mm/year. When studying the impact of hydrological loading correction on the periodicity of the coordinate series, it is concluded whether the hydrological loading is calculated or not, and the GNSS long-term coordinate series has obvious annual and semi-annual amplitude changes, which are most obvious in the vertical direction, up to 16.48 mm.
14 September 2023 in IEEE Transactions on Geoscience and Remote Sensing
GNSS coordinate time series reflects the combined influence of geophysical factors on stations around the land surface. Although some traditional parameterized methods are helpful to determine the magnitude of the seasonal signal at GNSS stations, the annual variation characteristics of the stations are not static, thus it is quite necessary to extract finer periodic signals with time-varying coefficients (PSTC) from stations’ position time series. This paper focuses on the height time series of 243 stations from the Crustal Movement Observation Network of China (CMONOC) and employs singular spectrum analysis (SSA) to extract PSTC. The results show that SSA method can effectively extract the time-varying trend and periodic terms from the original time series, which cannot be perfectly achieved by parameterized methods. SSA method reduces the RMSE value of the residual time series at 90.5% CMONOC stations, compared with the results of maximum likelihood estimation (MLE). Its function in extracting the PSTC from CMONOC stations is significant for further explaining the generation mechanism of the land surface nonlinear deformation in China. Different from MLE method which only considers the given epochs of offsets, SSA method can effectively fit the original time series through singular value decomposition (SVD) and signal reconstruction, despite there are unrecognized offsets contained in GNSS time series. It still works well when there is an offset up to 20 mm, which would reduce the traditional workload of offset detection by sight. SSA method manages to distinguish large unknown offsets, showing as negative improvement rates.
Integer ambiguity resolution is required to obtain precise coordinates for the global navigation satellite system (GNSS). Poorly observed data cause unfixed integer ambiguity and reduce the coordinate accuracy. Previous studies mostly used denoise filters and partial ambiguity resolution algorithms to address this problem. This study proposes a sequential ambiguity resolution method that includes a float solution substitution process and a double-difference (DD) iterative correction equation process. The float solution substitution process updates the initial float solution, while the DD iterative correction equation process is used to eliminate the residual biases. The satellite-selection experiment shows that the float solution substitution process is adequate to obtain a more accurate float solution. The iteration-correction experiment shows that the double-difference iterative correction equation process is feasible with an improvement in the ambiguity success rate from 28.4% to 96.2%. The superiority experiment shows significant improvement in the ambiguity success rate from 36.1% to 83.6% and a better baseline difference from about 0.1 m to 0.04 m. It is proved that the proposed sequential ambiguity resolution method can significantly optimize the results for poorly-observed GNSS data.
Precise signal extraction and geophysical interpretation of Global Navigation Satellite System (GNSS) coordinate time series constitute the core foundation for establishing the International Terrestrial Reference Frame (ITRF) and inverting surface mass redistribution. This paper reviews major advances in this field across four dimensions: model framework, signal characteristics, extraction methods, and geophysical mechanisms. Key findings include: (1) Maximum Likelihood Estimation (MLE) has become the recognized standard for linear trend extraction: by jointly estimating deformation parameters and the noise covariance, it corrects the up to 5–10-fold underestimation of velocity uncertainty that arises in conventional least-squares analyses when colored noise is present but a white-noise covariance is assumed; (2) in CMONOC benchmark tests reported by Wu et al., Variational Mode Decomposition (VMD) achieves an average 69.8% residual RMS reduction at 97.9% of stations—results that are promising but not yet independently replicated on other networks—while the self-supervised model GNSS-FM (currently an unreviewed preprint) represents an emerging intelligent analysis paradigm; (3) the combined effect of atmospheric, non-tidal ocean and hydrological loading explains about 42% of the residual power of the annual vertical signal globally after pole tide correction and reduces the weighted mean vertical annual amplitude from 4.19 mm to 3.19 mm, while for horizontal components the fraction explained by current loading models is much smaller (amplitude ratio, explained variance and RMS/WRMS reduction are distinct metrics and are not directly interchangeable). This paper further highlights that the annual period was reported to fluctuate between 363 and 367 days at the ten CMONOC stations analyzed by Li et al.—a time variability that, if general, challenges fixed-frequency signal separation methods, although apparent period changes may also arise from amplitude/phase modulation, spectral leakage, finite-record effects, colored noise or data gaps—and it identifies thermoelastic deformation (TED) as a long-neglected but potentially quantifiable component, based on a recently released preprint dataset that has not yet undergone peer review. Finally, key research prospects are outlined, including physics-informed fusion methods, self-supervised foundation models, and a unified multi-source inversion framework.