In Naturally Occurring Asbestos (NOA) rich areas, water flows through asbestos bearing rocks and soils and generates waterborne fibres that may migrate in air and become a risk for humans. Research on the migration and dispersion after water vaporisation has been so far only marginally evaluated. This study investigates the migration in air of asbestos from a set of suspensions contaminated by chrysotile from Balangero (Italy), under controlled laboratory conditions. We evaluated i) the morphological modifications that might occur to chrysotile during migration from water to air, and ii) the amount of airborne chrysotile mobilised from standardised suspensions. Morphological alteration of asbestos fibres occurred during water-air migration and impacted on the analytical response of electron microscopy. Waterborne asbestos concentration higher than 40 ∙ 106 f/L generates in air concentration higher than 1 fibre per litre [f/L], the alarm threshold limit set by World Health Organization for airborne asbestos. A possible correlation between the waterborne fibre concentration as mass or number of fibres per volume unit [μg/L or f/L] was observed.
Asbestos inhalation is associated with fatal respiratory diseases and raises concerns from the perspective of workplace safety and environmental impacts. Asbestos and asbestos-like minerals naturally occur in rocks and may become airborne when outcrops or soils are disturbed by anthropic activities. In situ detection of these minerals is a crucial step for the risk evaluation of natural sites. We assess here whether a portable Raman spectrometer (pRS) may be used in the identification of asbestos and asbestos-like minerals at the mining front during exploitation. pRS performance was tested at three geologically different mining sites in Italy and New Caledonia and compared with a high-resolution micro-Raman spectrometer (HRS). About 80% of the overall in situ analyses at the mining front were successfully identified by pRS, even when intermixed phases or strongly disaggregated and altered samples were analyzed. Chrysotile and tremolite asbestos, asbestos-like antigorite, and balangeroite were correctly detected during surveys. The major difficulties faced during in situ pRS measurements were fluorescence emission and focussing the laser beam on non-cohesive bundles of fibers. pRS is adequate for discriminating asbestos and asbestos-like minerals in situ. pRS may support risk assessment of mining sites to better protect workers and environment.