Neither pristine phase change materials (PCMs) nor metal‐organic frameworks (MOFs) can be driven by optical/electrical/magnetic triggers for multiple energy conversion and thermal storage, which cannot satisfy the requirements of multi‐scenario applications. Herein, a three‐dimensional interconnected forest‐type array carbon network anchored by Co nanoparticles serving as optical/electrical/magnetic multimode triggers was developed through in situ growth of two‐dimensional MOF nanosheet arrays on pre‐carbonized melamine foam and subsequent high‐temperature carbonization. After the encapsulation of polyethylene glycol, the resulting composite PCMs simultaneously integrate fascinating photothermal, electrothermal, magnetothermal conversion and storage for personal thermotherapy. Benefiting from the synergistic enhancement of forest‐type array carbon heterostructure and Co nanoparticles, composite PCMs exhibit high thermal/electrical conduction and strong full‐spectrum absorption capacities. Resultantly, low‐energy photoelectric triggers are sufficient to drive high‐efficiency photothermal/electrothermal conversion and storage of composite PCMs (93.1%, 100 mW/cm2; 92.9%, 2.5 V). Additionally, composite PCMs also exhibit excellent encapsulation stability without liquid phase leakage, long‐term thermal reliability and multiple energy conversion and storage stability after multiple cycles. The proposed photoelectromagnetic multimode triggers are aimed to inspire innovation and accelerate major breakthroughs in advanced responsive composite PCMs toward multiple energy utilization and personal thermotherapy.
Reinforced concrete (RC) beams strengthened with carbon-fabric-reinforced cementitious matrix (CFRCM) systems have shown potential for restoring flexural performance, yet their effectiveness under different corrosion levels remains insufficiently understood. This study presents a numerical investigation of the flexural behaviour of simply supported RC beams externally strengthened with CFRCM plates. Refined finite element models (FEMs) were developed by explicitly incorporating the steel–concrete bond-slip behaviour, the carbon fabric (CF) mesh–cementitious matrix (CM) interface, and the CFRCM–concrete substrate interaction and were validated against experimental results in terms of failure modes, load–deflection responses, and flexural capacities. A parametric study was then conducted to examine the effects of CFRCM layer number, steel corrosion level, and longitudinal reinforcement ratio. The results indicate that the baseline flexural capacity can be fully restored only when the corrosion level remains below approximately 15%; beyond this threshold, none of the CFRCM configurations achieved full recovery. The influence of the reinforcement ratio was found to depend on corrosion severity, while increasing CFRCM layers enhanced flexural performance but exhibited saturation effects for thicker configurations. In addition, corrosion level and CFRCM thickness jointly influenced the failure mode. Comparisons with design predictions show that bilinear CFRCM constitutive models are conservative, whereas existing FRP-based design codes provide closer agreement with numerical and experimental results.
About Me
Concrete durability; Strucutral retrofitting; Fatigue testing; Finite element modelling
Concrete durability; Strucutral retrofitting; Fatigue testing; Finite element modelling