Ying-Chyi Wang

Mr. Ying-Chyi Wang

National Taiwan University, Taipei, Taiwan

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2022 in Materials
Verified
Journal Article
Open access
PDF file
CLChen Liu
Chen Liu
CTChia-Yun Tseng
Chia-Yun Tseng
YWYing-Chyi Wang
Ying-Chyi Wang
CHCheng-che Hsu
Cheng-che Hsu
Jian-Zhang ChenJian-Zhang Chen
Jian-Zhang Chen
In this paper, low-pressure 95%Ar–5%H2, pure Ar, and 95%Ar–5%O2 plasmas were used for post-treatment of ruthenium (Ru) deposited on nickel foam (NF) (Ru/NF). Ru/NF was then tested as a catalyst for a hydrogen evolution reaction. Significant improvement in electrocatalytic activity with the lowest overpotential and Tafel slope was observed in an alkaline electrolyte (1 M KOH) with 95%Ar–5%O2 plasma processing on Ru/NF. Linear scanning electrical impedance spectroscopy (EIS) and cyclic voltammetry (CV) also indicate the lowest interfacial impedance and largest electrical double layer capacitance. Experimental results with 0.1 M phosphate buffered saline (PBS) and 0.5 M H2SO4 electrolytes were also demonstrated and compared.

28 December 2023 in Micromachines
Verified
Journal Article
Open access
PDF file
YWYing-Chyi Wang
Ying-Chyi Wang
SYShuo-En Yu
Shuo-En Yu
SLSU YU LUN
SU YU LUN
CHCheng-che Hsu
Cheng-che Hsu
YCYi-Cheng Chuang
Yi-Cheng Chuang
Jian-Zhang ChenJian-Zhang Chen
Jian-Zhang Chen
NiFe2O4 material is grown on carbon paper (CP) with the hydrothermal method for use as electrocatalysts in an alkaline electrolyzer. NiFe2O4 material is used as the anode and cathode catalysts (named NiFe(+)/NiFe(−) hereafter). The results are compared with those obtained using CP/NiFe as the anode and CP/Ru as the cathode (named NiFe)(+)/Ru(−) hereafter). During cell operation with NiFe(+)/Ru(−), the current density reaches 500 mA/cm2 at a cell voltage of 1.79 V, with a specific energy consumption of 4.9 kWh/m3 and an energy efficiency of 66.2%. In comparison, for NiFe(+)/NiFe(−), the current density reaches 500 mA/cm2 at a cell voltage of 2.23 V, with a specific energy consumption of 5.7 kWh/m3 and an energy efficiency of 56.6%. The Faradaic efficiency is 96–99%. With the current density fixed at 400 mA/cm2, after performing a test for 150 h, the cell voltage with NiFe(+)/Ru(−) increases by 0.167 V, whereas that with NiFe(+)/NiFe(−) decreases by only 0.010 V. Good, long-term stability is demonstrated.