Paolo Candeloro

Mr. Paolo Candeloro

University Niccolò Cusano, Rome, Lazio, Italy
orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 August 2022 in Fluids
Verified
Journal Article
Open access
PDF file
PCPaolo Candeloro
Paolo Candeloro
DRDaniele Ragni
Daniele Ragni
TPTiziano Pagliaroli
Tiziano Pagliaroli
In the last decade, the drone market has grown rapidly for both civil and military purposes. Due to their versatility, the demand for drones is constantly increasing, with several industrial players joining the venture to transfer urban mobility to the air. This has exacerbated the problem of noise pollution, mainly due to the relatively lower altitude of these vehicles and the proximity of their routes to extremely densely populated areas. In particular, both the aerodynamic and aeroacoustic optimization of the propulsive system and of its interaction with the airframe are key aspects of unmanned aerial vehicle design that can signify the success or the failure of their mission. The industrial challenge involves finding the best performance in terms of loading, efficiency and weight, and, at the same time, the most silent configuration. For these reasons, research has focused on an initial localization of the noise sources and, on further analysis, of the noise generation mechanism, focusing particularly on directivity and scattering. The aim of the present study is to review the noise source mechanisms and the state-of-the-art control strategies, available in the literature, for its suppression, focusing especially on the fluid-dynamic aspects of low Reynolds numbers of the propulsive system and on the interaction of the propulsive system flow with the airframe.

28 September 2023 in Aerospace
Verified
Journal Article
Open access
PDF file
RNRanieri Emanuele Nargi
Ranieri Emanuele Nargi
PCPaolo Candeloro
Paolo Candeloro
FGFabrizio De Gregorio
Fabrizio De Gregorio
GCGiuseppe Ceglia
Giuseppe Ceglia
TPTiziano Pagliaroli
Tiziano Pagliaroli
An investigation of twin corotating rotors’ interaction effects was performed by load (thrust and torque) measurements, flow field dynamics through Time-Resolved Particle Image Velocimetry, and acoustic emissions using a microphone array. Two rotors, each with a diameter of D = 393.7 mm and equipped with three blades, were investigated in a side-by-side configuration, to simulate a multirotor propulsion system. The mutual distance between the propellers is 1.02 D, and four different rotating speeds, i.e., 2620, 3500, 4360, and 5200 RPM, were explored. In such a configuration, thrust and torque undergo a reduction compared to that found for a single propeller configuration. The level of aerodynamic load fluctuations increases as well. The interaction of the wakes produces a recirculation region at the external periphery of the shear layers. An innovative approach involving the coupling of Proper Orthogonal Decomposition (POD) and Wavelet Transform has been employed to investigate the dominant structures within the flow and their mutual influence. The results reveal that the interacting wakes are dominated by a wave-like motion pulsating at Harmonics of the Blade Passing Frequency (HBPF) of 1/3. Higher orders of POD modes capture coherent vortical structures, including tip vortices pulsating at HBPF = 1. The aeroacoustic investigation shows that the noise level, in terms of the Over All Sound Pressure Level, presents a remarkable increment concerning that generated by the single propeller.

19 February 2025 in Aerospace
Verified
Journal Article
Open access
PDF file
FDFabio Del Duchetto
Fabio Del Duchetto
TPTiziano Pagliaroli
Tiziano Pagliaroli
PCPaolo Candeloro
Paolo Candeloro
KRKarl-Stéphane Rossignol
Karl-Stéphane Rossignol
JYJianping Yin
Jianping Yin
The main goal of the present study is to explore the noise mitigation potential using an active control strategy based on rotor phase synchronization. This work is focused on the effects of the inflow velocity on the noise interference effect. The inflow velocity does not affect the phase at which the interference phenomenon is observed, as expected. On the other hand, the intensity of the pressure fluctuations is influenced by the inflow velocity for all of the rotor phase shift conditions investigated. Specifically, as the inflow velocity increases, maintaining a constant rotational speed, in the Overall Sound Pressure Level graphs, a reduction of approximately 10 dB is observed. This effect also applies to cases of destructive interference, highlighting the remarkable versatility of this noise reduction technique.

27 June 2022 in Fluids
Verified
Journal Article
Open access
PDF file
PCPaolo Candeloro
Paolo Candeloro
EMEdoardo Martellini
Edoardo Martellini
RNRobert Nederlof
Robert Nederlof
TSTomas Sinnige
Tomas Sinnige
TPTiziano Pagliaroli
Tiziano Pagliaroli
The aim of the present manuscript is to investigate the noise footprint of an isolated propeller in different flight configurations for the propulsion of a hybrid-electric aircraft. Experimental tests were performed at the Low-Turbulence Tunnel located at Delft University of Technology with a powered propeller model and flush-mounted microphones in the tunnel floor. The propeller was investigated at different advance ratios in order to study the noise impact in propulsive and energy harvesting configurations. For brevity, this work only reports the results at the conditions of maximum efficiency in both propulsive and energy harvesting regimes, for a fixed blade pitch setting. Comparing these two configurations, a frequency-domain analysis reveals a significant modification in the nature of the noise source. In the propulsive configuration, most of the energy is related to the tonal noise component, as expected for an isolated propeller; however, in energy harvesting configuration, the broadband noise component increases significantly compared to the propulsive mode. A more detailed analysis requires separation of the two noise components and, for this purpose, an innovative decomposition strategy based on proper orthogonal decomposition (POD) has been defined. This novel technique shows promising results; both in the time and in the Fourier domains the two reconstructed components perfectly describe the original signal and no phase delays or other mathematical artifices are introduced. In this sense, it can represent a very powerful tool to identify noise sources and, at the same time, to define a proper control strategy aimed at noise mitigation.

9 September 2025 in Applied Acoustics
Verified
Journal Article
Closed access
PCPaolo Candeloro
Paolo Candeloro
DRDaniele Ragni
Daniele Ragni
TPTiziano Pagliaroli
Tiziano Pagliaroli

8 October 2019 in Preprints.org
Verified
Preprint
Open access
PDF file
PCPaolo Candeloro
Paolo Candeloro
TPTiziano Pagliaroli
Tiziano Pagliaroli
DRDaniele Ragni
Daniele Ragni
Silvia Di FrancescoSilvia Di Francesco
Silvia Di Francesco
In the last decade, the drone market has grown rapidly for both civil and military purposes. Due to their versatility, drones demand is constantly increasing, with several industrial players joining the venture to transfer urban mobility to the air. This has exacerbated the problem of noise pollution, mainly due to the relatively lower altitude of these vehicles and to the proximity of their routes to extremely densely populated areas. In particular, both the aerodynamic and aeroacoustic optimization of the propulsive system and of its interaction with the airframe are key aspects of the design of aerial vehicles for the success or the failure of their mission. The industrial challenge involves finding the best performance in terms of loading, efficiency and weight, and, at the same time, the most silent configuration. For this reason, research has focused on an initial localization of the noise sources and, on further analysis, of the noise generation mechanism, focusing particularly on directivity and scattering. The aim of the present study is to review the noise source mechanisms and the state-of-the-art technologies available in literature for its suppression, focusing especially on the fluid-dynamic aspects of low Reynolds numbers of the propulsive system and on the interaction of the propulsive-system flow with the airframe.