This work presents the use of electrical discharge machining (EDM) technology for manufacturing of three different types of axial microgrooves in heat pipes. This specific process, called wire electrical discharge machining (or wire-EDM), allows the fabrication of microgrooves on the inner wall of a heat pipe with accuracy. Different from other capillary structures, such as composite wick and screen mesh, the material is removed from the pipe’s container in order to conceive the capillary structure, which contributes with the mass reduction of the passive two-phase heat transfer device. The heat pipes were manufactured from a straight copper pipe with the external diameter of 9.45 mm, the inner diameter of 6.20 mm and a total length of 200 mm. Three types of axial microgrooves were manufactured for constant width (35 μm) and varying the depth (from 30 up to 48 μm) and thickness (from 35 up to 70 μm). The number of microgrooves was also varied from 21 up to 32 microgrooves. Water was used as the working fluid and the loading filling ratio was 60% of the evaporator volume. The condenser was cooled by air forced convection, the adiabatic section was insulated and the evaporator was heated by an electrical resistor and it was insulated from the environment with aeronautic thermal insulation. The thermal performance of the heat pipes are analyzed based on experimental results, so the heat pipes were tested at the horizontal and different inclinations under different low heat loads (from 5 up to 50 W or a heat flux from 0.21 up to 2.10 W/cm2). The experimental results showed that the axial microgrooves manufactured by the wire-EDM process worked satisfactorily in all analyzed cases and microgrooves of Type #1 showed a better thermal performance when compared with the others.
The heat pipe and thermosyphon are passive heat transfer devices with phase change, which can be applied for thermal management of thermoelectric cooling, such as the TEC hot side. The heat pipes basically consist of a metal tube sealed with capillary structure internally that is embedded with a working fluid. This capillary structure can be made of screen meshes, grooves, or sintered media. The thermosyphon is a heat pipe assisted by gravity, because it has no capillary structure. Then, in this chapter, manufacturing of low cost and easy-to-manufacture heat pipes and thermosyphon is described in detail, and an experimental evaluation of their thermal performance is accomplished. The considered devices were a rod, a thermosyphon, a mesh heat pipe, a grooved heat pipe, and a sintered heat pipe. According to the behavior of the global thermal resistance and the effective thermal conductivity, the passive devices operated satisfactorily with the exception of the rod and the thermosyphon in the horizontal position. The heat pipes were the best among the tested devices and the best position was vertical.