The starting point for the proper design of an efficient wireless sensor node (WSN) supply system that is based on the adoption of a resonant electromagnetic vibration energy harvester (REVEH) is represented by the choice of a REVEH with a proper resonance frequency. But further likewise important design guidelines need to be also taken into account especially if, as in the case of freight wagons applications, vibrations are nonsinusoidal and their characteristics change with time. In this paper, the guidelines leading to the development of a smart power electronics interface between the REVEH and the WSN are provided with reference to freight wagons applications. In particular, for the most widely used double stage ac/dc architecture for REVEH applications, such guidelines not only allow the choice of the proper dc/dc converter topology, but they also allow the development of a suitable maximum power point tracking control strategy that allows to avoid the waste of energy and the consequent necessity to oversize the REVEH.
9 March 2020 in IEEE Transactions on Circuits and Systems I: Regular Papers
An active electronic interface for maximizing the power extracted from a resonant piezoelectric vibration harvester by means of a multi-variable Maximum Power Point Tracking (MPPT) technique is presented. The input voltage of the electronic interface is dynamically adapted in order to ensure that the maximum power is extracted even if the vibration characteristics change with time. The digital control unit updates the amplitude, the phase and the frequency of such an input voltage without requiring the high-frequency sampling and elaboration of the harvester current or voltage. The unit exploits only the information on the vibration frequency kept from a small piezo accelerometer and a low-frequency sampling of the DC current. The implemented algorithm is as simple as the widespread Perturb & Observe algorithm, but it allows the extraction of significantly more power from the harvester. The power increase for a piezoelectric harvester with the proposed electronic interface is investigated both theoretically and experimentally. By using a commercially available piezoelectric harvester, the maximum power tracking performance of the proposed active interface is experimentally compared with that of a usual AC/DC converter with Perturb & Observe MPPT control.
A backpack energy harvester converts mechanical energy associated with the oscillation of the backpack during human walking, into electric energy. It can be a very promising solution for supplying portable devices, especially in outdoor activities, disaster relief, and military applications. In this article, a backpack energy harvesting system that is able to self-adapt its operating condition to maximize the extracted power while supplying a dc load is presented and studied, analytically and experimentally. It is based on a mechanical motion rectifier that converts the up-and-down oscillation of the backpack into a unidirectional rotation of a dc generator. The generator output voltage is regulated by a power electronic interface implementing a maximum power point tracking technique to maximize the extracted power. Experimental results confirm the tracking ability of the proposed system and show the advantages with respect to other wearable energy harvesting systems published in the literature.