Mercy Mbua

Ms. Mercy Mbua

Colorado State University, Fort Collins, Colorado, USA
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 November 2022 in Atmospheric Measurement Techniques
Verified
Journal Article
Open access
PDF file
SRStuart N. Riddick
Stuart N. Riddick
RARiley Ancona
Riley Ancona
MMMercy Mbua
Mercy Mbua
CBClay S. Bell
Clay S. Bell
ADAidan Duggan
Aidan Duggan
DZDaniel Zimmerle
Daniel Zimmerle
Recent interest in measuring methane (CH4) emissions from abandoned oil and gas infrastructure has resulted in several methods being continually used to quantify point source emissions less than 200 g CH4 h−1. The choice of measurement approach depends on how close observers can come to the source, the instruments available, and the meteorological/micrometeorological conditions. As such, static chambers, dynamic chambers, Bacharach Hi Flow Sampler (BHFS) measurements, Gaussian plume (GP) modeling, and backward Lagrangian stochastic (bLs) models have all been used, but there is no clear understanding of the accuracy or precision of each method. To address this, we copy the experimental design for each of the measurement methods to make single field measurements of a known source, to simulate single measurement field protocol, and then make repeat measurements to generate an understanding of the accuracy and precision of each method. Here, we present estimates for the average percentage difference between the measured emission and the known emission for three repeat measurements, Ar, for emissions of 40 to 200 g CH4 h−1. The static chamber data were not presented because of safety concerns during the experiments. Both the dynamic chamber (Ar = −10 %, −8 %, and −10 % at emission rates of 40, 100, and 200 g CH4 h−1, respectively) and BHFS (Ar = −18 %, −16 %, and −18 %) repeatedly underestimate the emissions, but the dynamic chamber had better accuracy. The standard deviation of emissions from these direct measurement methods remained relatively constant for emissions between 40 and 200 g CH4 h−1. For the far-field methods, the bLs method generally underestimated emissions (Ar = +6 %, −6 %, and −7 %) while the GP method significantly overestimated the emissions (Ar = +86 %, +57 %, and +29 %) despite using the same meteorological and concentration data as input. Variability in wind speed, wind direction, and atmospheric stability over the 20 min averaging period are likely to propagate through to large variability in the emission estimate, making these methods less precise than the direct measurement methods. To our knowledge, this is the first time that methods for measuring CH4 emissions from point sources between 40 and 200 g CH4 h−1 have been quantitatively assessed against a known reference source and against each other.

5 February 2024 in Atmosphere
Verified
Journal Article
Open access
PDF file
SRStuart N. Riddick
Stuart N. Riddick
MMMercy Mbua
Mercy Mbua
ASArthur Santos
Arthur Santos
WHWendy Hartzell
Wendy Hartzell
DZDaniel Zimmerle
Daniel Zimmerle
Methane is a greenhouse gas and identified as a key driver of near-term climate change. Bottom-up approaches estimate annual methane loss from US natural gas production and transport at 6 Tg, but recent studies suggest this may be an underestimate. To investigate this possibility, an equipment-based emissions inventory, using EPA emission factors, was developed to calculate methane emissions from oil and gas operations in the Delaware basin, USA. Emission factors and activity data were then updated using contemporary and region-specific measurement data. The original inventory estimated emissions at 315 Gg CH4 y−1 (gas production-normalized rate of 0.6% loss), while the updated inventory estimated emissions of 1500 Gg CH4 y−1 (2.8% loss). The largest changes resulted from large fugitive emissions from oil production (+430 Gg CH4 y−1), updating maintenance activity emissions (+214 Gg CH4 y−1), considering flaring inefficiency (+174 Gg CH4 y−1), and the inclusion of associated gas venting (+136 Gg CH4 y−1). This study suggests that a systematic underestimate probably exists in current bottom-up inventories and identifies sources currently missing or may be incorrect. We also strongly recommend that emission factors should be validated through direct comparison against measurement campaigns that include long-tail distributions typical of oil and gas activities.

29 September 2022 in Sensors
Verified
Journal Article
Open access
PDF file
SRStuart N. Riddick
Stuart N. Riddick
FCFancy Cheptonui
Fancy Cheptonui
KYKexin Yuan
Kexin Yuan
MMMercy Mbua
Mercy Mbua
RDRachel Day
Rachel Day
DZDaniel Zimmerle
Daniel Zimmerle
Methane (CH4), a powerful greenhouse gas (GHG), has been identified as a key target for emission reduction in the Paris agreement, but it is not currently clear where efforts should be focused to make the greatest impact. Currently, activity data and standard emission factors (EF) are used to generate GHG emission inventories. Many of the EFs are globally uniform and do not account for regional variability in industrial or agricultural practices and/or regulation. Regional EFs can be derived from top–down emissions measurements and used to make bespoke regional GHG emission inventories that account for geopolitical and social variability. However, most large-scale top–down approaches campaigns require significant investment. To address this, lower-cost driving surveys (DS) have been identified as a viable alternative to more established methods. DSs can take top–down measurements of many emission sources in a relatively short period of time, albeit with a higher uncertainty. To investigate the use of a portable measurement system, a 2260 km DS was conducted throughout the Denver–Julesburg Basin (DJB). The DJB covers an area of 8000 km2 north of Denver, CO and is densely populated with CH4 emission sources, including oil and gas (O and G) operations, agricultural operations (AGOs), lakes and reservoirs. During the DS, 157 individual CH4 emission sources were detected; 51%, 43% and 4% of sources were AGOs, O and G operations, and natural sources, respectively. Methane emissions from each source were quantified using downwind concentration and meteorological data and AGOs and O and G operations represented nearly all the CH4 emissions in the DJB, accounting for 54% and 37% of the total emission, respectively. Operations with similar emission sources were grouped together and average facility emission estimates were generated. For agricultural sources, emissions from feedlot cattle, dairy cows and sheep were estimated at 5, 31 and 1 g CH4 head−1 h−1, all of which agreed with published values taken from focused measurement campaigns. Similarly, for O and G average emissions for well pads, compressor stations and gas processing plants (0.5, 14 and 110 kg CH4 facility−1 h−1) were in reasonable agreement with emission estimates from intensive measurement campaigns. A comparison of our basin wide O and G emissions to measurements taken a decade ago show a decrease of a factor of three, which can feasibly be explained by changes to O and G regulation over the past 10 years, while emissions from AGOs have remained constant over the same time period. Our data suggest that DSs could be a low-cost alternative to traditional measurement campaigns and used to screen many emission sources within a region to derive representative regionally specific and time-sensitive EFs. The key benefit of the DS is that many regions can be screened and emission reduction targets identified where regional EFs are noticeably larger than the regional, national or global averages.

17 November 2023 in Sensors
Verified
Journal Article
Open access
PDF file
SRStuart N. Riddick
Stuart N. Riddick
MMMercy Mbua
Mercy Mbua
JRJohn C. Riddick
John C. Riddick
CHCade Houlihan
Cade Houlihan
AHAnna L. Hodshire
Anna L. Hodshire
DZDaniel Zimmerle
Daniel Zimmerle
The recent interest in measuring methane (CH4) emissions from abandoned oil and gas wells has resulted in five methods being typically used. In line with the US Federal Orphaned Wells Program’s (FOWP) guidelines and the American Carbon Registry’s (ACR) protocols, quantification methods must be able to measure minimum emissions of 1 g of CH4 h−1 to within ±20%. To investigate if the methods meet the required standard, dynamic chambers, a Hi-Flow (HF) sampler, and a Gaussian plume (GP)-based approach were all used to quantify a controlled emission (Qav; g h−1) of 1 g of CH4 h−1. After triplicate experiments, the average accuracy (Ar; %) and the upper (Uu; %) and lower (Ul; %) uncertainty bounds of all methods were calculated. Two dynamic chambers were used, one following the ACR guidelines, and a second “mobile” chamber made from lightweight materials that could be constructed around a source of emission on a well head. The average emission calculated from the measurements made using the dynamic chamber (Qav = 1.01 g CH4 h−1, Ar = +0.9%), the mobile chamber (Qav = 0.99 g CH4 h−1, Ar = −1.4%), the GP approach (Qav = 0.97 g CH4 h−1, Ar = −2.6%), and the HF sampler (Qav = 1.02 g CH4 h−1, Ar = +2.2%) were all within ±3% of 1 g of CH4 h−1 and met the requirements of the FOWP and ACR protocols. The results also suggest that the individual measurements made using the dynamic chamber can quantify emissions of 1 g of CH4 h−1 to within ±6% irrespective of the design (material, number of parts, geometrical shape, and hose length), and changes to the construction or material specifications as defined via ACR make no discernible difference to the quantification uncertainty. Our tests show that a collapsible chamber can be easily constructed around the emission source on an abandoned well and be used to quantify emissions from abandoned wells in remote areas. To our knowledge, this is the first time that methods for measuring the CH4 emissions of 1 g of CH4 h−1 have been quantitively assessed against a known reference source and against each other.

5 August 2024 in Gases
Verified
Journal Article
Open access
PDF file
SRStuart N. Riddick
Stuart N. Riddick
MMMercy Mbua
Mercy Mbua
AAAbhinav Anand
Abhinav Anand
Elijah KiplimoElijah Kiplimo
Elijah Kiplimo
ASArthur Santos
Arthur Santos
DZDaniel Zimmerle
Daniel Zimmerle
Methane is a powerful greenhouse gas with a 25 times higher 100-year warming potential than carbon dioxide and is a target for mitigation to achieve climate goals. To control and curb methane emissions, estimates are required from the sources and sectors which are typically generated using bottom-up methods. However, recent studies have shown that national and international bottom-up approaches can significantly underestimate emissions. In this study, we present three bottom-up approaches used to estimate methane emissions from all emission sectors in the Denver-Julesburg basin, CO, USA. Our data show emissions generated from all three methods are lower than historic measurements. A Tier 1/2 approach using IPCC emission factors estimated 2022 methane emissions of 358 Gg (0.8% of produced methane lost by the energy sector), while a Tier 3 EPA-based approach estimated emissions of 269 Gg (0.2%). Using emission factors informed by contemporary and region-specific measurement studies, emissions of 212 Gg (0.2%) were calculated. The largest difference in emissions estimates were a result of using the Mechanistic Air Emissions Simulator (MAES) for the production and transport of oil and gas in the DJ basin. The MAES accounts for changes to regulatory practice in the DJ basin, which include comprehensive requirements for compressors, pneumatics, equipment leaks, and fugitive emissions, which were implemented to reduce emissions starting in 2014. The measurement revealed that normalized gas loss is predicted to have been reduced by a factor of 20 when compared to 10-year-old normalization loss measurements and a factor of 10 less than a nearby oil and production area (Delaware basin, TX); however, we suggest that more measurements should be made to ensure that the long-tail emission distribution has been captured by the modeling. This study suggests that regulations implemented by the Colorado Department of Public Health and Environment could have reduced emissions by a factor of 20, but contemporary regional measurements should be made to ensure these bottom-up calculations are realistic.

20 May 2025 in Atmosphere
Verified
Journal Article
Open access
PDF file
SRStuart N. Riddick
Stuart N. Riddick
MMMercy Mbua
Mercy Mbua
CLCatherine Laughery
Catherine Laughery
DZDaniel Zimmerle
Daniel Zimmerle
Since pre-industrial times, anthropogenic methane emissions have increased and are partly responsible for a changing global climate. Natural gas and oil extraction activities are one significant source of anthropogenic methane. While methods have been developed and refined to quantify onshore methane emissions, the ability of methods to directly quantify emissions from offshore production facilities remains largely unknown. Here, we review recent studies that have directly measured emissions from offshore production facilities and critically evaluate the suitability of these measurement strategies for emission quantification in a marine environment. The average methane emissions from production platforms measured using downwind dispersion methods were 32 kg h−1 from 188 platforms; 118 kg h−1 from 104 platforms using mass balance methods; 284 kg h−1 from 151 platforms using aircraft remote sensing; and 19,088 kg h−1 from 10 platforms using satellite remote sensing. Upon review of the methods, we suggest the unusually large emissions, or zero emissions observed could be caused by the effects of a decoupling of the marine boundary layer (MBL). Decoupling can happen when the MBL becomes too deep or when there is cloud cover and results in a stratified MBL with air layers of different depths moving at different speeds. Decoupling could cause: some aircraft remote sensing observations to be biased high (lower wind speed at the height of the plume); the mass balance measurements to be biased high (narrow plume being extrapolated too far vertically) or low (transects miss the plume); and the downwind dispersion measurements much lower than the other methods or zero (plume lofting in a decoupled section of the boundary layer). To date, there has been little research on the marine boundary layer, and guidance on when decoupling happens is not currently available. We suggest an offshore controlled release program could provide a better understanding of these results by explaining how and when stratification happens in the MBL and how this affects quantification methodologies.