Despite the fact that aerated stirred tank reactors are widely used in industry and often studied, their design and scale‐up still remains challenging. Especially the specific power input is a crucial and geometry‐dependent scale‐up parameter, usually calculated with the dimensionless power number Po. Within the scope of this study, the power number is measured for different stirrer types and configurations in a laboratory and an industrial‐scale aerated stirred tank reactor. Good agreements to literature are found for the unaerated case for the two‐stage stirrer configurations at different stirrer spacing for both scales. By literature only the aerated case in the laboratory scale can be predicted. Scale‐up of an aerated industrial‐scale reactor is challenging because of a specific influence of the aeration. In case of a three‐stage Rushton configuration, an asymmetrical distribution of the stirrers should be preferred to ensure a high power number as well as good power performance under aerated conditions.

For the purpose of the intensification of an industrial-scale gas-liquid process, the implementation in an alternative reactor concept is investigated at Hamburg University of Technology (TUHH) in cooperation with Ehrfeld Mikrotechnik GmbH. Existing process operation data from a bubble column hint at a mass transfer limitation of the gas-liquid reaction. In the project, a jet loop reactor (JLR) is chosen to increase the specific interfacial area between gas and liquid, and thus increase mass transfer, while keeping the reactor system mechanically simple and low-maintenance. For the investigation, a laboratory scale reactor has been designed on the basis of an existing industrial scale process and scaled according to a pilot scale reactor available at TUHH. For scaling, geometric similarity is desired, while specific energy dissipation rate and volumetric gas input are kept constant for the chosen scale-up strategy. Between the two different scales, the reactors are successfully characterised in a water-air system with regards to the important mass transfer, among other parameters. A pressure- and chemical-resistant twin of the laboratory-scale reactor is provided to the project partner for trials under real process conditions with the original material system. The presented work shows that the JLR concept can be transferred sufficiently well between different scales when suitable parameters are chosen, and offers a wide operating window. The investigations aim to provide a basis for a future scale-up of the chemical process in the JLR system to the industrial scale.

The reliable transfer of bioprocesses from single-use bioreactors (SUBs) of different scales to conventional stainless steel stirred-tank bioreactors is of steadily growing interest. In this publication, a scale-up study for SUBs with volumes of 200 L and 2000 L and the transfer to an industrial-scale conventional stainless steel stirred-tank bioreactor with a volume of 15,000 L is presented. The scale-up and transfer are based on a comparison of mixing times and the modeling of volumetric mass transfer coefficients k_La, measured in all three reactors in aqueous PBS/Kolliphor solution. The mass transfer coefficients are compared with the widely used correlation of van’t Riet at constant stirrer tip speeds. It can be shown that a van’t Riet correlation enables a robust and reliable prediction of mass transfer coefficients on each scale for a wide range of stirrer tip speeds and aeration rates. The process transfer from single-use bioreactors to conventional stainless steel stirred-tank bioreactors is proven to be uncritical concerning mass transfer performance. This provides higher flexibility with respect to bioreactor equipment considered for specific processes.