The temperature inside broiler houses is crucial to broiler health, welfare, and productivity. High stocking density in broiler houses can easily lead to nonuniform temperature conditions, which would cause broilers to suffer cold and heat stress. It is essential to assess the temperature distribution inside broiler houses and investigate the factors that affect temperature uniformity. Therefore, in this study, temperature, wind velocity, and differential pressure were monitored in the aisle, at the sidewall inlet, and outside the sidewalls of a commercial stacked-deck cage broiler house in Northeast China aiming to continuously monitor the temperature throughout the entire fattening period. Results show that the maximum temperature difference increased from 1.85 °C to 6.43 °C, while the daily fluctuation increased from 2.27 °C to 5.80 °C. The highest temperature was consistently recorded at the side of the exhaust fans (p < 0.001) in the longitudinal direction. In the lateral direction, the temperature difference varies periodically with solar radiation. The average temperature at the southern location (23.58 ± 1.97 °C), which faces the sun, was higher than that at the northern location (23.35 ± 1.38 °C), which is in the shade, during periods of solar radiation (p < 0.001) at the last testing period. However, without solar radiation, the northern location recorded a warmer temperature (23.19 ± 1.41 °C) compared to the southern location (22.30 ± 1.67 °C) (p < 0.001). The lateral temperature differences are strongly positively correlated with solar radiation and wind speed (p < 0.001). In conclusion, the inside temperature nonuniformity and fluctuation increased as the broiler age increased, which affected the production performance of broilers. Nonuniform solar radiation and wind speed can lead to differences in the inlet temperature and air volume between both sidewalls, thereby affecting the uniformity of the lateral temperature inside the house.

Low-pressure systems (LPSs) are among the most critical weather systems, producing excessive precipitation that causes air temperatures to drop and rise considerably. Acute temperature changes directly affect poultry feed intake (FI) and laying performance. To explore the effects of LPSs on hens, the parameters of air temperature, relative humidity, egg production, and feed utilization efficiency were evaluated during different LPSs in three houses. Results indicated that about 2.8 ± 0.7 d, 2.4 ± 0.5 d, and 2.4 ± 0.5 d before the LPS landfall in houses 1, 2, and 3, respectively, the indoor air temperature started to decrease, with the average decreases being 1.7 °C ± 0.4 °C, 2.4 °C ± 0.6 °C, and 1.8 °C ± 0.4 °C, respectively. Significant differences were observed between different LPSs for reducing indoor air temperature (p < 0.05) in the three houses. In house 1, the egg production rates (EPRs) were decreased by 6.6% and 1.1% when LPSs 1 and 2 landed. The average egg weight (AEW) and FI during the LPS landfall were significantly higher than those before the LPS landfall (p < 0.01). Under successive LPSs landfall in the three houses, the EPRs initially reduced by 3.9%, 4.0%, and 0.5%, respectively, but the second LPS event increased the EPRs by 1.8%, 5.3%, and 1.0%, respectively. Furthermore, the LPS landfall increased the feed conversion ratio (FCR_e) in the three houses, all above 2.00. In conclusion, LPSs can reduce heat stress, lower the EPRs, and lead to higher FI, FCR_e, and AEW.

Optimum insulation thickness for the sandwich structure livestock buildings external envelopes in different climate regions of China

Excessive mating is a significant welfare concern for floor-reared broiler breeder hens. Perches have shown potential as a solution to mitigate this issue; however, limited research is available on the design parameters of perches. Understanding the jumping characteristics of broiler breeder hens is crucial for designing safe and functional perches. In this study, perching platforms were selected to ensure the safety of hens during jumps. Videos of hens performing voluntary jumps from varying heights (35, 40, 45, and 50 cm) were analyzed using Tracker (version 6.2.0) software. The results showed that the take-off latency (TL) and jump duration (JD) increased with height increases, with downward jumps exhibiting a 66.1% and 10.7% higher TL and JD than those of upward jumps (based on mean values), respectively. However, the latency to achieve balance (LAB) decreased by 76.5% during downward jumps (based on mean values). During upward jumps, both the wing-beating frequencies during the jump (WBJD) and after landing (WBL) increased with height increases. The interaction between the height and direction of jumping significantly affected the horizontal displacement (body) and angles (body and head) during the JL phase (p < 0.05). The body horizontal displacement during downward jumps was up to 70.3% higher than that during upward jumps (based on mean values), while the downward body angles were more minor than those during upward jumps. The lowest body and head angles of downward jumps were 42.2° ± 5.4° and 33.4° ± 5.6°, respectively. The results related to TL and LAB are expected to provide guidance for designing appropriate heights in perching facilities. Meanwhile, the findings on horizontal displacement and jump angles offer valuable insights for the safe distance and angle design between perching platforms.

Alternative housing systems for laying hens, such as the aviary, promote the expression of dustbathing behavior by providing substrate materials to improve their welfare. However, extensive litter areas in aviaries can lead to reduced air quality and increased incidence of diseases, making them unsuitable for deployment in new large cage aviary unit (LCAU) systems in China. Dust baths have advantages in terms of continuous availability, but their design lacks unified standards. This study explored the effects of different areas, shapes (circular and square), and substrate depths (1 cm, 5 cm, 9 cm) of dust baths on dustbathing behavior in LCAU systems by recording digital video. Each LCAU system was initially populated with 305 Jingfen No. 2 laying hens at 50 days of age. The dust baths were initially placed on the bottommost tier at 66 days of age. The results showed that after approximately 3 weeks of adaptation to dustbathing, the average daily proportion of dustbathing hens within the flock stabilized at approximately 10%. A 50 cm diameter circular dust bath could accommodate their dustbathing requirements. Increasing the number of circular dust baths to 2 did not significantly affect the daily proportion of dustbathing hens. Both the circular dust bath and a 5 cm depth substrate resulted in better expression of the hens’ side rubbing behavior and the lower frequency of tossing behavior.