Shimpei Aihara

Mr. Shimpei Aihara

Japan Institute of Sports Sciences
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 February 2022 in Sensors
Verified
Journal Article
Open access
PDF file
SAShimpei Aihara
Shimpei Aihara
RSRyusei SHIBATA
Ryusei SHIBATA
RMRyosuke Mizukami
Ryosuke Mizukami
TSTakara Sakai
Takara Sakai
Akira ShionoyaAkira Shionoya
Akira Shionoya
Wheelchair sports are recognized as an international sport, and research and support are being promoted to increase the competitiveness of wheelchair sports. For example, an electromyogram can observe muscle activity. However, it is generally used under controlled conditions due to the complexity of preparing the measurement equipment and the movement restrictions imposed by cables and measurement equipment. It is difficult to perform measurements in actual competition environments. Therefore, in this study, we developed a method to estimate myoelectric potential that can be used in competitive environments and does not limit physical movement. We developed a deep learning model that outputs surface myoelectric potentials by inputting camera images of wheelchair movements and the measured values of inertial sensors installed on wheelchairs. For seven subjects, we estimated the myoelectric potential during chair work, which is important in wheelchair sports. As a result of creating an in-subject model and comparing the estimated myoelectric potential with the myoelectric potential measured by an electromyogram, we confirmed a correlation (correlation coefficient 0.5 or greater at a significance level of 0.1%). Since this method can estimate the myoelectric potential without limiting the movement of the body, it is considered that it can be applied to the performance evaluation of wheelchair sports.

24 April 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
GCGuanyu Chen
Guanyu Chen
HMHaruna Mori
Haruna Mori
SAShimpei Aihara
Shimpei Aihara
Fumito MasuiFumito Masui
Fumito Masui
YTYoshinari Takegawa
Yoshinari Takegawa
Real-time feedback is increasingly valued in sports training, yet in curling it is commonly delivered through off-stone displays or post hoc review, forcing disruptive gaze shifts while athletes track a moving and continuously rotating stone, especially during collaborative sweeping. To address this gap, we present TabletStone, a stone-mounted tablet interface that provides in situ, glanceable feedback with role-aware layouts and rotation-robust visualization. TabletStone is implemented as a lightweight, UDP-driven endpoint that renders upstream training signals on the stone while adapting the UI to throwers and sweepers. To preserve readability under rotation, we formalize an absolute-position fixation strategy based on an on-device yaw estimate and counter-rotation transforms. We evaluate TabletStone through an initial controlled user study with six experienced curlers performing sweeping while reading on-stone values under two conditions (baseline and absolute-position fixation). The study showed higher subjective readability together with improved accuracy and recall for absolute-position fixation, while precision remained high in both conditions; missed readouts remained the dominant failure mode under workload. Overall, these results support the feasibility and potential usefulness of combining role-aware UI/UX with rotation-aware stabilization for on-object feedback in curling training, while broader training effects remain to be validated.

19 May 2026 in Sensors
Verified
Journal Article
Open access
PDF file
AKAkihiro Kawamura
Akihiro Kawamura
TSTakumi Shintani
Takumi Shintani
SAShimpei Aihara
Shimpei Aihara
RKRyo Kurazume
Ryo Kurazume
Understanding the interaction forces between climbers and climbing holds is important for motion analysis and performance evaluation in sport climbing. In particular, force measurement during speed climbing can provide valuable insights into explosive movements and athlete performance. However, many existing measurement systems require modifications to the climbing wall structure or sensors installed behind the wall, which limits their applicability to existing speed climbing facilities. This study proposes a wireless instrumented climbing hold for speed climbing that enables force-related measurement without modifying the wall structure. The proposed system integrates a six-axis force sensor, a microcomputer, a wireless communication module, and a battery inside the climbing hold. This self-contained configuration allows the hold to wirelessly transmit force and moment data during climbing while maintaining compatibility with standard speed climbing walls and competition environments. In addition, the system enables an estimation of the point of force application on the hold surface by combining measured force and moment data with the three-dimensional hold geometry. Experimental evaluations were conducted to verify the feasibility and performance of the system. External load tests using a digital force gauge confirmed that the embedded sensor can measure static loads and respond to rapidly changing loads with sufficient temporal responsiveness, and the estimated point of force application corresponded closely to the actual loading point. Furthermore, measurements on an actual speed climbing wall demonstrated that the proposed system can successfully capture interaction forces during climbing movements. These results indicate that the proposed system is a practical tool for force-based motion analysis in speed climbing.

18 July 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
TSTadaaki SONE
Tadaaki SONE
RKRyosuke Katagiri
Ryosuke Katagiri
TKTakashi Kawamura
Takashi Kawamura
SAShimpei Aihara
Shimpei Aihara
In curling, quantitative assessment of ice surface conditions during actual play is challenging, and existing sensor-on-stone approaches cannot simultaneously capture ice-contact vibration and athlete-related measurements. We developed a self-contained wearable slider unit embedding two IMUs (LSM6DSV16X), a wideband accelerometer (IIS3DWB), and plantar pressure sensors in a commercially compatible curling slider. Measurements were conducted with two participants under four ice surface conditions (used pebble, no-pebble, extra-fine, and coarse-fine pebble) at an actual curling hall. The root mean square (RMS) amplitude of the DC-subtracted IIS3DWB Z-axis vibration signal distinguished no-pebble from pebbled ice but did not distinguish among the three pebbled conditions. The spectral centroid of the no-pebble condition was also biased toward higher frequencies, although participant-dependent effects remained among pebbled conditions. The slider acquired plantar-pressure variation during delivery, and an exploratory pooled analysis showed a pattern consistent with greater right/left balance variation in trials with greater MOCAP-derived lateral wobble. Because only two participants were tested and the lateral pressure channels reached the calibration limit, participant-specific validation requires a wider measurement range and additional participants. These results support the feasibility of simultaneous ice-contact vibration and plantar-pressure measurement during curling delivery.

10 July 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
RCRintaro Chiba
Rintaro Chiba
YTYasumasa Tamura
Yasumasa Tamura
SAShimpei Aihara
Shimpei Aihara
MYMasahito Yamamoto
Masahito Yamamoto
Curling is a strategic sport in which shot decisions involve both expected rewards and inherent risks; expected-score distributions (ESDs)—probability distributions over possible final scores—capture this uncertainty as a risk-aware strategic indicator. Although unified frameworks predicting ESDs across all shots have been proposed, their internal behavior and learned output characteristics have not been systematically examined. We construct an all-shot ESD prediction framework grounded entirely in real-match board configurations drawn from World Curling Federation championship events and conduct a shot-wise analysis along two complementary axes: accuracy, the model’s reproduction of its training targets, and plausibility, the validity of those targets at aggregate and in-match scales. Accuracy degrades monotonically with shot number; only shot 16 admits comparison with an independent reference, while intermediate-shot labels are bootstrap rollouts of the next-shot model. An independent ground-truth probe at the first backward step (shot 15,500 boards × 95 contexts) bounds the consequence of this bootstrap structure: the resulting deviation is a small selection-induced hammer-underestimation bias common to both FiLM and concatenation chains, whose magnitude is more than an order of magnitude larger than the FiLM chain versus concatenation chain stage difference, and full multi-step verification beyond the first step is structurally out of reach. Within this scope the aggregate ESD shares the gross shape of the empirical end-score distribution and the qualitative hammer/non-hammer ordering, with a hammer-favorable offset attributed—after disentangling intent from execution on the shot-percentage 100% subset—to a label execution-noise envelope that is tighter than the realized play of top-tier matches. Within real matches the chain responds smoothly to each delivered stone and, at the directly validated terminal shot, assigns mean probability ≈0.71–0.72 to the realized end score under intended execution (against 0.28 for a marginal-frequency baseline), transferring from senior to junior populations. The framework is best read as an internally coherent chain anchored to a directly validated final-shot calibration, statistically plausible under intended execution with a clear boundary at execution failure. Two structural limitations remain: rare high-magnitude outcomes are scarce in real data and produce a heavy upper tail of accuracy errors, and a single fixed execution-noise envelope that is tighter than top-tier realized play accounts for the aggregate hammer-side offset and motivates recalibration against real-match execution statistics.

2 April 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
KSKei Suzumura
Kei Suzumura
YTYasumasa Tamura
Yasumasa Tamura
SAShimpei Aihara
Shimpei Aihara
MYMasahito Yamamoto
Masahito Yamamoto
Curling is a sport in which two teams take turns delivering stones on ice and compete for total scores. It is a highly strategic sport, often referred to as “Chess on Ice”. In recent years, research on curling AI and statistical analysis aimed at tactical evaluation has been active. Decision-making in curling highly depends on the current stone position state, so obtaining stone positions is essential for tactical analysis. This study proposes an object detection model capable of acquiring stone coordinates with high accuracy and generality from stone position images of actual games. The proposed model was realized with a small amount of manually annotated data and pseudo-labeled images. Using the active testing method, the image-level accuracy of data—a strict criterion requiring perfect detection of all stones in a single image—for approximately 100,000 items was estimated to be 99.37%. Furthermore, we measured the positional error of the detected stones and found an average result of 0.472 px. We determined that this model had sufficient accuracy for practical use, so we decided to store the acquired coordinates in a database and use them as training data for the curling AI and statistical analysis.