The introduction of quiet short take-off and landing for civil aircraft operations in close proximity to the population poses important technological challenges. One critical aspect is the realization of extreme lift augmentation at low acoustic emissions. The aircraft concept selected to achieve this goal is a high-lift system equipped with an active flow-control non-slotted flap and a droop nose. For this specific configuration, trailing edge noise becomes a dominant noise source. Porous materials as a passive means for trailing-edge noise reduction are selected and characterized. Results of extensive experimental investigations in the acoustic wind tunnel Braunschweig are presented and discussed to point out the potential and limitations of the selected porous devices. Practical issues related to material manufacturing and integration into the wind tunnel model are addressed. The noise reduction potential of passive porous trailing-edge devices is found to strongly depend on both these aspects. Issues related to the characterization of the porous materials properties are described. Although porous materials are found to be successful at reducing trailing-edge noise emissions, the results indicate that there is still a need for more generic investigations to further clarify the parametric dependencies between noise reduction and material properties.
The main goal of the present study is to explore the noise mitigation potential using an active control strategy based on rotor phase synchronization. This work is focused on the effects of the inflow velocity on the noise interference effect. The inflow velocity does not affect the phase at which the interference phenomenon is observed, as expected. On the other hand, the intensity of the pressure fluctuations is influenced by the inflow velocity for all of the rotor phase shift conditions investigated. Specifically, as the inflow velocity increases, maintaining a constant rotational speed, in the Overall Sound Pressure Level graphs, a reduction of approximately 10 dB is observed. This effect also applies to cases of destructive interference, highlighting the remarkable versatility of this noise reduction technique.
In order to provide an innovative form of urban air mobility, a new and versatile generation of small, highly automated aircraft is currently being developed. This is made feasible by the development of new technologies such as electrified powertrains, Vertical Take-Off and Landing capabilities and distributed propulsion systems. The operation of these novel aircraft types will generate a new source of air traffic noise. In particular, the perception of noise and the annoyance caused by these aircraft and their distributed propulsion systems are likely to deviate from those of conventional aircraft and will also depend on psychoacoustic effects. Thus, the noise emission and its subjective perception will be key factors for the success of urban air mobility vehicles and their acceptance by society. In order to investigate acoustic effects that enable low-noise aircraft design, a multidisciplinary approach is applied to develop new aircraft concepts for urban air mobility. This approach includes the conceptual design of two vehicles, one vehicle with tilt-rotors and one with tiltable, ducted fans; the sizing of an electric powertrain; the design and manufacturing of a wingtip rotor; and the design and manufacturing of the low-speed ducted fans. This paper presents the design of the two vehicle architectures, including their electric powertrain, as well as the aerodynamic and acoustic performance of the rotor and fan.
Understanding the development of turbulent jets in subsonic nozzles is essential for improving jet noise prediction models and for validating high-fidelity numerical simulations in aerospace applications. Within the framework of the NATO STO AVT-415 activity, a dedicated experimental campaign was carried out at the Italian Aerospace Research Center (CIRA) to investigate the velocity field and turbulence characteristics at the inlet and exit of a novel subsonic nozzle configuration using hot-wire anemometry (HWA). The results offer a comprehensive description of the flow evolution downstream of the nozzle exit and a detailed characterization of the turbulence properties upstream of the nozzle. These measurements are of significant importance for validating numerical simulations and establishing accurate boundary conditions.