In the study, parts are fused deposition modeling–printed using polylactic acid filaments filled with copper, brass, bronze, tungsten, and carbon fiber. Wear and three-point bending tests are applied to FDM-printed specimens and it is yielded that on-edge oriented specimens had higher flexural strength while flat orientation contributed to wear resistance. Wear tracks are examined, and mostly abrasive wear is detected in the dry sliding condition while adhesive, fatigue and abrasive wear is observed in the wet sliding condition. Brass-filled polylactic acid specimens showed highest flexural strength and flexural modulus with 46.73 MPa and 1.53 GPa, respectively. Besides, the most wear resistant filler is determined as tungsten for dry and wet sliding conditions.
Acrylonitrile-butadiene-styrene test specimens were additively manufactured by fused deposition method to investigate the effects of infill pattern and density on wear rate, coefficient of friction, wear mechanisms, and microscopic wear characterization. The surface morphology of specimens was characterized using a scanning electron microscope. Under constant parameters of applied load, sliding speed, and sliding time, wear tests were carried out at room temperature. The study revealed that a grid pattern of high infill density and a honeycomb pattern of low infill density showed the lowest wear rate and lowest coefficient of friction compared to the rectilinear pattern. Infill pattern and density affected the wear rate behavior of specimens directly. Moreover, adhesion between additively manufactured layers along with surface texture affects the wear behavior and wear rate. Increasing infill density allowed poor cooling of previously built layers. Longer process time results in rough surfaces.
This study applied classical and intercritical heat treatments to maraging steel (MS1) samples produced with standard additive manufacturing (AM) production parameters. The effects of heat treatment parameters on the microstructure-phase changes of the material were investigated by optical microscope (OM), scanning electron microscope (SEM), Electron Dispersion Spectroscopy (EDX), and X-ray diffraction analysis (XRD) techniques. Likewise, microhardness and dry sliding wear tests were performed to determine the relationship of heat treatment parameters (especially intercritical heat treatment) to the mechanical properties and wear of the material. The results reveal that the intercritical heat treatment is exciting for the AM/MS1 material.