The Bangladesh lowlands are traversed by the largest sediment flux on the planet. Detritus generated mostly in Himalayan highlands and conveyed through the Ganga–Brahmaputra rivers and Meghna estuary reaches the Bay of Bengal, where it forms a composite deltaic system. This study integrates the vast existing database on Ganga–Brahmaputra sediments of all grain sizes from clay to sand with new petrographic, mineralogical, and geochemical data on estuarine and shallow-marine sands. A large spectrum of compositional signatures was used to: (i) assess the relative supply of the Ganga and Brahmaputra rivers to estuarine and shelfal sediments; (ii) define the compositional variability of estuarine sediments and the impact exerted by hydraulic sorting and climate-related chemical weathering on provenance signals; (iii) define the compositional variability of shelf sediments and the potential hydrodynamic segregation of fast-settling heavy minerals in coastal environments and of slow-settling platy micas on low-energy outer-shelf floors; (iv) consider the potential additional mud supply from the western subaerial part of the delta formerly built by the Ganga River; and (v) draw a preliminary mineralogical comparison between fluvio-deltaic sediments and turbidites of the Bengal–Nicobar deep-sea fan, thus tracing sediment dispersal across the huge sedimentary system extending from Tibet to the equatorial Indian Ocean. All investigated mineralogical and geochemical parameters, as well as Sr and Nd isotope ratios and clay–mineral assemblages, showed a clear prevalence in sediment supply from the Brahmaputra (60–70%) over the Ganga (30–40%). Heavy-mineral suites and Sr and Nd isotope fingerprints of Bengal shelf sediments are nearly identical to those of the Brahmaputra River and Meghna estuary, also because the Brahmaputra carries almost twice as many Ca-plagioclase grains and heavy minerals including epidote than the Ganga, and these minerals control the large majority of the Sr and Nd budgets. The experience gained in modern settings can be directly extrapolated only to the recent past, because sediments older than the late Pleistocene and buried more than a few hundred meters begin to lose less durable ferromagnesian minerals by selective chemical dissolution, which makes quantitative estimates progressively less robust in more deeply buried older strata.

Based on the concept that sedimentary processes average large areas of exposed crust, sediment data have been widely used to estimate the average Pb isotopic composition of the upper continental crust. However, the possible effects of mineral sorting processes on sediment Pb isotopes have never been fully investigated. Here, we report Pb isotopic compositions of Himalayan river sediments as well as those of several grain‐size fractions and mineral separates. We demonstrate that Pb isotopes of both bed loads and suspended loads are biased toward more radiogenic values than their source rocks due to a “heavy mineral effect” caused by mineral sorting during fluvial transport on continents. The sparse zircons, monazites and allanites present in all samples (<1 wt%), including suspended loads, generate a Pb isotopic variability as large as that observed in the Earth's mantle. After correction of this effect, we propose an average value for the composition of the upper Himalayan crust together with a new Pb isotopic value for the Earth's upper continental crust. We conclude that mineralogical effects must be evaluated carefully before using Pb isotopes of sediments as provenance and anthropogenic tracers.

High-resolution petrographic and heavy-mineral analyses of Bengal Fan turbidites from six cores drilled during IODP Expeditions 353 and 354 elucidate factors controlling their intersample compositional variability as a key to understanding sedimentary processes and erosional evolution of the Himalayan belt since the Miocene. Bengal Fan turbidites are feldspatho-quartzose to litho-feldspatho-quartzose with plagioclase > K-feldspar; slow-settling micas increase in abundance in very fine sand and coarse silt. The feldspar/quartz ratio and higher-rank metamorphic rock fragments notably increase from uppermost Miocene to Pleistocene deposits, which is ascribed to the onset of rapid exhumation of the Eastern Himalayan syntaxis since ∼ 5 Ma. The same trends are documented in Nicobar Fan turbidites, confirming that they belong to the same sedimentary system. Both Bengal and Nicobar fans record a pulse in mass accumulation rate at Tortonian times, when supply of sedimentary and very-low-grade metasedimentary detritus reflected accelerated exhumation of the Lesser Himalaya. In contrast to foreland-basin sediments, where ferromagnesian minerals have been completely dissolved in strata as young as Pliocene–Pleistocene, in both Bengal–Nicobar and Indus fans amphibole invariably represents about half of the moderately rich to rich transparent-heavy-mineral suite, demonstrating that amphibolite-facies Greater Himalaya metamorphic rocks were widely exposed in the Himalayan range well before the late Miocene and possibly since the late Oligocene, as indicated by a few sillimanite and kyanite grains in Bengal Fan sediments as old as 23 Ma and 28 Ma, respectively. Diagenetic dissolution strongly affected olivine and pyroxene in strata older than the middle and early Pleistocene, respectively, whereas amphibole decreases markedly through progressively older Miocene strata. Ferromagnesian minerals and sillimanite are almost completely dissolved in lower Miocene strata, where durable zircon, tourmaline, rutile, and apatite make up half of the strongly depleted heavy-mineral assemblage. Quaternary turbidites from the six studied cores have virtually the same compositional signatures, testifying to efficient homogenization by turbidite transport and reworking across the fan. Turbidites in western cores closer to peninsular India (U1444A and U1454B) are not different from those in eastern cores, indicating very minor supply from the subcontinent. Forward-mixing calculations based on integrated petrographic and heavy-mineral data indicate that sand supply from the Brahmaputra River to Quaternary turbidites was four times larger than supply from the Ganga River, indicating up to six times higher sediment yields and erosion rates in the Brahmaputra than in the Ganga catchment, largely reflecting superfast erosion of the Eastern Himalayan syntaxis.

Interpretation of the origin of Oligocene Flysch exposed in the Andaman–Nicobar Islands has been the subject of debate. Previous work on the provenance of the Andaman Flysch based on samples from South Andaman has indicated major contributions from Myanmar affected by the India–Asia collision, mixed with subordinate detritus from the nascent Himalayas. This study examines the provenance of a larger suite of samples that extend to North and Middle Andaman islands as well as Great Nicobar Island. Rather monotonous petrographic and heavy-mineral assemblages testify to strong diagenetic imprint, leading to a poorly constrained identification of the sediment source. U–Pb zircon ages provide more robust and diagnostic provenance discrimination between the Myanmar Arc and the growing Himalayan range. Combining petrographic and mineralogical data with detrital zircon U–Pb analyses, we find that most of the Andaman Flysch is dominated by a strong continental-crust signal with only a minor contribution from arc material. Statistical analyses of the data show that most of the samples have a provenance similar to Palaeogene Bengal Fan sediments, although the type section on South Andaman has a closer affinity to the provenance of the modern Irrawaddy.Supplementary material:Sample location (Table A1), the complete petrographic (Table A2), heavy mineral (Table A3) and U–Pb zircon-age datasets (Table A4) are all available athttps://doi.org/10.6084/m9.figshare.c.3634328.v1

Epidote group minerals are one of the three most abundant kinds of heavy minerals in orogenic sediments, the other two being amphibole and garnet. They resist diagenesis better than amphibole and resist weathering in soils better than garnet. Their chemical composition and optical properties vary markedly and systematically with temperature and pressure conditions during growth. Useful information on the metamorphic grade of source rocks can thus be obtained by provenance analysis. In this study, we combine optical, SEM–EDS, and Raman analyses of nine standard crystals of epidote group minerals collected from different rock units exposed in the European Alps and Apennines and develop a Raman library for efficient discrimination of epidote, clinozoisite, zoisite, and allanite by establishing clear user-oriented relationships among optical properties, chemical composition, and Raman fingerprint. This new library allows us to distinguish and reliably determine, directly from their Raman spectrum, the chemical compositions of epidote group minerals during routine heavy mineral analyses of sand/sandstone and silt/siltstone samples down to the size of a few microns. The validity of the approach is illustrated by its application to 41 Bengal Fan turbidites collected from five cores during IODP Expedition 354 and ranging in grain size from medium sand to fine silt.