Single-layer metallic rings are the effective structure cell which are widely used to design single-band and multiband perfect metamaterial absorbers owning to their electromagnetic resonance. However, the absorbers based on the single-layer metallic rings have a common shortcoming, that is the narrow absorption bandwidth. To overcome the limitations, here we proposed a single-layer, flexible and broadband terahertz metamaterial absorber, which consists of four sub-cells with multiple metal rings and a metal ground plane separated by a dielectric layer. By enhancing the coupling response between adjacent metallic rings and merging the adjacent resonant peaks of multi-resonators, we experimentally observed broadband characteristics at the terahertz band. The average absorption of 88% from 0.63 to 1.34 THz and the relative absorption bandwidth of 95% at the incident angle of 15o for TE polarization. Correspondingly, for TM polarization the absorption of more than 80% from 0.61 to 1.1 THz with the relative absorption bandwidth of 80% were also observed. The results went far beyond the previous single-layer absorbers based on metal rings and were much better than the fractal-cross structure reported recently [Kenney et al., ACS Photonics 4, 2604 (2017)]. We had reason to believe that the presented terahertz metamaterial absorber with broad absorption bandwidth and simple structure can find important applications in communication, stealth, energy harvesting systems and so on.
We propose and experimentally demonstrate a novel strategy to achieve dual‐band symmetry‐protected bound states in the continuum (BICs) in silicon metasurfaces. This strategy is based on the hybridization of Mie surface lattice resonances (SLRs) in periodic silicon bipartite nanodisk arrays, of which the central nanodisk displaced from the center of the unit cell. We show that dual‐band electric quadrupole and magnetic dipole BICs can be supported in such a system, and transfer to quasi‐BICs with ultrahigh measured quality factors up to 1240 at the Γ point. Taking advantage of the SLR characteristics, we show that the spectral separation and the quality factors of these two quasi‐BICs can be conveniently tuned by varying the nanodisk diameter or the lattice period. Making use of these dual‐band quasi‐BICs, we numerically obtain bulk sensitivities above 480 nm/RIU and high figures of merit up to 1200. We also show that when the central nanodisk is not displaced but has different diameter, the silicon bipartite nanodisk array supports an electric dipole BIC that was referred to as subradiant SLR in the literature. Our work provides a new approach for realizing and tuning dual‐band BICs, and the obtained ultrahigh‐ Q quasi‐BICs can find potential applications in nonlinear optics, multimodal lasing, and optical sensing.
We propose a plasmonic platform for achieving out-of-plane quadrupolar plasmonic surface lattice resonances (SLRs) with large quality factors. The proposed platform is composed of a horizontal metal–insulator–metal (MIM) grating embedded in a homogeneous dielectric environment. Numerical results based on rigorous coupled-wave analysis show that under oblique incidences, high-Q out-of-plane quadrupolar SLRs can be excited at wavelengths of 1242 nm over a wide range of insulator widths, and the quality factor can reach 1036. As a comparison, under the same conditions, only dipolar SLRs with much lower quality factors of can be excited in a vertical MIM grating, which has the same period and a quarter-turned unit cell. We expect that the proposed high-Q quadrupolar SLR platform will find applications in light–matter interactions on the nanoscale.
We experimentally demonstrate the tuning of accidental bound states in the continuum (A‐BICs) in silicon nanodisk arrays. The A‐BIC emerges of the destructive interference of multipoles, which are the dominating out‐of‐plane electric dipole and in‐plane magnetic dipole, and weak electric quadrupole and magnetic quadrupole. We further show that the spectral and angular position of the A‐BIC can be conveniently tuned by varying the nanodisk size or the lattice period. Remarkably, the angular position can be tuned even to 0°, suggesting an interesting transition of the A‐BIC from an off‐Γ‐BIC to an at‐Γ‐BIC. Our work provides a new strategy for light trapping with high quality factors, and the obtained tunable A‐BICs can find potential applications in low‐threshold lasing, enhanced nonlinear optics, and optical sensing.
Wave plates as important polarization control devices are widely used in the applications of biomedical imaging, fiber optical communication, astronomy, semiconductor industry and aerospace etc. To make the wave plate actively tunable, we propose a rectangular antenna-based metasurface based on the phase-changing material Ge2Sb2Te5 (GST) with high transmittance and polarization conversion rate. Before the GST phase transition, the metasurface operates as a quarter-wave plate in the wavelength range of 10.0-11.9 μm. After the GST turning into crystalline state, the metasurface operates as a half-wave plate in the wavelength range of 10.3-10.9 μm. The physical mechanism for the high transmittance efficiency and polarization conversion rate attributes to the combination of the electric dipole and magnetic dipole resonances. Moreover, the adjustable wavelength range can be further extended by changing the geometry of antenna-based GST to selectively enhancing or suppressing the electric and magnetic resonances. This work provides a new strategy for tunable wave plate, which would have the potential in the application of multi-functional integrated optical systems.
A simple, effective, and productive method to fabricate an ordered Au pore array of Au/Ag nanoparticles is proposed in this article. Using a polystyrene sphere (PS) colloidal monolayer as the template, the electrodeposition is carried out in a HAuCl4 electrolyte under a constant cathodic current density of 0.04 mA cm−2 for 5 h at room temperature. After removing the PS colloidal monolayer, a Au bowl-like array is obtained. Then nanoparticles are ion-sputtered onto the array at a deposition current of 10 mA for 12 min. The ordered Au pore array with Au/Ag nanoparticles exhibits a strong SERS performance for R6G as the probe molecule. The enhancement mainly comes from coupling between the nanoparticles and the pores. The finite-difference time-domain (FDTD) method is used to calculate the local electric field distribution near the nanostructure. The simulation results agree well with the experiments.