Recently, new form factors, such as foldable, have increased demand for mobile products. Moreover, mobile phones should support the RF signal frequency up to the mm-wave frequency due to the expansion of 5G mobile products. Therefore, 5G foldable products require components that facilitate both mm-wave RF transmission and ultra-high flexibility for interconnecting through the hinge structure of foldable products. To improve flexibility, a flexible PCB must be thin with no ground vias in its bending section; in contrast, the low-loss flexible PCB for mm-wave transmission must be thick and have many ground vias, so there is a trade-off relationship between flexibility and RF characteristics. This paper proposes a new flexible PCB structure that does not experience problems regarding signal transmission to the mm-wave band, even when folded 200,000 times. To overcome the physical limits of the trade-off relationship, an interlayer air-gap was formed; a structure with a via-less and meander ground shape is proposed. The simulated loss of the proposed structure was 0.0254 dB/mm @ 10 GHz, and the isolation between signals ranged from 21.98 dB to 10 GHz. The simulated results of insertion loss and isolation were experimentally verified. The proposed structure is currently being applied to the RF flexible PCB that interconnects through the hinge of a foldable phone, and is currently being mass-produced.
25 November 2025 in IEEE Microwave and Wireless Technology Letters
This letter presents a compact and cost-effective microstrip low-pass filter (LPF) based on the incorporation of coupled lines with an MLCC-loaded microstrip stub (MLCC-CL) for practical mobile applications. The primary concept of MLCC-CL structure is to induce the separation of transmission zeros (TZs) and increase their number, thereby resulting in wideband rejection with a compact filter footprint. An analytical method is developed for efficiently and systematically designing the proposed MLCC-CL LPF. A test vehicle targeting 2.4-GHz wireless mobile services is fabricated using PCB manufacturing technology. The proposed LPF achieves a low insertion loss of 0.37 dB at 2.4 GHz, a 20-dB rejection bandwidth spanning from 4.68 to 10.80 GHz, and an extremely compact size of 2.74 mm${}^{\mathbf {2}}$ ($0.0014~\lambda _{\mathbf {g}}^{\mathbf {2}}$ ), providing suitability for practical applications.