Maximum power point tracking (MPPT) algorithms are invariably employed to utilize solar photovoltaic (PV) systems effectively. Perturbation based MPPT algorithms are popular due to their simplicity and reasonable efficiency. While novel MPPT algorithms claim increased energy utilization over classic perturbation techniques, their performance is governed by the choice of optimal algorithm parameters. Existing guidelines for parameter optimization are mathematically laborious and are not generic. Hence, this paper aims to provide simple and comprehensive guidelines to ensure optimal performance from the perturbation based MPPT technique. For an illustration of proposed claims, a solar PV fed boost converter is investigated to examine the effect of input capacitor, digital filter cut-off frequency, system time constant and sampling time on implementing a classic Perturb and Observe (P and O) algorithm. The readers will be presented with two simple step tests (to determine the effective system time constant) and proposed guidelines to choose the optimal performance sampling time. Necessary laboratory experiments show that an appropriate choice of sampling time could increase efficiency and ensure system stability. This investigation’s learnings can be easily extended to any power electronics converter, loads and all perturbation-based algorithms used in solar PV systems. The results of appropriate tests on the system’s mathematical model and the laboratory prototype are presented in detail to support this research’s claims.
This paper deals with design and implementation of speed controller to control the speed of separately excited DC motor using a class A chopper. The speed of Separately Excited DC motor is controlled to a maximum of its rated speed using chopper as a converter. The speed controller used is Proportional Integral type which reduces steady state error and provides fast control. The parameters of the speed controller have been designed using control system theory. The validity of the proposed approach is presented by simulating the DC drive system in SCILAB (XCOS) and also by implementing the same using TI'sF28027 launch pad under varying speed and varying load conditions.
This paper elucidates Low Cost, High performance Chopper based Four Quadrant close loop control of DC Motor. The drive system realized is applicable to Hybrid Electric Vehicles (HEV's) working in all four quadrants. The drive system has been developed and modeled using Scilab /XCOS. The objective of simulation is to predict the performance of the drive system under realistic operating conditions. Close loop speed control of Chopper fed Separately Excited DC Motor (SEDC) is obtained using TI's F28069-M launch pad. Experimental results validate the high performance of the control algorithm utilized in the DC Drive system.
In recent years, solar photovoltaic systems have become more popular and today, this technology has become the application of interest mainly in isolated areas where the power grid is not accessible. Generally, PV fed dc motors are used because of their robust construction and ease to control. However, dc motors need to be frequently maintained due to its commutator and carbon brush. Hence in this paper, centrifugal pump driven by three-phase induction motor is considered. To power the three-phase induction motor, a three-phase voltage source inverter is used which performs two functions, viz., (i) converts the Maximum Power-Point dc voltage into three-phase ac voltage (ii) changes the frequency of the three-phase ac voltage and helps the system to guide at the Maximum Power Point.
Solar Array Drive Assembly (SADA) requires high precision in positioning of the photovoltaic panels, which can be attained through the use of stepper motors. In this paper, a digital controller for micro-stepping drive of stepper motor using Look up Table(LUT) approach is proposed and is compared to the conventional full-step methodology and the Pulse Width Modulation (PWM) technique used for microstepping. The comparison is done on the basis of (I) Switching frequency of the drivers, (II) The hardware complexity involved and (III) Synthesis report-Utilization of number of gates. Although the conventional full-step methodology is easy to implement and reliable, it severely limits in terms of resolution, ripple and mid-frequency resonance. In case of PWM technique for micros-tepping the above mentioned problems are well settled at the cost of high switching frequency. The proposed methodology accounts the problem of resolution, mid-frequency resonance and switching frequency at the cost of the increased external hardware complexity and processor requirements. The design is implemented in Xilinx ISE. Results are presented to show the substantial advantages of the proposed methodology and to bring about comparison with other mentioned methodologies.