Boride layers are typically used to combat the wear and corrosion of metals. For this reason, to improve our knowledge of the boriding process, this research studied the effect of the size of the treated material on the kinetics of the growth of the boride layers obtained during a solid diffusion process. The purpose was to elucidate how the layers’ growth kinetics could be affected by the size of the samples since, as the amount of matter increases, the amount of energy necessary to make the process occur also increases. Furthermore, the level of activation energy seems to change as a function of the sample size, although it is considered an intrinsic parameter of each material. Six cylindrical samples with different diameters were exposed to the boriding process for three different exposure times (1.5, 3, and 5 h). The treatment temperatures used were 900, 950, and 1000 °C for each size and duration of treatment. The results show that the layer thickness increased not only as a function of the treatment conditions but also as a function of the sample diameter. The influence of the sample size on the growth kinetics of the boride layers is clear, because the growth rate increased even though the treatment conditions (time and temperature) remained constant.
2 April 2023 in Arabian Journal for Science and Engineering
It is well known that the mechanical properties of a steel plate depend on the anisotropy of the material and the rolling directions. This paper presents the results of the Charpy V-Notch (CVN) impact test for the ST, TL, TS, LS, LT, 45°, and SL directions in API 5L X52 pipelines with electric-resistance-welded (ERW) and seamless (SMLS) pipes. Charpy specimens were manufactured and tested according to the ASTM E23 standard in laboratory conditions. All possible directions in the pipe were tested. Three Charpy specimens were tested for each direction, for a total of 21 Charpy tests. Moreover, the microstructures, hardness, ductile and brittle areas, and fracture surfaces of the Charpy specimens are presented in this research. The results show that the Charpy energy values, hardness, and microstructures depend on the direction of the specimens. The Charpy values of the SMLS pipe are higher than those of the ERW pipe because of several metallurgical factors, such as grain size, non-metallic inclusions, delaminations, and microstructures.
This work shows the effect of artificial aging on the mechanical properties of an API 5L Gr. B steel that undergoes different artificial aging times (0, 500, 1250, and 1500 h). Among the mechanical properties studied are the stress–strain curve, yield stress, and ultimate tensile stress. In addition, the parameters from the Ludwik–Hollomon equation, which are the parameter (K) and the work-hardening coefficient (n), are obtained for the true stress–strain curve. Once the true stress–strain curve is plotted, a 3D model of a transverse crack in a pipeline is proposed. The crack defects are straight, and the finite element method (FEM) is used to determine its behavior at different sizes in order to estimate the failure pressure. It can be said that the mechanical properties (stress–strain curve) increase for an aging time of 500 h compared to the air condition because of the over-aging process, something that is well recognized in the literature. In general, past the over-aging condition, with an increase in the aging time, the mechanical properties tend to decrease. This behavior is similar for the failure pressure. The FEM is sensitive to the decrease in mechanical properties along with the true stress–strain curve.