The focus of the experimental work was on shallow spiral geothermal heat exchanger configurations. Real-scale experiments were carried out for vertically oriented spiral collectors (helix) in sand and soil. One objective was to develop a measurement concept in laboratory environment to create a framework for a validated database. This database serves as the basis for further and new development of engineering design tools. To achieve the highest possible data-point density in the observed environment, temperature sensors and a fiber-optic temperature measurement system (DTS) were used. Soil probes were taken in situ before and after the measurements and analyzed at a thermophysical laboratory to determine material properties. The heat flow was controlled by an electric heating cable, which was installed in the form of a spiral-shaped heat exchanger in a 1 m³ container. To guarantee constant boundary conditions, the measurements were carried out in a climate chamber at a defined ambient temperature. The evaluation of the transient response behavior is spatially resolved. The results are coordinate-based temperature points, which describe temperature gradients in all axes of the container over time, which are combined with known soil properties. The collected data was used to develop computational fluid dynamic (CFD) models, which are used to extend the variety of geometry and soil configurations for developing new design tools.

Heat pumps are widely regarded as a key technology for sustainable heating, offering a pathway to significantly reduce fossil fuel dependency and combat the climate crisis. However, replacing individual gas boilers with heat pumps in multi-unit residential buildings remains a substantial challenge despite its immense potential to lower urban greenhouse gas emissions. To address this, the following paper describes the development of a compact, modular heat pump system designed to replace conventional gas boilers, focusing on the building and testing of a prototype for such a modular heat pump system. The prototype supports multiple functionalities, including space heating, cooling, and domestic hot water production. The performance advantages of two different compressor technologies were exploited to optimize the efficiency of the complete system and the pressure lifts associated with applications for heating and domestic hot water production. Thus, measurements were conducted across a range of operating points, comparing different heat pump module types. In the case of the piston compressor module, the Carnot efficiency was in the range of 47.2% to 50.4%. The total isentropic efficiency for floor heating and domestic hot water production was above 0.45 for both piston and rotary compressors.