In this research, new composite materials were improved by reinforcing the environment-polluting waste polyurethane (WPU) to unsaturated polyester (UP). Polyester composites were produced with WPU, UP, methyl ethyl ketone peroxide (MEKP), and cobalt octoate (Co. Oc.). The effect of WPU on the changes in density, Shore D hardness, thermal conductivity coefficient, thermal stability, and porosity of the obtained composites were investigated. According to the findings, as WPU ratio increased in the composite, both the thermal conductivity coefficient and the density of the composite decreased. Shore D hardness was been found to decrease as the rate of WPU in polyester composites raised. The use of optimum WPU ratios (7 wt.%) in composite production improved some thermo-physical properties of polyester composite. The high use of WPU negatively affected both the surface morphology and thermal stability of the polyester composite. In addition, the parameters affecting the production of polyester composites were optimized according to response surface methodology (RSM).
31 December 2021 in Hittite Journal of Science and Engineering
In this research, some physical and chemical properties of the biocomposite obtained from synthesized epoxy modified palm oil (MPO) and epoxy resin have been characterized. The experimental study plan is made according to Response Surface Methodology (RSM) and biocomposites with different MPO rates are obtained. The chemical bond structure of MPO and epoxy biocomposite has been evaluated with Fourier Transform Infrared Spektrofotometre (FTIR). The experimental, and RSM model results obtained, the density of the biocomposite rise as the MPO rate increases. It is determined that the Shore D hardness of the biocomposite is inversely proportional to the MPO rate by mass. The thermal conductivity coefficient and thermal stability also rise with the rate of MPO (wt.%) in the biocomposite. In the thermal degradation experiments of the obtained biocomposite, it is observed that the thermal stability of the composite goes up as the MPO rate rises. Activation energies are calculated using the Flynn Wall Ozawa, Kissinger, and Coats Redfern models. The activation energies calculated for the 9th, 2nd, and 13th experiments according to the Flynn Wall Ozawa method are approximately 139.65, 143.56, and 145.28 kJ/mol, respectively. The function with the highest R2 value has been determined according to the Coats Redfern method, and the deviation in Flynn Wall Ozawa and Kissinger model results was below 7%.
11 February 2022 in Biomass Conversion and Biorefinery