The wood biomass obtained from four tree species: spruce, beech, willow and alder was studied. Sawdust obtained by sawing of wood was dried in a convective dryer at 80 °C, without drying-agent flow. The measurements taken with oven-drying method covered determination of initial moisture and its detailed changes during entire drying process. Both DSC curves and spectral data from infrared spectra registered in the classic MIR range were also used to monitor change in water content in studied samples within entire drying process. Results obtained suggest that the DSC curves can be efficiently used as a discriminant to distinguish dry and wet biomass samples, as significant differences within courses of specific DSC curves of woody biomass before and after drying process occurred. Calorimetrically measured values of enthalpy of evaporation of water and water content in studied biomass samples were directly proportional to high determination coefficient, i.e. 0.9653. Statistical analysis proved quantitative directly proportional correlation between content of water measured with oven-drying method and IR spectral data of studied samples.
26 May 2017 in Journal of Thermal Analysis and Calorimetry
The aim of this study was the analytical evaluations of human milk fat substitutes (HMFS) synthesized via enzymatic interesterification of lard and milk thistle oil mixtures by a immobilized commercial sn-1,3-specific lipase, using calorimetric and chromatographic methods. The mixtures of lard and milk thistle oil at mass ratio 6:4 and 8:2 were interesterified for 2, 4 and 6 h at the temperature of 60 °C. The determination of fatty acid composition was carried out by gas chromatographic analysis of fatty acid methyl esters. The positional distribution of fatty acids in the sn-2 and sn-1,3 positions of triacylglycerols was based on the ability of the pancreatic lipase to selectively hydrolyze ester bonds in the sn-1,3 positions. Pressure differential scanning calorimetry (PDSC) method was used for the determination of the oxidative stability of HMFS. The oxidative induction time was obtained from the PDSC curves. Due to enzymatic interesterification of mixtures of lard and milk thistle oil, new HMFS that have a similar regiospecific structure of triacylglycerols to human milk fat can be produced. The induction time obtained from PDSC measurements can be used as a parameter for the assessment of the resistance of tested fats to their thermal-oxidative decomposition.
The article proposes to use machine learning as one of the areas of artificial intelligence to forecast the volume of biogas production from household organic waste. The use of five regression algorithms (Linear Regression, Ridge Regression, Lasso Regression, Random Forest Regression, and Gradient Boosting Regression) to create an effective model for forecasting the volume of biogas production from household organic waste is considered. Based on the comparison of these algorithms by MSE and MAE indicators, the quality of training and their accuracy during forecasting are evaluated. The proposed algorithm for creating a model for forecasting biogas production volumes from household organic waste involves the implementation of 10 main and 3 auxiliary steps. Their advantage is that they aid in the performance of component data analysis, which is carried out based on the method of reducing the dimensionality of the data set, increasing interpretability, and minimizing the risk of data loss. An analysis of 2433 data is was carried out, which characterizes the formation of biogas from food (FW) and yard waste (YW) according to four features. Data preparation is performed using the Jupyter Notebook environment in Python. We select five machine learning algorithms to substantiate an effective model for forecasting volumes of biogas production from household organic waste. On the basis of the conducted research, the main advantages and disadvantages of the used algorithms for building forecasting models of biogas production volumes from household organic waste are determined. It is found that two models, “Random Forest Regressor” and “Gradient Boosting Regressor”, show the best accuracy indicators. The other three models (Linear Regression, Ridge Regression, Lasso Regression) are inferior in accuracy and were not considered further. To determine the accuracy of the “Random Forest Regressor” and “Gradient Boosting Regressor” models, we choose the MSE and MAE indicators. The Random Forest Regressor model is found to be a more accurate model compared to the Gradient Boosting Regressor. This is confirmed by the fact that the MSE of the “Random Forest Regressor” model on the training data set is 7.14 times smaller than that of the “Gradient Boosting Regressor” model. At the same time, MAE is 2.67 times smaller in the “Random Forest Regressor” model than in the “Gradient Boosting Regressor” model. The MSE and MAE of both models are worse on the test data set, which indicates overtraining tendencies. The Gradient Boosting Regressor model has worse MSE and MAE than the Random Forest Regressor model on both the training and test data sets. It is established that the model based on the “Random Forest Regressor” algorithm is the most effective for forecasting the volume of biogas production from household organic waste. It provides MAE = 0.088 on test data and the smallest absolute errors in predictions. Further systematic improvement of the “Random Forest Regressor” model for forecasting biogas production volumes from household organic waste based on new data will ensure its accuracy and maintain competitive advantages.
9 November 2012 in Journal of Thermal Analysis and Calorimetry
The aim of this paper was to assess the oxidative stability of structured lipids synthesized by enzymatic interesterification of a blend of lard and rapeseed oil with concentrates of n − 3 fatty acids. Differential scanning calorimetry was used to evaluate the oxidation induction time of interesterified fats as a parameter assessing resistance of tested fats to their thermal-oxidative decomposition. Moreover, the IR spectra registered in the classic spectral range (4000–400 cm−1) were used to differentiate the samples of interesterified fats. The results show that the interesterification process decreased the induction time. Increased content polar fraction in the interesterified fatty product can reduce its resistance to oxidation. FT-IR data of selected spectral ranges correlate with the value of induction time at a statistically significant level. This is a proof that chemical changes occurring during different treatments of the starting mixture can be monitored by FT-IR spectroscopy. Moreover, obtained correlations can be used for the evaluation of an induction value of an unknown oil sample.
24 June 2014 in Journal of Thermal Analysis and Calorimetry
The aim of this study was to assess the possibilities to use brewer’s spent grains (BSGs) left over from beer production for energy purposes, and to determine its calorific value and chemical composition. The research materials were samples of wet spent grain from a brewery in Poland. Three samples, that are different in ingredient composition, were examined. The examined samples of BSGs were characterised by humidity that is typical for this product (approx. 77–80%). Convective drying of the spent grain contributed to a reduction in the water content in the biomass to below 10%. Samples of dry spent grain that were examined contained a similar amount of ash (3.8–4.1% d.m.) and organic matter (91.0–91.9% d.m.). All the examined spent grain samples demonstrated similar volatile matter content—approx. 77.8–78.7% d.m. and calorific value—approx. 15.6–15.9 MJ/kg. The estimated calorific value for wet samples (approx. 1.4–2.0 MJ/kg) indicated that it is necessary to lower water content in the biomass in order to improve its energy properties.