Electrocatalytic materials are pivotal for clean chemical production and energy conversion in devices like electrolyzers and fuel cells. These materials usually consist of metallic nanoparticles which serve as active reaction sites, and support materials which provide high surface area, conductivity and stability. When designing novel electrocatalytic composites, the focus is often on the metallic sites, however, the significance of the support should not be overlooked. Carbon materials, valued for their conductivity and large surface area, are commonly used as support in benchmark electrocatalysts. However, using alternative support materials instead of carbon can be beneficial in certain cases. In this minireview, we summarize recent advancements and key directions in developing novel supports for electrocatalysis, encompassing both carbon and non-carbon materials.
100 nm thick TiO2/TiN bilayers with varying thickness ratios were deposited via reactive sputtering of a Ti target in controlled oxygen and nitrogen atmospheres. Post-deposition annealing in air at 600 °C was performed to induce nitrogen diffusion through the oxygen-deficient TiO2 layer. The resulting changes in morphology and chemical environment were investigated in detail using transmission electron microscopy (TEM), scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS), and UV-Vis spectroscopy. Detailed TEM and XPS analyses have confirmed nitrogen diffusion across the TiO2 layer, with surface nitrogen concentration and the ratio of interstitial to substitutional nitrogen dependent on the TiO2/TiN mass ratio. Optical studies demonstrated modifications in optical constants and a reduction of the effective bandgap from 3.2 eV to 2.6 eV due to new energy states introduced by nitrogen doping. Changes in surface free energy induced by nitrogen incorporation showed a correlation to nitrogen doping sites on the surface, which had positive effects on overall photocatalytic activity. Photocatalytic activity, assessed through methylene blue degradation, showed enhancement attributed to nitrogen doping. Additionally, deposition of a 5 nm gold layer on the annealed sample enabled investigation of synergistic effects between nitrogen doping and gold incorporation, resulting in further improved photocatalytic performance. These findings establish the TiO2/TiN bilayer as a versatile platform for supporting thin gold films with enhanced photocatalytic properties.
This work critically re-evaluates the photocatalytic performance of V₂O₅ nanopowders and underscores the need for rigorous dark controls and comprehensive spectroscopic analysis. Vanadium pentoxide (V₂O₅) is frequently reported as a visible-light photocatalyst, yet achieving consistent and reproducible results remains challenging. This study systematically compares V₂O₅ powders obtained by thermal calcination, hydrothermal synthesis, and a commercial sample for the removal of methylene blue (MB), rhodamine B (RhB), and methyl orange (MO). The results reveal pronounced dye-dependent behavior. MO degradation is completely obscured by dissolved vanadium species, a key but often neglected property. V₂O₅ shows weak activity toward RhB, removing 30% of the dye, about half via adsorption. For cationic MB, the negatively charged surface primarily acts as an adsorbent, eliminating over 80% of the dye within one hour, a process often misinterpreted as photocatalytic. Adsorption partially passivates the surface and slows V₂O₅ dissolution, but additional modification is required for genuinely photocatalytic applications. Overall, V₂O₅-based materials should be viewed not as straightforward visible-light photocatalysts, but as partially soluble adsorbents whose apparent activity is strongly dye-dependent and easily overestimated without stringent controls and full optical characterization.