The following work deals with the preparation of highly porous activated biochar from sugarcane bagasse (SB) via potassium hydroxide activation and optimization by a D-optimal design. Activation temperatures within the range of 600 to 800 °C, holding times between 60 and 180 min, and KOH impregnation ratios (WKOH/WRBC) ranging between 0.5, 1, and 2 were explored with a view to enhance properties like Brunauer–Emmett–Teller (BET) surface area and total pore volume of biochar while considering mean diameter as well. Optimized conditions in this study were an activation temperature of 800 °C, holding time of 120 min, and KOH impregnation ratio of 1:1. The activated biochar prepared under such conditions had a very high BET surface area, 1149 m2/g, and a total pore volume of 0.53 cm3/g. This was further characterized by thermal gravimetric analysis (TGA), and Fourier transform infrared (FTIR) spectroscopy, indicating improved microporosity with a view to application in adsorption studies. This is a sustainable work to obtain economical high-performance biochar from agricultural waste for application in adsorption and catalytic processes.
17 September 2023 in Colloids and Surfaces A: Physicochemical and Engineering Aspects
A comparative study on the adsorption of ciprofloxacin (CIP) and sulfamethoxazole (SMX) onto CO2-activated biochars derived from leather tannery waste (ABT) and Sargassum brown macroalgae (ABS) is presented. N2 physisorption revealed that ABS possesses a higher Langmuir surface area (1305 m2/g) and a hierarchical micro–mesoporous structure, whereas ABT exhibits a lower surface area (412 m2/g) and a predominantly microporous texture. CHNS and FTIR analyses confirmed the presence of N-, O-, and S-containing heteroatoms and functional groups on both adsorbents, enhancing surface reactivity. Adsorption isotherms fitted well to the Langmuir model, with ABS showing superior maximum capacities of 256.41 mg/g (CIP) and 256.46 mg/g (SMX) compared to ABT (210.13 and 213.00 mg/g, respectively). Kinetic data followed a pseudo-second-order model (R2 > 0.998), with ABS exhibiting faster uptake due to its mesoporosity. Over eight reuse cycles, ABS retained >75% removal efficiency for both antibiotics, while ABT declined to 60–70%. pH-dependent adsorption behavior was governed by the point of zero charge (pHPZC≈ 9.0 for ABT; ≈7.2 for ABS), influencing electrostatic and non-electrostatic interactions. These findings demonstrate that ABS is a highly effective, sustainable adsorbent for antibiotic removal in water treatment applications.