Hicham Klaina

Dr. Hicham Klaina

Public University of Navarra, Pamplona, Navarre, Spain
orcid

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2022 in Measurement
Verified
Journal Article
Open access
Hicham KlainaHicham Klaina
Hicham Klaina
IGImanol Picallo Guembe
Imanol Picallo Guembe
PLPeio Lopez-Iturri
Peio Lopez-Iturri
MCMiguel Ángel Campo-Bescós
Miguel Ángel Campo-Bescós
LALeyre Azpilicueta
Leyre Azpilicueta
FFFrancisco Falcone
Francisco Falcone

7 July 2020 in IEEE Access
Verified
Journal Article
Open access
Hicham KlainaHicham Klaina
Hicham Klaina
Imanol Picallo GuembeImanol Picallo Guembe
Imanol Picallo Guembe
Peio Lopez-IturriPeio Lopez-Iturri
Peio Lopez-Iturri
Jose Javier AstrainJose Javier Astrain
Jose Javier Astrain
Leyre AzpilicuetaLeyre Azpilicueta
Leyre Azpilicueta
Francisco FalconeFrancisco Falcone
Francisco Falcone
Recently, there has been growing attention to the power grid management due to the increasing concerns on global warming. With the advancement in electric vehicles (EV) industry and the evolution in batteries, EVs become an important contributor to the grid with capability of bidirectional power exchange with the grid. In this context, Vehicle-to-Grid (V2G) systems enable multiple functionalities between EVs and the corresponding aggregator. Thus, reliable, long-range communication capabilities between aggregator and EVs is compulsory. In this paper, wireless channel analysis for aggregator and electrical vehicle communication using Long-Range Wide Area Network (LoRaWAN) technology in V2G is presented, in order to test a low-cost solution with large coverage and reduced power consumption profile. Wireless channel and system-level measurements have been performed in a real urban scenario between EV’s charging station in Pamplona (Spain) and a vehicle in motion using LoRaWAN 868 MHz devices. Wireless channel characterization is performed by implementing a full 3D urban scenario model, including elements such as buildings, vehicles, users and urban infrastructure such as lamp posts and benches. By means of in-house developed 3D Ray Launching algorithm with hybrid simulation capabilities, estimations of received power levels, signal to noise ratio and time domain parameters have been obtained, for the complete volume of the scenario under test in dense urban conditions. V2G end to end communication has been validated by implementing an intra-vehicle Controller Area Network-BUS (CAN BUS) data gathering system connected to the vehicle LoRaWAN transceiver and subsequently, to a cloud-based web service. The results show that the accurate deterministic based radio channel analysis enables to optimize the network design of LoRaWAN networks in a vehicular environment, considering inter-vehicular and infrastructure links, enabling scalable, low cost end to end data exchange for the deployment of ancillary V2G services.

10 March 2021 in IEEE Access
Verified
Journal Article
Open access
AAAnas Al-Rahamneh
Anas Al-Rahamneh
Jose Javier AstrainJose Javier Astrain
Jose Javier Astrain
Jesus VilladangosJesus Villadangos
Jesus Villadangos
Hicham KlainaHicham Klaina
Hicham Klaina
Imanol Picallo GuembeImanol Picallo Guembe
Imanol Picallo Guembe
Francisco FalconeFrancisco Falcone
Francisco Falcone
In the last decades, the cities' capacity for generating digital information has grown exponentially. In this context, the successful implementation of smart cities' concept depends on the current possibility of handling the significant volumes of sensed data. This is particularly notorious in the case of urban mobility. Researchers in the field of urban planning have shown a great interest in urban mobility problems, proposing different route recommendation services towards making it easier and safer to move around the city. This paper addresses the development of an urban data platform and how to obtain and integrate information from sensors and other data sources to provide aggregated and intelligent views of raw data to support urban mobility. With the aim of evaluating the efficiency of the developed platform, we present an intelligent urban mobility solution, where the context-awareness, user preferences, and environmental factors play a significant role in the process of route planning. Finally, our work provides an experiment to assess different long-range wireless communication technologies to enable its implementation within an urban environment.

26 July 2018 in Sensors
Verified
Journal Article
Open access
PDF file
Hicham KlainaHicham Klaina
Hicham Klaina
AAAna Alejos
Ana Alejos
Otman AghzoutOtman Aghzout
Otman Aghzout
Francisco FalconeFrancisco Falcone
Francisco Falcone
In this contribution, a narrowband radio channel model is proposed for rural scenarios in which the radio link operates under near-ground conditions for application in wireless sensor networks dedicated to smart agriculture. The received power attenuation was measured for both transmitter and receiver antennas placed at two different heights above ground: 0.2 and 0.4 m. Three frequency ranges, proposed for future 5G-IoT use case in agriculture, were chosen: 868 MHz, 2.4 GHz and 5.8 GHz. Three ground coverings were tested in a rural scenario: soil, short and tall grass fields. The path loss was then estimated as dependent of the radio link range and a three-slope log-normal path loss model was tailored. Results are explained in terms of the first Fresnel zone obstruction. Commercial Zigbee sensor nodes operating at 2.4 GHz were used in a second experiment to estimate the link quality from the experimental Radio Signal Strength Indicator (RSSI) received values. Two sensor nodes were placed at the same elevation above ground as in the previous experiment, only for short grass field case. The Quality of Service performance was determined in terms of theoretical bit error rate achieved for different digital modulations—BPSK, 8PSK and 16QAM—concluding remarkable results for an obstructed radio link.

23 October 2019 in Sensors
Verified
Journal Article
Open access
PDF file
Imanol Picallo GuembeImanol Picallo Guembe
Imanol Picallo Guembe
Hicham KlainaHicham Klaina
Hicham Klaina
Peio Lopez-IturriPeio Lopez-Iturri
Peio Lopez-Iturri
EAErik Aguirre
Erik Aguirre
Mikel CelayaMikel Celaya
Mikel Celaya
AAAna Alejos
Ana Alejos
In this paper we consider the D2D (Device-to-Device) communication taking place between Wireless Sensor Networks (WSN) elements operating in vegetation environments in order to achieve the radio channel characterization at 2.4 GHz, focusing on the radio links blocked by oak and pine trees modelled from specimens found in a real recreation area located within forest environments. In order to fit and validate a radio channel model for this type of scenarios, both measurements and simulations by means of an in-house developed 3D Ray Launching algorithm have been performed, offering as outcomes the path loss and multipath information of the scenarios under study for forest immersed isolated trees and non-isolated trees. The specific forests, composed of thick in-leaf trees, are called Orgi Forest and Chandebrito, located respectively in Navarre and Galicia, Spain. A geometrical and dielectric model of the trees were created and introduced in the simulation software. We concluded that the scattering produced by the tree can be divided into two zones with different dominant propagation mechanisms: an obstructed line of sight (OLoS) zone far from the tree fitting a log-distance model, and a diffraction zone around the edge of the tree. 2D planes of delay spread value are also presented which similarly reflects the proposed two-zone model.

17 July 2020 in IEEE Access
Verified
Journal Article
Open access
Hicham KlainaHicham Klaina
Hicham Klaina
Imanol Picallo GuembeImanol Picallo Guembe
Imanol Picallo Guembe
Peio Lopez-IturriPeio Lopez-Iturri
Peio Lopez-Iturri
Jose Javier AstrainJose Javier Astrain
Jose Javier Astrain
Leyre AzpilicuetaLeyre Azpilicueta
Leyre Azpilicueta
Francisco FalconeFrancisco Falcone
Francisco Falcone
In this contribution, an end to end system to enable user interaction with a distributed botanical university campus garden is designed, implemented and tested. The proposed system employs different wireless links to collect data related to different bio physiological parameters of both the vegetation mass and the surrounding environment. Detailed analysis of these multilevel communication links is performed by using deterministic volumetric wireless channel estimation and considering underground, near ground and over ground radio propagation conditions. An in-house developed technique enables accurate wireless channel characterization for complete campus scenario considering the multiple link types and all its composing elements. Node definition and network topology is thus obtained by wireless channel analysis of over ground, near ground and underground communication for both 868 MHz and 2.4 GHz Wireless Sensor Networks in an inhomogeneous vegetation environment. Connectivity to enable user interaction as well as for telemetry and tele-control purposes within the campus is achieved by combining ZigBee and LoRaWAN transceivers with the corresponding sensor/actuator platforms. Coverage studies have been performed in order to assess communication capabilities in the set of multiple underground/near ground/over ground links, by means of deterministic channel analysis for the complete university campus location. Measurement results in lab environment as well as full system deployment are presented, showing good agreement with deterministic simulations. Moreover, system level tests have been performed over a physical campus cloud, providing adequate quality of experience metrics. The proposed solution is a scalable system that provides real time trees status monitoring by a cloud-based platform, enabling user interaction within a distributed botanical garden environment in the university campus.