Naseer Hamed Hamza

Dr. Naseer Hamed Hamza

Mechanical Engineering Department, University of Al-Qadisiyah, Ad Dīwānīyah, Al Qādisīyah, Iraq
orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 September 2023 in International Journal of Thermofluids
Verified
Journal Article
Open access
Naseer Hamed HamzaNaseer Hamed Hamza
Naseer Hamed Hamza
NANabeel M. Abdulrazzaq
Nabeel M. Abdulrazzaq
MTMaathe A. Theeb
Maathe A. Theeb
MSMikhail Sheremet
Mikhail Sheremet
AAAmmar Abdulkadhim
Ammar Abdulkadhim

17 November 2022 in Energies
Verified
Journal Article
Open access
PDF file
Sattar AlgayyimSattar Algayyim
Sattar Algayyim
Talal YusafTalal Yusaf
Talal Yusaf
Naseer Hamed HamzaNaseer Hamed Hamza
Naseer Hamed Hamza
AWAndrew P. Wandel
Andrew P. Wandel
I. M. R. FattahI. M. R. Fattah
I. M. R. Fattah
S M RahmanS M Rahman
S M Rahman
The objective of this review is to provide a deep overview of liquid biofuels produced from sugarcane bagasse and to address the economic challenges of an ethanol and acetone-butanol-ethanol blend in commercial processes. The chemistry of sugarcane bagasse is presented. Pretreatment technologies such as physical, chemical pretreatment, biological, and combination pretreatments used in the fermentation process are also provided and summarised. Different types of anaerobic bacteria Clostridia (yeast) are discussed to identify the ingredient best suited for sugarcane bagasse, which can assist the industry in commercializing ethanol and acetone-butanol-ethanol biofuel from biomass sugarcane. The use of an acetone-butanol-ethanol mixture and ethanol blend in internal combustion engines is also discussed. The literature then supports the proposal of the best operating conditions for fermentation to enhance ethanol and acetone-butanol-ethanol plant efficiency in the sugar waste industry and its application in internal combustion engines.

12 February 2023 in Experimental Heat Transfer
Verified
Journal Article
Closed access
HAHaneen M. Al-Ali
Haneen M. Al-Ali
Naseer Hamed HamzaNaseer Hamed Hamza
Naseer Hamed Hamza
The current paper reports the impact of variation of ribs’ pitch distance in the case of laminar flow and forced convection heat transfer upon flow characteristics in a rectangular channel experimentally and numerically. The thermal behavior of the ribbed channel with water as a working fluid was measured experimentally and compared to numerical simulations performed using Galerkin finite element method under the same operating and boundary conditions. Numerical analysis has been extended to investigate the entire ribbed channel with the presence of nano-particles in the base fluid to predict the performance of the heat transfer process with interaction with extended geometries. The analysis was done keeping heat flux constant at the bottom boundary condition. The impacts of the rib pitch-to-height ratio (p/e = 2.5, 3.125, 3.75, 4.375, and 5), nano-particle volume concentration (0% ≤ φ ≤ 4%), also Reynolds numbers (427.44 to 1282. 9), were all examined in the present study. The results show a good coincidence between the numerical and experimental study with a maximum deviation was nearly 3%. The main findings show that when the nano-fluid volume fraction increases from 0% to 4%, the average Nusselt number for all aspect ratios increases too. Meanwhile, the average skin friction decreases as the Reynolds number increase for different values of AR. Furthermore, the results revealed that the water – aluminum oxide nano-fluid with the concentration φ = 0.04 aid to improve the coefficient of heat transfer by 5% higher than the case of φ = 0.02, and up to 9.4% compared to pure water (φ = 0) due to an increase in viscosity. Finally, the current work shows that these extended surfaces with the use of nano-fluids can remarkably improve heat transfer properties with barely increased friction, making them suitable candidates for the development of efficient heat exchanger devices.

23 September 2024 in International Journal of Heat and Fluid Flow
Verified
Journal Article
Closed access
FAFatimah Q. Al-Daamee
Fatimah Q. Al-Daamee
Naseer Hamed HamzaNaseer Hamed Hamza
Naseer Hamed Hamza

20 May 2024 in International Journal of Thermofluids
Verified
Journal Article
Open access
FAFatimah Q. Al-Daamee
Fatimah Q. Al-Daamee
Naseer Hamed HamzaNaseer Hamed Hamza
Naseer Hamed Hamza

14 November 2023 in Heat Transfer
Verified
Journal Article
Closed access
Naseer Hamed HamzaNaseer Hamed Hamza
Naseer Hamed Hamza
AAAmmar Abdulkadhim
Ammar Abdulkadhim
AMAli M. Mohsen
Ali M. Mohsen
AAAzher M. Abed
Azher M. Abed