Lipases from Candida antarctica (isoform B) and Rhizomucor miehei (CALB and RML) have been immobilized on octyl-agarose (OC) and further coated with polyethylenimine (PEI) and dextran sulfate (DS). The enzymes just immobilized on OC supports could be easily released from the support using 2% SDS at pH 7, both intact or after thermal inactivation (in fact, after inactivation most enzyme molecules were already desorbed). The coating with PEI and DS greatly reduced the enzyme release during thermal inactivation and improved enzyme stability. However, using OC-CALB/RML-PEI-DS, the full release of the immobilized enzyme to reuse the support required more drastic conditions: a pH value of 3, a buffer concentration over 2 M, and temperatures above 45 °C. However, even these conditions were not able to fully release the thermally inactivated enzyme molecules from the support, being necessary to increase the buffer concentration to 4 M sodium phosphate and decrease the pH to 2.5. The formation of unfolded protein/polymers composites seems to be responsible for this strong interaction between the octyl and some anionic groups of OC supports. The support could be reused five cycles using these conditions with similar loading capacity of the support and stability of the immobilized enzyme.

Lipase B from Candida antarctica (CALB) immobilized on octyl-agarose (OC) was submitted to coating with polyethylenimine (PEI) and dextran sulfate (DS). Using lowly loaded enzyme preparations, the properties of OC-CALB preparations hardly improved, suggesting too large the distance between enzyme molecules. However, using OC-CALB preparations with maximum loading, CALB stability was greatly improved in different conditions after PEI coating. Moreover, the CALB release from the OC support in the presence of detergents, or during thermal or organic solvent inactivations was greatly reduced after this treatment (PEI plus DS coating). The results pointed that the main positive effect of this coating could be derived from the physical intermolecular crosslinking of the CALB molecules with the polymers that reduce the enzyme desorption from the support. The coating of OC-CALB-PEI with DS only produced a minimal improvement on enzyme performance. Even though the enzyme release was much more difficult after physical crosslinking, all enzyme molecules could be released from the OC support combining an ionic detergent (SDS), high buffer concentration, pH 3 and 45 °C, while using the OC-CALB just 2% SDS at pH 7 and 25 °C was enough to release all enzyme. The support could be reused several cycles. Thus, this strategy permitted to greatly reduce the enzyme desorption during operation and to improve enzyme stability while keeping the enzyme immobilization reversibility.

Millions of patients suffer yearly from bone fractures and disorders such as osteoporosis or cancer, which constitute the most common causes of severe long-term pain and physical disabilities. The intrinsic capacity of bone to repair the damaged bone allows normal healing of most small bone injuries. However, larger bone defects or more complex diseases require additional stimulation to fully heal. In this context, the traditional routes to address bone disorders present several associated drawbacks concerning their efficacy and cost-effectiveness. Thus, alternative therapies become necessary to overcome these limitations. In recent decades, bone tissue engineering has emerged as a promising interdisciplinary strategy to mimic environments specifically designed to facilitate bone tissue regeneration. Approaches developed to date aim at three essential factors: osteoconductive scaffolds, osteoinduction through growth factors, and cells with osteogenic capability. This review addresses the biological basis of bone and its remodeling process, providing an overview of the bone tissue engineering strategies developed to date and describing the mechanisms that underlie cell–biomaterial interactions.