Nutrient consumption by plants depends on the growth stage and environmental conditions. In general, plants take up species of elements at different speeds. We monitored and recorded the electrical charge flow through xylem sap of tomato plants (Brillante F1) using femto/picoammeter equipment (Keysight B2981A). This technique evaluates the nutrient uptake of tomato treated with the most common macronutrients (KNO₃; KH₂PO₄; Ca(NO₃)₂; KCl) by monitoring the electrical conductivity for 24 h. The electrical conductivity of each treatment correlated with the plant growth and development stages. The results showed that the tomato plants had a high consumption of nutrients in the vegetative stage, while in other stages, they had a specific consumption, like phosphorus for bulb formation, potassium for increasing the number of flowers and water for the ripening of fruits. The quantitative evaluation of the ions absorbed by the plant was based on the magnitude and shape of the electrical conductivity curves. Our technique is an efficient method to determine nutrient consumption and is useful in predicting the deficiency of a certain element in tomato plants.

Fertigation is considered an efficient alternative to the enhanced use of chemical fertilizers. Since most of the fertigation systems rely on a theoretical electrical conductivity value of the nutrient solution, we tried to evaluate if this is the real need of the plants as well as if all the nutrients are needed at once. Therefore, we analyzed the electrical signals of the nutrients applied individually or in different mixes, correlating the electrical signals with the leaf gas exchange processes, studying the relation between the electrical signals and different plant phenological stages and the influence of the treatments on the lycopene content, nutritional composition, and antinutritional factors as well as the mineral bioavailability of tomato fruits cv. Brillante F1. The study was carried out in a greenhouse under controlled conditions. Ten different treatments consisting of MaEs (major elements) (V1—MgSO₄, V2—KNO₃, V3—K₂SO₄, V4—Ca(NO₃)₂, V5—KH₂PO₄, V6—KCl, V7—MgSO₄ + KNO₃ + KH₂PO₄, V8—K₂SO₄ + Ca(NO₃)₂ + KCl, V9—the mix of V1 to V6, commonly used in agricultural practices, V10—one nutrient each day) were applied daily when plants were 42 days old. The results showed that the values of the electrical signals varied depending on the treatment and the plant phenological stage. Five different trends of the electrical signals were identified. In addition, the shape of the signals varied during the day in accordance with the photosynthesis and the amount of CO₂ registered. The results of the treatments’ influence on the nutritional composition and lycopene content of tomato fruits suggested that plants do not need all the nutrients at once; the highest values are registered for K₂SO₄ fertilization. However, this fertilizer also had the highest registered tannin, saponin, and trypsin inhibitors content, constituting a disadvantage considering the high nutritional values and lycopene content. Regarding the bioavailability of zinc, calcium, and iron for the human diet, regardless of the treatment applied, phytic acid did not affect the availability of zinc and calcium, but it had a negative impact on iron availability; also, the amount of oxalate could impair the bioavailability of calcium. The study suggests that tomato plants do not need all nutrients at once for quality fruits. However, further studies are needed in order to develop a fertigation scheme based on a smart nutrient use that provides an improved nutritional composition and mineral bioavailability. In addition, it is necessary to evaluate the influence of treatments on yield.

This paper presents a method to separate the reversible and irreversible parts of magnetization in real ferromagnetic systems. The basic hypothesis is that the first-order reversal curve (FORC) diagram includes effects of both the reversible and irreversible components while the remanent second-order reversal curve (SORC_R) diagram includes essentially only the irreversible component. This means that the difference of the two diagrams describes only the reversible part. The experimental and simulated results were compared and the differences are discussed. Various scalar Preisach-type models have been used to simulate the FORC, SORC_R and the difference between the two distributions.

The climatic modifications lead to global warming; favouring the risk of the appearance and development of diseases are considered until now tropical diseases. Another important factor is the workers’ immigration, the economic crisis favouring the passive transmission of new species of culicidae from different areas. Malaria is the disease with the widest distribution in the globe. Millions of people are infected every year in Africa, India, South-East Asia, Middle East, and Central and South America, with more than 41% of the global population under the risk of infestation with malaria. The increase of the number of local cases reported in 2007–2011 indicates that the conditions can favour the high local transmission in the affected areas. In the situation presented, the establishment of the level of risk concerning the reemergence of malaria in Romania becomes a priority.

The prospect of replacing traditional chemical fertilization with organic and microorganism-based fertilization meets the current demand for more sustainable cropping systems and healthy food. In this respect, research was carried out to evaluate the effects of the factorial combination between four basil cultivars (‘Aromat de Buzau’, ‘Macedon’, ‘Cuisoare’ and ‘Serafim’) and three types of fertilization, namely chemical fertilization (with a solid chemical fertilizer), organic fertilization (with chicken manure formulate) and microorganisms’ fertilization (with microorganisms formulate), on basil yield, biochemical and physiological parameters and essential oil composition. The results showed that the biometric parameters (plant height, number of stems and leaves and leaf area) were significantly influenced by the cultivar; ‘Macedon’ obtained the highest values of plant height (64.7 cm) and number of stems (20.33) and leaves (618.3) and ‘Serafim’ the largest leaf area (4901.7 cm² per plant), while the type of fertilization did not affect these parameters. Regarding the biomass, the influence of the cultivar was not significant on fresh biomass but was significant on dry biomass, with ‘Macedon’ showing the highest value (56.4 g·plant⁻¹ dry biomass). The mentioned parameters were significantly influenced by the type of fertilization, with the highest values recorded with chemical fertilization. Both the cultivar and the fertilization type significantly influenced the physiological parameters (the total content of assimilatory pigments and photosynthesis). Five phenolic compounds were quantified from leaf extracts by HPLC-MS (caffeic acid, hyperoside, isoquercitrin, rutin and quercitrin). Hyperoside was identified only in ‘Macedon’, while the rest of the compounds were found in all the cultivars and varied depending on the cultivar and fertilization type. Regarding the composition of the essential oil, variation was found depending on the cultivar and fertilization type. In ‘Aromat de Buzau’, the main compounds were methyl chavicol and β-linalool; in ‘Macedon’, geranial and neral; and in ‘Cuisoare’ and ‘Serafim’, β-linalool. Moreover, the PCA showed that the ‘Serafim’ cultivar has exclusive properties compared to the other cultivars. Our results highlight that identifying the most effective interaction between genotype and fertilization type allows to optimize yield and quality targets for sweet basil.