Ștefan Cula

Mr. Ștefan Cula

Robots and Production Systems, National Polytechnic University of Science and Technology Bucharest, Bucharest, Bucureşti, Romania
orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 May 2026 in Polymers
Verified
Journal Article
Open access
PDF file
Diana PopescuDiana Popescu
Diana Popescu
Ștefan CulaȘtefan Cula
Ștefan Cula
LPLidia Lorentina Parpala
Lidia Lorentina Parpala
Conductive filaments for Material Extrusion Additive Manufacturing (MEX) can enable low-cost fabrication of functional parts with embedded electrical features. However, systematic studies on process-dependent electrical properties like apparent resistivity and repeatability are limited, and the post-printing stability of the electrical response is not commonly addressed. This study evaluates the influence of printing temperature, printing speed and layer height on the apparent resistivity, specimen-to-specimen repeatability and time-dependent drift of a commercial carbon black-filled conductive PLA filament (ProtoPasta). The novelty of the study consists of evaluating not only the initial apparent resistivity, but also the repeatability between specimens and the post-print drift of apparent resistivity over a 0–50 h interval. The filament was investigated using three printing temperatures (210–230 °C), two printing speeds (60–80 mm/s) and three layer heights (0.2–0.4 mm), with three replicates per configuration. Apparent resistivity ranged between 0.156 and 0.205 kΩ·mm at t0 and between 0.162 and 0.222 kΩ·mm at t50. Multifactorial ANOVA and main-effects analyses showed that the printing temperature was the main factor affecting mean apparent resistivity at both t0 and t50. Higher temperature reduced apparent resistivity, most likely due to improved polymer flow, inter-bead/inter-layer bonding and conductive-network continuity. Printing speed had no significant main effect on the mean apparent resistivity or drift within the tested range. Repeatability depended on the parameter configuration and measurement time, with variability increasing after 24 h and then becoming mainly dependent on layer height. Drift analysis showed a significant main effect of layer height and a significant layer height × temperature interaction, with the largest increase at 0.3 mm. These results show that parameter selection for conductive MEX parts should consider both the initial resistivity level and post-print stability over time.

1 January 2023 in International Journal of Modeling and Optimization
Verified
Journal Article
Closed access
MCM. Costea
M. Costea
Ștefan CulaȘtefan Cula
Ștefan Cula
GJG. Jiga
G. Jiga