Traditional sound-absorbing materials have a number of disadvantages: low water resistance, low compressive and tensile strengths, low weather resistance, etc. Therefore, new sound-absorbing materials need to be developed with improved properties including the involvement of industrial byproducts. The influence of the grain-size composition of the rubber crumb from used car tires on the sound insulation of cement and gypsum composites was studied in the paper. The results of the study contribute to the creation of a structural material for the manufacture of sound-absorbing as well as load-bearing structures. The field of application of the developed materials is very extensive.
A comparative study of the fracture features, strength and deformation properties of pseudo strain-hardening composites based on alkali-activated slag and Portland cement matrices with polypropylene microfiber was carried out. Correlations between their compositions and characteristics of stress–strain diagrams under tension in bending with an additional determination of acoustic emission parameters were determined. An average strength alkali-activated slag matrix with compressive strength of 40 MPa and a high-strength Portland cement matrix with compressive strength of 70 MPa were used. The matrix compositions were selected for high filling the composites with polypropylene microfiber in the amount of 5%-vol. and 3.5%-vol. ensuring the workability at the low water-to-binder ratios of 0.22 and 0.3 for Portland cement and alkali-activated slag matrices, respectively. Deformation diagrams were obtained for all studied compositions. Peaks in the number of acoustic signals in alkali-activated slag composites were observed only in the strain-softening zone. Graphs of dependence of the rate of acoustic events occurrence in samples from the start of the test experimentally prove that this method of non-destructive testing can be used to monitor structures based on strain-hardening composites.
The physical and mechanical characteristics of expanded-clay lightweight concrete based on a supersulfated binder in comparison with lightweight concrete based on ordinary Portland cement were studied. In replacing CEM 32.5 with a supersulfated binder of 6000 cm2/g specific surface, one can increase the tensile strength in bending up to 20% and can increase the ratio of the tensile strength in bending to the compressive strength that indicates the crack resistance increase of concrete. Compressive strengths at the age of 28 days were equal to 17.0 MPa and 16.6 MPa for the supersulfated binder of 3500 cm2/g specific surface and CEM 32.5, respectively. Shrinkage deformation of hardening concrete, indicators of fracture toughness, frost resistance, and thermal conductivity were determined during the experimental works. The coefficient of thermal conductivity decreased up to 12% compared to the use of CEM 32.5. An enhancement in concrete properties was associated with the increase of supersulfated binder fineness.
27 May 2011 in Bulletin of Engineering Geology and the Environment
The paper presents analytical methods and results for assessing the variation in the concentration of sulphate (and other ions) over space and time in groundwater flowing through a soluble evaporite terrain beneath a dam. The influence of effective porosity, groundwater flow velocity and the specific rate of dissolution (K′) are considered. The theoretical analysis was tested in a scale model simulating a dam constructed on heavily karstified bedrock. A simple and useful method for assessing how much material is lost through dissolution and how the rate of dissolution changes over time is considered in the context of the Caspe Dam, Spain. L’article présente des calculs analytiques et des méthodes d’évaluation de la concentration en sulfates (et d’autres ions) d’eaux s’écoulant au travers de formations évaporitiques sous un barrage, concentrations variables dans l’espace et dans le temps. Les rôles de la porosité effective, de la vitesse d’écoulement de l’eau et du rapport de solubilité (K′) sont analysés. L’étude théorique a été testée pour un modèle à l’échelle représentant un barrage construit sur un substratum fortement karstifié. Une méthode simple et utile pour évaluer quelle quantité de matière est évacuée par dissolution et comment le taux de dissolution évolue en fonction du temps est présentée dans le contexte du barrage de Caspe en Espagne.
1 January 2016 in Journal of Cave and Karst Studies
The Fuentetoba Spring, with a mean flow of 210 L s-1, releases the discharge from an aquifer that comprises three hydraulically-connected synclines. The spring has a very irregular flow of between 8 L s-1 and 3,400 L s-1 due to the predominant water circulation that is non-Darcian turbulent flow as an underground torrent in the vadose zone, as well as through well-developed karstic conduits in the phreatic and epiphreatic zones, as attested to by speleological explorations. The long response times to recharge by the Fuentetoba karstic system, seen in the spring´s hydrograph, are controlled by regional factors. Nevertheless, certain responses that have very long time lags under high water conditions might be governed in the final stretch of the flowpath by mechanisms of pressure or siphoning of the floodwave, and perhaps by constrictions or plugs of sediment in the conduits
Many of the large number of underground works constructed or under construction in recent years are in unfavorable terrains facing unusual situations and construction conditions. This is the case of the subject under study in this paper: a tunnel excavated in evaporitic rocks that experienced significant karstification problems very quickly over time. As a result of this situation, the causes that may underlie this rapid karstification are investigated and a novel methodology is presented in civil engineering where the use of saturation indices for the different mineral specimens present has been crucial. The drainage of the rock massif of El Regajal (Madrid-Toledo, Spain, in the Madrid-Valencia high-speed train line) was studied and permitted the in-situ study of the hydrogeochemical evolution of water flow in the Miocene evaporitic materials of the Tajo Basin as a full-scale testing laboratory, that are conforms as a whole, a single aquifer. The work provides a novel methodology based on the calculation of activities through the hydrogeochemical study of water samples in different piezometers, estimating the saturation index of different saline materials and the dissolution capacity of the brine, which is surprisingly very high despite the high electrical conductivity. The circulating brine appears unsaturated with respect to thenardite, mirabilite, epsomite, glauberite, and halite. The alteration of the underground flow and the consequent renewal of the water of the aquifer by the infiltration water of rain and irrigation is the cause of the hydrogeochemical imbalance and the modification of the characteristics of the massif. These modifications include very important loss of material by dissolution, altering the resistance of the terrain and the increase of the porosity. Simultaneously, different expansive and recrystallization processes that decrease the porosity of the massif were identified in the present work. The hydrogeochemical study allows the evolution of these phenomena to be followed over time, and this, in turn, may facilitate the implementation of preventive works in civil engineering.