Martino Aldrigo

Dr. Martino Aldrigo

National Institute for Research and Development in Microtechnologies IMT-Bucharest
orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 September 2016 in Applied Physics Letters
Verified
Journal Article
Closed access
Mircea DragomanMircea Dragoman
Mircea Dragoman
Martino AldrigoMartino Aldrigo
Martino Aldrigo
In this paper, we propose a graphene rectenna that encompasses two distinct functions in a single device, namely, antenna and rectifier, which till now were two separate components. In this way, the rectenna realizes an efficient energy harvesting technique due to the absence of impedance mismatch between antenna and diode. In particular, we have obtained a maximum conversion efficiency of 58.43% at 897 GHz for the graphene rectenna on n-doped GaAs, which is a very good value, close to the performance of an RF harvesting system. A comparison with a classical metallic antenna with an HfO2-based metal-insulator-metal diode is also provided.

18 October 2020 in Nanomaterials
Verified
Journal Article
Open access
PDF file
Martino AldrigoMartino Aldrigo
Martino Aldrigo
Mircea DragomanMircea Dragoman
Mircea Dragoman
Sergiu IordanescuSergiu Iordanescu
Sergiu Iordanescu
Florin NastaseFlorin Nastase
Florin Nastase
SVSilviu Vulpe
Silviu Vulpe
In this paper, we present microwave filters that are based on 6-nm-thick ferroelectric thin films of hafnium oxide doped with zirconium (HfZrO), which are tunable continuously in targeted bands of interest within the frequency range 0.1–16 GHz, when the applied direct current (DC) voltage is swept between 0 V and 4 V. Here, we exploit the orthorhombic polar phase in HfO2 through a careful doping using zirconium in an Atomic Layer Deposition (ALD) process, in order to guarantee phase stabilization at room temperature. Polarization versus voltage characterization has been carried out, showing a remanent polarization (Pr) of ~0.8 μC/cm2 and the coercive voltage at ~2.6 V. The average roughness has been found to be 0.2 nm for HfZrO films with a thickness of 6 nm. The uniform topography, without holes, and the low surface roughness demonstrate that the composition and the structure of the film are relatively constant in volume. Three filter configurations (low-pass, high-pass, and band-pass) have been designed, modelled, fabricated, and fully characterized in microwaves, showing a frequency shift of the minimum of the reflection coefficient between 90 MHz and 4.4 GHz, with a minimum insertion loss of approximately 6.9 dB in high-pass configuration.

22 May 2018 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
Martino AldrigoMartino Aldrigo
Martino Aldrigo
Mircea DragomanMircea Dragoman
Mircea Dragoman
Mircea ModreanuMircea Modreanu
Mircea Modreanu
IPIan Povey
Ian Povey
Sergiu IordanescuSergiu Iordanescu
Sergiu Iordanescu
Diego MasottiDiego Masotti
Diego Masotti
In this paper, the first demonstration of a bow-tie antenna integrated with a metal-insulator-metal (MIM) diode for electromagnetic energy harvesting in the V-band (i.e., 40-75 GHz) is presented. We have designed, simulated, fabricated, and fully characterized a 60-GHz rectifying antenna (rectenna) based on a vertical Au-HfO₂-Pt MIM diode with reduced differential resistance. The dielectric used for the MIM structure is a 6-nm-thick amorphous HfO₂ grown by atomic layer deposition. For the fabricated MIM device, we report here a current density of 3 x 10⁴ A/cm² that exceeds the previous values presented in the literature. The vertical MIM-based rectenna is able to efficiently harvest up to 250 μV from an impinging modulated millimeter-wave signal with -20 dBm of available power, thus offering a voltage responsivity of over 5 V/W. The reported results indicate that the proposed approach is well suited for future low-power solutions much sought after for the energetically autonomous 5G terminal equipment.

13 February 2019 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
Muhammad YasirMuhammad Yasir
Muhammad Yasir
Martino AldrigoMartino Aldrigo
Martino Aldrigo
Mircea DragomanMircea Dragoman
Mircea Dragoman
ADAdrian Dinescu
Adrian Dinescu
Maurizio BozziMaurizio Bozzi
Maurizio Bozzi
DVD. Vasilache
D. Vasilache

24 March 2016 in Journal of Applied Physics
Verified
Journal Article
Closed access
Alina CismaruAlina Cismaru
Alina Cismaru
Martino AldrigoMartino Aldrigo
Martino Aldrigo
ARAntonio Radoi
Antonio Radoi
Mircea DragomanMircea Dragoman
Mircea Dragoman
In this paper, we present the experimental results obtained in the microwave frequency range using an electromagnetic band gap (EMBG) resonator covered with carbon nanotubes (CNTs) and dedicated to CH4 gas detection. The multi-walled CNTs layer is decorated with gold nanoislands (with sizes between 2 nm and 20 nm) and deposited over the EMBG resonator. The microwave measurements of the CNT-based EMBG resonator in air (no gas) and kept for 60 min inside the chamber filled with CH4 demonstrate a shift in the resonance frequency of about 139 MHz and a phase shift of about 9.63°. A very good sensitivity of about 4.58% was obtained from scattering parameters measurements. A new device for CH4 detection was then fabricated and tested.

1 February 2021 in Physica E: Low-dimensional Systems and Nanostructures
Verified
Journal Article
Closed access
MDMircea Dragoman
Mircea Dragoman
Martino AldrigoMartino Aldrigo
Martino Aldrigo
Daniela DragomanDaniela Dragoman
Daniela Dragoman
IPIan Povey
Ian Povey
Sergiu IordanescuSergiu Iordanescu
Sergiu Iordanescu
MMMircea Modreanu
Mircea Modreanu