High-precision GNSS (global navigation satellite e system) measurements can be used for remote sensing and nowadays play a significant role in atmospheric sounding (station data, radio occultation observations) and sea surface altimetry based on reflectometry. A limiting factor of high-precision reflectometry is the loss of coherent phase information due to sea-state-induced surface roughness. This work studies airborne reflectometry observations recorded over coastal waters to examine the sea-state influence on Doppler distribution and the coherent residual phase retrieval. From coherent observations, the possibility of zenith total delay inversion is also investigated, considering the hydrostatic mapping factor from the Vienna mapping function and an exponential vertical decay factor depending on height receiver changes. The experiment consists of multiple flights performed along the coast between the cities of Calais and Boulogne-sur-Mer, France, in July 2019. Reflected signals acquired in a right-handed circular polarization are processed through a model-aided software receiver and passed through a retracking module to obtain the Doppler and phase-corrected signal. Results from grazing angle observations (elevation < 15°) show a high sensitivity of Doppler spread with respect to sea state with correlations of 0.75 and 0.88 with significant wave height and wind speed, respectively. An empirical Doppler spread threshold of 0.5 Hz is established for coherent reflections supported by the residual phase observations obtained. Phase coherence occurs in 15% of the observations; however, the estimated zenith total delay for the best event corresponds to 2.44 m, which differs from the typical zenith total delay (2.3 m) of 5%.
Coherent observations in GNSS reflectometry are prominent in regions with smooth reflecting surfaces and at grazing elevation angles. However, within these lower elevation ranges, GNSS signals traverse a more extensive atmospheric path, and increased ionospheric effects (e.g., delay biases) are expected. These biases can be mitigated by employing dual-frequency receivers or models tailored for single-frequency receivers. In preparation for the single-frequency GNSS-R ESA “PRETTY” mission, this study aims to characterize ionospheric effects under variable parameter conditions: elevation angles in the grazing range (5° to 30°), latitude-dependent regions (north, tropic, south) and diurnal changes (day and nighttime). The investigation employs simulations using orbit data from Spire Global Inc.’s Lemur-2 CubeSat constellation at the solar minimum (F10.7 index at 75) on March, 2021. Changes towards higher solar activity are accounted for with an additional scenario (F10.7 index at 180) on March, 2023. The electron density associated with each reflection event is determined using the Neustrelitz Electron Density Model (NEDM2020) and the NeQuick 2 model. The results from periods of low solar activity reveal fluctuations of up to approximately 300 TECUs in slant total electron content, 19 m in relative ionospheric delay for the GPS L1 frequency, 2 Hz in Doppler shifts, and variations in the peak electron density height ranging from 215 to 330 km. Sea surface height uncertainty associated with ionospheric model-based corrections in group delay altimetric inversion can reach a standard deviation at the meter level.
Sea level rise and sea state variability due to climate change and global warming are major research topics in the scientific community. Wind speed (WS) and significant wave height (SWH) are usable parameters to monitor the sea state threats and the impact of the ocean weather conditions in coastal areas. GNSS reflectometry (GNSS-R) has shown considerable promise as a remote sensing technique for ocean parameters estimation. Multiple studies have been successfully conducted in the recent two decades by using GNSS-R ground-based, airborne and spaceborne data to retrieve geophysical properties of the sea surface.The focus of this study is to investigate the Doppler shift of the reflected signal as observable to estimate the Doppler spread (DS) and determine its correlation with sea state changes, making use of GNSS-R airborne data in coastal areas. An additional aim is to study the possibility of using the Doppler spread as a metric for coherent GNSS reflectometry for applications such as precise altimetry and precise total electron content (TEC) estimates. An experiment was conducted from the 12th to the 19th of July 2019 along Opal Coast, between the cities of Calais and Boulogne-sur-Mer, France. The experiment consisted of multiple flights at an altitude of ~780m (a.m.s.l). The direct and reflected signals were received by dual-polarized (Right-Handed and Left-Handed Circular Polarizations) antenna mounted on a gyrocopter.A software receiver is used to process the direct and reflected signals from the right-hand channel. The resulting in-phase (I) and quadrature (Q) components (at 50 Hz rate) of the reflected signals are analyzed in the spectral domain every ten seconds to obtain the relative Doppler shift and power estimates. The coherence is established by analyzing the phase observations obtained from I and Q. The sensitivity of the reflected signal estimates and the sea state is determined by the correlation between the Doppler Spread with wind speed and significant wave height. The latter two were obtained from the atmospheric, land and oceanic climate model, ERA5, provided by the European Centre for Medium-Range Weather Forecasts (ECMWF).Initial results have shown promising performance at a calm sea (WS: 2.9 m/s and SWH: 0.26 m) and grazing angles. Satellites with low elevations (E < 10°) present a Doppler Spread of 0.3 Hz and its Pearson correlations with respect to WS and SHW are 0.89 and 0.75, respectively. The performance is relatively poor for high elevation events (E > 30°). The DS increases up to 2.1 Hz and the correlation decrease to 0.55 and 0.42 respectively. Coherence conditions are still under study; however, preliminary phase analysis reveals coherent observations at events with elevations below 15° and sea state with a significant wave height of 0.26 m.
Spaceborne GNSS reflectometry (GNSS-R) has emerged as a valuable technique for surface and atmospheric remote sensing, particularly under grazing-angle geometries where atmospheric effects are amplified. Single-frequency missions such as ESA passive REflecTomeTry and dosimetrY (PRETTY) rely on model-based corrections to account for ionospheric and tropospheric delays. In this study, we exploit PRETTY’s capabilities to perform observations down to 1 degree (at the specular point) to investigate ionospheric effects at very low angles. We analyze six GNSS-R events recorded over the North Polar region in July 2024, focusing on the estimation of the relative ionospheric delay using code delay observations. Comparisons with model-based ionospheric delays from NEDM2020, NeQuick, and IRI show close agreement, with NEDM2020 consistently exhibiting the lowest residual differences, ranging from 1.28 to 4.39 m across all events. This supports the ability of GNSS-R code delay observables to capture the first-order ionospheric delay with reasonable fidelity. Uncertainty analysis reveals that the observed delay fitting process dominates the overall error budget, with additional contributions from tropospheric correction and surface height uncertainty. Furthermore, inversion of the fitted delays using the Chapman layer model yields plausible F-layer parameters, with peak heights ranging from 307 to 367 km and a mean delay RMSE of approximately 1.2 m (~ 4 TECU). Comparisons with ionosonde and EISCAT measurements show differences within ± 15 km. These results demonstrate the potential of single-frequency GNSS-R missions for retrieving ionospheric structure, particularly in remote regions where conventional techniques are limited or unavailable.
The ionosphere is a layer of Earth's upper atmosphere that is ionized by solar radiation. It plays a crucial role in the propagation of Global Navigation Satellite System (GNSS) signals, as these signals pass through the ionosphere on their way from the GNSS satellite to the receiver. The irregularities in the ionospheric electron density may have a significant impact on the GNSS signals, causing delays and phase and amplitude scintillations.GNSS reflectometry (GNSS-R) is a promising technique for atmospheric sounding. Multiple studies have been successfully conducted in the recent decade by using GNSS-R ground-based, airborne and spaceborne data e.g., to estimate ionospheric disturbances from the reflected signals. However, further investigations are needed to precisely characterize ionospheric effects for GNSS-R altimetric applications.This study presents simulation results of ionospheric delay for reflection events in tropical regions. The first-order ionospheric effects are estimated along the ray paths by deriving the slant total electron content from the Neustrelitz Electron Density Model (NEDM). The geometry of the simulated events refers to reflectometry records of the SPIRE satellite constellation and the satellite navigation system GPS on 2021/03/01.Initial analysis has shown promising results. As solar activity increases (indicated by solar radio flux F10.7 index), an increase in the total ionospheric phase delay is evident. Between 0h and 8h local time, there is a delay of 2 to 10 meters. For the time interval from 8h to 16h, the delay is from 14 up to 22 meters, with the maximum at noon. In the sunset period from 16h to 24h, the ionospheric delay reduces from 9 to 3 meters, respectively. The height above the Earth’s surface at which the highest amount of electron content is found along the ray path is ~290 km. This altitude corresponds to the F-region which has the highest concentration of free electrons. The analyzed events correspond to elevation angles from 5 to 30 degrees. The highest ionospheric delay is found at elevation angles between 10 and 20 degrees also depending on the local time.