The conventional approach in vehicle suspension optimization based on the ride comfort and the handling performance requires decomposition of the multi-performance targets, followed by lengthy iteration processes. Suspension tuning is a time-consuming process, which often requires the benchmarking of competitors’ vehicles to define the performance targets of the desired vehicle by experimental techniques. Optimum targets are difficult to derive from benchmark vehicles as each vehicle has its own unique vehicle set-up. A new method is proposed to simplify this process and to reduce significantly the development process. These design objectives are formulated into a multi-objective optimization problem together with the suspension packaging dimensions as the design constraints. This is in order to produce a Pareto front of an optimized vehicle at the early stages of design. These objectives are minimized using a multi-objective optimization workflow, which involves a sampling technique, and a regularity-model-based multi-objective estimation of the distribution algorithm to solve greater than 100-dimensional spaces of the design parameters by the software-in-the-loop optimization process. The methodology showed promising results in optimizing a full-vehicle suspension design based on the ride comfort and the handling performance, in comparison with the conventional approach.
The design of a vehicle suspension system through simulation requires accurate representation of the design parameters. These parameters are usually difficult to measure or sometimes unavailable. This article proposes an efficient approach to identify the unknown parameters through optimization based on experimental results, where the covariance matrix adaptation–evolutionary strategy (CMA-es) is utilized to improve the simulation and experimental results against the kinematic and compliance tests. This speeds up the design and development cycle by recovering all the unknown data with respect to a set of kinematic measurements through a single optimization process. A case study employing a McPherson strut suspension system is modelled in a multi-body dynamic system. Three kinematic and compliance tests are examined, namely, vertical parallel wheel travel, opposite wheel travel and single wheel travel. The problem is formulated as a multi-objective optimization problem with 40 objectives and 49 design parameters. A hierarchical clustering method based on global sensitivity analysis is used to reduce the number of objectives to 30 by grouping correlated objectives together. Then, a dynamic summation of rank value is used as pseudo-objective functions to reformulate the multi-objective optimization to a single-objective optimization problem. The optimized results show a significant improvement in the correlation between the simulated model and the experimental model. Once accurate representation of the vehicle suspension model is achieved, further analysis, such as ride and handling performances, can be implemented for further optimization.
Polylactic acid (PLA) bioplastic is a common material used in Fused Deposition Modeling (FDM) 3D printing. It is biodegradable and environmentally friendly biopolymer which made out of corn. However, it exhibits weak mechanical properties which reduced its usability as a functional prototype in a real-world application. In the present study, two PLA composites are created through coextruded with 3K carbon fibres and twisted Kevlar string (as core fibre) to form a fibre reinforced parts (FRP). The mechanical strength of printed parts was examined using ASTM D638 standard with a strain rate of 1 mm/min. It has been demonstrated that the FRPs coextruded with 3K carbon fibres had achieved significant improvement in Young’s modulus (+180.6%, 9.205 GPa), ultimate tensile strength (+175.3%, 103 MPa) and maximum tensile strain (+21.6%, 1.833%). Although the Young’s modulus of Kevlar FRP was found to be similar to as compared to unreinforced PLA (~3.29 GPa), it has gained significant increment in terms of maximum tensile strain (+179.7%, 104.64 MPa), and maximum tensile strain (+257%, 5.384%). Thus, this study revealed two unique composite materials, in which the 3K carbon FRP can offer stiff and high strength structure while Kevlar FRP offers similar strength but at a higher elasticity.