The triggering mechanism and movement evolution of loess-red clay landslides, which occurred frequently along the contact between the loess and red clay on the Loess Plateau, are closely related to the mechanical properties of the contact surface. This work presents an experimental investigation on loess, clay and loess-red clay interlaminar (LRCI) samples obtained from a typical loess-red clay landslide in northern part of Shaanxi province of China, using a series of ring shear tests, microscopic observation and scanning electron microscopy tests, in an attempt to explore the mechanical behavior of loess, clay and LRCI samples with variation in moisture content, normal stress and shear rate. The results revealed that for all specimens, both the peak shear strength $$\tau_{p}$$τp and the residual shear strength $$\tau_{r}$$τr decreased with increasing moisture content, among which, moisture content has the greatest influence on the $$\tau_{p}$$τp and $$\tau_{r}$$τr of red clay, followed by the LRCI specimen, and the loess specimen is least affected by moisture content. Meanwhile, exponential functions describing the correlations between shear strength and moisture content of LRCI, red clay and loess specimens were proposed. Furthermore, the macroscopic morphological characteristics and the microstructure of shear surface obtained from the LRCI specimens showed that a localized water accumulation was built up within the shear surface as the water content increases to some extent, and a high degree of liquefaction developed within shear surface when the moisture content reached to the saturate degree. The microstructural observation on LRCI specimen suggested that the shear surface became smoother and the larger percentage of small-sized pores was observed with moisture content. Accordingly, the built-up excess pore water pressure during shearing is difficult to be dissipated due to a close structure of small-sized pores. Due to the low permeability, high pore-water pressure built up within the shear zone and the increase in the fine particle content, the LRCI soils with a high saturation degree shows the potential for the localized liquefaction within shear zone, which further provides a scientific explanation for the triggering mechanism of loess-red clay landslides with high-speed and long- run out.

The structure, time-dependent mechanical deformation, and strength characteristics of loess, which is loose and porous with well-developed vertical joints, are greatly affected by the dry-wet cycles, which are attributed to periodic artificial irrigation, rainfall, and water evaporation. To better understand the creep characteristics of loess under the effect of dry-wet cycles, Q₂ loess samples obtained from the South Jingyang County, China, were subjected to different dry-wet cycles (0, 5, 10, 15, 20) and sheared in triaxial creep tests. The experimental results revealed that: firstly, the maximum value of the deviatoric stress corresponding to creep failure gradually decreases with an increase in the dry-wet cycles. Secondly, the long-term strength of the loess after dry-wet cycles were obtained through the Isochronous Curve Method. It is found that the long-term strength and the number of dry-wet cycles showed an exponential decreasing relationship. In addition, the creep damage mechanism of loess due to dry-wet cycles is proposed. This study may provide the basis for understanding the mechanical behavior of the loess under the effect of dry-wet cycles, as well as guidelines for the prevention and prediction of loess landslide stability.

Loess landslides are closely related to the variation in mechanical properties of soils due to the leaching of irrigation water in the irrigation area which causes the loss of soluble salt in the loess stratum. To investigate the effect of leaching on the mechanical characteristics of loess, ring shear tests were conducted on the slip zone soil samples obtained from a typical loess landslide under different soaking time and salt concentration. Furthermore, the microstructural observations were made on shear planes by using SEM (scanning electron microscopy) tests. The experiment revealed that: firstly, the shear strength of loess decreases with the increase of soaking time before reaching the minimum value at the soaking time of 1 d, and then increases with the soaking time until reaching a relatively stable value. Secondly, the shear strength of loess has an increasing tendency with the salt concentration before reaching a maximum value at the salt concentration of 8%, and then shear strength decreases. In addition, a “stress-softening” was found for the loess samples with the soaking time of 1 d and salt concentration of 8%. It is found that the total number of micropores and small-pores in loess samples decreases with increasing salt concentration up to 8%, but increases rapidly between salt contents of 8% and 20%. The SEM tests showed that the increase in salt concentration (0% to 8%) facilities the formation of small aggregates within loess soils, which in turn promotes the increasing of shear strength. However, further increase in salt concentration (8% to 20%) helps the development of relatively large aggregates in loess samples, resulting in the reduction in shear strength.