Jie Zhou

Prof. Dr. Jie Zhou

Electrical and Computer Engineering, The University of Texas at Dallas, Richardson, Texas, USA
orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 July 2022 in Science Advances
Verified
Journal Article
Open access
TLTzu-Li Liu
Tzu-Li Liu
YDYan Dong
Yan Dong
SCShulin Chen
Shulin Chen
JZJie Zhou
Jie Zhou
ZMZhenqiang Ma
Zhenqiang Ma
JLJinghua Li
Jinghua Li
Tracking the concentration of biomarkers in biofluids can provide crucial information about health status. However, the complexity and nonideal form factors of conventional digital wireless schemes impose challenges in realizing biointegrated, lightweight, and miniaturized sensors. Inspired by the working principle of tuning circuits in radio frequency electronics, this study reports a class of battery-free wireless biochemical sensors: In a resonance circuit, the coupling between a sensing interface and an inductor-capacitor oscillator through a pair of varactor diodes converts a change in electric potential into a modulation in capacitance, resulting in a quantifiable shift of the resonance circuit. Proper design of sensing interfaces with biorecognition elements enables the detection of various biomarkers, including ions, neurotransmitters, and metabolites. Demonstrations of “smart accessories” and miniaturized probes suggest the broad utility of this circuit model. The design concepts and sensing strategies provide a realistic pathway to building biointegrated electronics for wireless biochemical sensing.

27 April 2024 in Applied Surface Science
Verified
Journal Article
Closed access
JZJie Zhou
Jie Zhou
JGJiarui Gong
Jiarui Gong
MSMoheb Sheikhi
Moheb Sheikhi
ADAshok Dheenan
Ashok Dheenan
QWQingxiao Wang
Qingxiao Wang
ZMZhenqiang Ma
Zhenqiang Ma

12 February 2024 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
SXShuwen Xie
Shuwen Xie
MSMoheb Sheikhi
Moheb Sheikhi
SXShining Xu
Shining Xu
TATahmidul Alam
Tahmidul Alam
JZJie Zhou
Jie Zhou
CGChirag Gupta
Chirag Gupta
As an attractive next generation ultrawide bandgap material, Ga2O3 has been demonstrated to be capable of high voltage operation. However, the lack of shallow p-type dopant in Ga2O3 leads to difficulties in developing Ga2O3 based bipolar devices. The semiconductor grafting technology, by bonding a single crystalline p-type semiconductor nanomembrane (NM) to n-Ga2O3 to from abrupt heterojunction, offers a way to expand the application of Ga2O3 in bipolar areas. In this Letter, we report a p-GaAs/(001)-Ga2O3 heterojunction diode fabricated using semiconductor grafting technology. The single crystalline GaAs NM was prepared and transferred onto a Ga2O3 substrate, showing good integrity. Diodes of a mesa diameter of 25 μm were fabricated, showing a high breakdown voltage of ∼800 V, a power figure of merit of 126.5 MW/cm2, and a calculated 1D peak electric field of 1.60 MV/cm. The turn on voltage of the diode was determined to be around 1.91 V with an on–off ratio to be 6 × 106 at −4/4 V and the specific on resistance to be 5.06 mΩ cm2. The ideality factor was extracted to be approximately 1.34, indicating reasonable interface quality. The interfacial defects and the self-passivation effects of Ga2O3 are discussed, and the theoretical band diagram was analyzed for the p-GaAs/n-Ga2O3 heterojunction. By managing the peak electric field with suitable edge termination techniques, higher breakdown voltage can be expected. In addition, by taking advantage of the InGaAsP alloy system, a wide variety of GaAs-Ga2O3 based high voltage HBT can be further developed.

10 January 2024 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
SXShuwen Xie
Shuwen Xie
TATahmidul Alam
Tahmidul Alam
JGJiarui Gong
Jiarui Gong
QLQinchen Lin
Qinchen Lin
MSMoheb Sheikhi
Moheb Sheikhi
CGChirag Gupta
Chirag Gupta
In this work, we report a single crystalline p-Si/(001) β-Ga 2 O 3 heterojunction diode fabricated using semiconductor grafting technology. The diode showed a breakdown voltage (V br ) of ~0.86 kV, which is the highest breakdown voltage reported for Si/(001) Ga 2 O 3 heterojunction diode to date. The average peak electric field (E m ) was calculated to be >2 MV/cm near breakdown, while the specific on resistance (R on,sp ) was measured to be 7.7 mΩ·cm 2 , corresponding to a power figure of merit of ~96 MW/cm 2 . Catastrophic breakdown is confirmed by optical microscope inspection. The turn on voltage (V on ) of the diode was measured to be around 1.12 V, the on-off ratio was calculated to be 9 × 10 9 at -2 and 2 V, and the ideality factor was extracted to be approximately 1.18. The band structure of the diode was analyzed, and C-V measurements were also performed to understand the trapping behavior at the Si/Ga 2 O 3 interface.

2 September 2024 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
HAHaris Naeem Abbasi
Haris Naeem Abbasi
SLSeunghyun Lee
Seunghyun Lee
HJHyemin Jung
Hyemin Jung
NGNathan Gajowski
Nathan Gajowski
YLYi Lu
Yi Lu
SKSanjay Krishna
Sanjay Krishna
The short-wave infrared (SWIR) wavelength, especially 1.55 μm, has attracted significant attention in various areas such as high-speed optical communication and LiDAR systems. Avalanche photodiodes (APDs) are a critical component as a receiver in these systems due to their internal gain, which enhances the system performance. Silicon-based APDs are promising since they are CMOS compatible, but they are limited in detecting 1.55 μm light detection. This study proposes a p-type Si on n-type GaAs0.51Sb0.49 (GaAsSb) lattice matched to InP substrates heterojunction formed using a grafting technique for future GaAsSb/Si APD technology. A p+Si nanomembrane is transferred onto the GaAsSb/AlInAs/InP substrate, with an ultrathin ALD-Al2O3 oxide at the interface, which behaves as both double-side passivation and quantum tunneling layers. The devices exhibit excellent surface morphology and interface quality, confirmed by atomic force microscope and transmission electron microscope. Also, the current–voltage (I–V) of the p+Si/n−GaAsSb heterojunction shows the rectifying characteristics with an ideality factor of 1.8. The I–V tests across multiple devices confirm high consistency and yield. Furthermore, the x-ray photoelectron spectroscopy measurement reveals that GaAsSb and Si are found to have type-II band alignment with a conduction band offset of 50 meV, which is favorable for the high-bandwidth APD application. The demonstration of the GaAsSb/Si heterojunction highlights the potential to advance current SWIR PD technologies.

24 June 2024 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
JGJiarui Gong
Jiarui Gong
DKDonghyeok Kim
Donghyeok Kim
HJHokyung Jang
Hokyung Jang
FAFikadu Alema
Fikadu Alema
QWQingxiao Wang
Qingxiao Wang
ZMZhenqiang Ma
Zhenqiang Ma
Beta-phase gallium oxide (β-Ga2O3) has exceptional electronic properties with vast potential in power and radio frequency electronics. Despite the excellent demonstrations of high-performance unipolar devices, the lack of effective p-type dopants in β-Ga2O3 has hindered the further development of Ga2O3-based bipolar devices. In this work, we applied the semiconductor grafting approach and fabricated monocrystalline Si/β-Ga2O3p–n heterojunctions, of which the characteristics were systematically studied. The heterojunctions demonstrated a diode rectification over 1.3 × 107 at ±2 V with a diode ideality factor of 1.13. Furthermore, capacitance–voltage (C–V) measurement showed frequency dispersion-free characteristics from 10 to 900 kHz. The interface defect density (Dit) was calculated as 1–3 × 1012/cm2 eV. Scanning transmission electron microscopy (STEM) and x-ray photoelectron spectroscopy (XPS) revealed that an ultrathin oxygen-rich layer existed on the Ga2O3 surface and later formed an ultrathin interfacial layer after bonding with Si. It is speculated that the excessive oxygen at the Ga2O3 surface enhanced the passivation of the Si dangling bonds and thus reduced Dit. This work improved our understanding of interface properties of the semiconductor grafting approach, providing useful guidance on the future development of Si/Ga2O3 heterojunction devices.