Laouamer Mosbah

Dr. Laouamer Mosbah

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2018
Verified
Conference Paper
Closed access
Laouamer MosbahLaouamer Mosbah
Laouamer Mosbah
AKAbdellah Kouzou
Abdellah Kouzou
RMRIDHA DJAMEL MOHAMMEDI
RIDHA DJAMEL MOHAMMEDI
ATAbdelhalim TLEMCANI
Abdelhalim TLEMCANI
The Phasor Measurement Unit is a contemporary measuring device installed in power system Used for control and monitoring. PMU's are most exact and advance time synchronized technology which extends operation of measurements voltages in the buses and also current phase values which are installed to those buses where these PMU ' s are observed. In this study, The Sine Cosine Algorithm(SCA) is novel method to optimize the placement optimal of the PMU'sin power system visibility. The optimal PMU placement(OPP) problem is intended such that minimizing the number of PMUs placing in power grid. This new method of placement has been tested on 3 standards IEEE-9,14 and 30-Buses.

1 March 2018
Verified
Conference Paper
Closed access
Laouamer MosbahLaouamer Mosbah
Laouamer Mosbah
RMRIDHA DJAMEL MOHAMMEDI
RIDHA DJAMEL MOHAMMEDI
AKA. Kouzou
A. Kouzou
ATAbdelhalim TLEMCANI
Abdelhalim TLEMCANI
The Phasor Measurement Unit (PMU) is a contemporary metering device installed on system to enable the power system monitoring and control. PMUs are most accurate and advance time synchronized technology which provides measurements of voltages at the buses and also current phase values which are connected to those buses where these PMUs are located. In this paper, a Genetic Algorithm is presented to optimize placement of PMUs for power system observability. The optimal placement problem (OPP) is formulated such that minimizing the number of PMU installations. The placement algorithm has been tested on 3 standards IEEE-bus30, 57 and 118 buses. The simulation results show that the determined optimal PMU placements by the proposed method can guarantee good observability of the system states. As another test, for the observability whole system, the proposed methods applied to 114-bus Algerian network.

10 December 2025 in International Journal of Electrical and Electronics Research
Verified
Journal Article
Open access
PDF file
Laouamer MosbahLaouamer Mosbah
Laouamer Mosbah
MAMohammed Adaika
Mohammed Adaika
SRSouhaib REMHA
Souhaib REMHA
AMAbdelkader Mahmoudi
Abdelkader Mahmoudi
Hamza AdaikaHamza Adaika
Hamza Adaika
Photovoltaic (PV) systems are increasingly vital to global energy transitions but remain vulnerable to surface anomalies such as dust, snow, bird droppings, and physical or electrical damage—that significantly reduce power yield and long-term reliability. Manual inspection is inefficient for large-scale solar farms, motivating the development of intelligent and automated fault detection systems. This study introduces a reproducible comparative deep-learning framework that systematically benchmarks four convolutional neural network (CNN) architectures ResNet50, EfficientNetB0, MobileNetV3Small, and DenseNet121 under identical preprocessing, training, and validation settings. The framework integrates runtime efficiency analysis, five-fold cross-validation, and a real-time GUI-based deployment interface, bridging the gap between academic benchmarking and field-level implementation. A six-class labeled dataset of 1,574 RGB images was expanded through extensive data augmentation (rotation, flipping, brightness adjustment, and Gaussian noise perturbation) to simulate diverse real-world conditions. Among the four tested models, DenseNet121 achieved the highest macro-averaged F1-score (≈ 0.96), followed by ResNet50 (0.93), EfficientNetB0 (0.92), and MobileNetV3Small (0.92), highlighting clear accuracy–efficiency trade-offs across architectures. The novelty of this work lies in its multi-model benchmarking design and transparent methodology, providing a standardized and reproducible reference for future PV image-based diagnostics. Practically, integrating the models into a real-time graphical user interface (GUI) demonstrates their feasibility for UAV-based or on-site PV inspection. From an operational and economic perspective, this approach supports cost-effective, scalable, and non-invasive monitoring solutions tailored for modern large-scale solar farms.

17 March 2026 in Diagnostyka
Verified
Journal Article
Open access
PDF file
SRSouhaib REMHA
Souhaib REMHA
Laouamer MosbahLaouamer Mosbah
Laouamer Mosbah
AMAbdelkader Mahmoudi
Abdelkader Mahmoudi
MAMohammed Adaika
Mohammed Adaika
YSYoucef Soufi
Youcef Soufi
In the last decades, the on-line detection of incipient short-circuit faults for electrical machines has been a major challenge, particularly in closed-loop conditions. It is found in the literature that the 2nd harmonics in both dq-axis currents were used for fault detection, and the main...

26 September 2025 in International Journal of Computational and Experimental Science and Engineering
Verified
Journal Article
Open access
PDF file
MAMohammed Aroudj
Mohammed Aroudj
YMYousra Megdoud
Yousra Megdoud
Laouamer MosbahLaouamer Mosbah
Laouamer Mosbah
RMRedha Meneceur
Redha Meneceur
MKMohammed Khadem
Mohammed Khadem
YBYamina Benkrima
Yamina Benkrima
This study presents first-principles calculations performed within the framework of density functional theory (DFT) using the full-potential linearized augmented plane wave (FP-LAPW) method as implemented in WIEN2k. Exchange–correlation interactions are described through the Wu–Cohen generalized gradient approximation (WC-GGA), while the modified Becke–Johnson (mBJ) potential is applied to improve the accuracy of the electronic band gap. The analysis initially focuses on the structural and electronic properties of PbS and PbSe in their NaCl-type phase. The results confirm that both compounds exhibit a direct band gap located at the L point. The investigation then extends to the ternary PbSe₁₋ₓSₓ alloys, where the influence of composition on lattice parameters and bulk modulus is systematically examined. The findings reveal clear deviations from Vegard’s law, interpreted within the theoretical framework proposed by Zunger and co-workers. Furthermore, the dependence of the band gap on alloy composition is analyzed under different pressure conditions. In addition to electronic properties, the optical response is also explored, including the dielectric function, refractive index, absorption coefficient, and reflectivity, highlighting the potential of these materials for optoelectronic and photovoltaic applications.

8 December 2025 in East European Journal of Physics
Verified
Journal Article
Open access
AKAbdelghani Koubil
Abdelghani Koubil
MKMohamed Khettal
Mohamed Khettal
YMYousra Megdoud
Yousra Megdoud
Laouamer MosbahLaouamer Mosbah
Laouamer Mosbah
BYBenkrima Yamina
Benkrima Yamina
RMRedha Meneceur
Redha Meneceur
In this paper, we present a detailed theoretical exploration of the ternary chalcopyrite semiconductors AgGaTe₂ and AgInTe₂ using first-principles calculations grounded in Density Functional Theory (DFT). The simulations are carried out within the Full-Potential Linearized Augmented Plane Wave (FPLAPW) formalism as implemented in the WIEN2k computational package. Structural properties are optimized using the WC-GGA exchange–correlation functional, whereas the electronic and optical responses are refined through the modified Becke–Johnson (mBJ) potential, known for its improved bandgap estimation accuracy. The study involves a thorough evaluation of the electronic band structures and various optical parameters, including the complex dielectric function, absorption coefficient, refractive index, energy-loss function, and reflectivity. The findings reveal that both materials possess direct bandgaps that lie within the optimal range for solar cell absorption. Additionally, these compounds show strong light absorption in the visible and near-infrared regions, high refractive indices, and marked interband transitions. Such features highlight their suitability for photovoltaic technologies, especially in thin-film configurations where enhanced light capture and carrier generation are critical. Moreover, the observed optical and electronic properties also suggest possible utilization in infrared detection and nonlinear optoelectronic systems. Overall, the results contribute valuable theoretical insight into the optoelectronic characteristics of silver-based telluride chalcopyrites, reinforcing their potential as environmentally friendly and efficient materials for future solar energy solutions.