This paper deals with the simultaneous gust and maneuver load alleviation problem of a seamless active morphing wing. The incremental nonlinear dynamic inversion with quadratic programming control ...

The presented study investigates the design and development of an autonomous morphing wing concept developed in the scope of the SmartX project, which aims to demonstrate in-flight performance optimisation with active morphing. To progress this goal, a novel distributed morphing concept with six translation induced camber morphing trailing edge modules is proposed in this study. The modules are interconnected using elastomeric skin segments to allow seamless variation of local lift distribution along the wingspan. A fluid-structure interaction optimisation tool is developed to produce an optimised laminate design considering the ply orientation, laminate thickness, laminate properties and actuation loads of the module. Analysis of the kinematic model of the integrated actuator system is performed, and a design is achieved, which meets the required continuous load and fulfils both static and dynamic requirements in terms of bandwidth and peak actuator torque with conventional actuators. The morphing design is validated using digital image correlation measurements of the morphing modules. Characterisation of mechanical losses in the actuator mechanism is performed. Out-of-plane deformations in the bottom skin and added stiffness of the elastomer are identified as the impacting factors of the reduced tip deflection.

This paper proposes a nonlinear control architecture for flexible aircraft simultaneous trajectory tracking and load alleviation. By exploiting the control redundancy, the gust and maneuver loads a...

Inspired by nature, smart morphing technologies enable the aircraft of tomorrow to sense their environment and adapt the shape of their wings in flight to minimize fuel consumption and emissions. A primary challenge on the road to this feature is how to use the knowledge gathered from sensory data to establish an optimal shape adaptively and continuously in flight. To address this challenge, this article proposes an online black-box aerodynamic performance optimization architecture for active morphing wings. The proposed method integrates a global online-learned radial basis function neural network (RBFNN) model with an evolutionary optimization strategy, which can find global optima without requiring in-flight local model excitation maneuvers. The actual wing shape is sensed via a computer vision system, while the optimized wing shape is realized via nonlinear adaptive control. The effectiveness of the optimization architecture was experimentally validated on an active trailing-edge (TE) camber morphing wing demonstrator with distributed sensing and control in an open jet wind tunnel. Compared with the unmorphed shape, a 7.8% drag reduction was realized, while achieving the required amount of lift. Further data-driven predictions have indicated that up to 19.8% of drag reduction is achievable and have provided insight into the trends in optimal wing shapes for a wide range of lift targets.

This article describes the challenges of integrating smart sensing, actuation, and control concepts into an over-sensed and over-actuated technology integrator. This technology integrator has more control inputs than the expected responses or outputs (over-actuated), and its every state is measured using more than one sensor system (over-sensed). The hardware integration platform is chosen to be a wind tunnel model of a low-speed aircraft wing such that it can be tested in a large university-level wind tunnel. This hardware technology integrator is designed for multiple objectives. The nature of these objectives is aerodynamic, structural, and aeroelastic, or, more specifically; drag reduction, static and dynamics loads control, aeroelastic stability control, and lift control. Enabling technologies, such as morphing, piezoelectric actuation and sensing, and fibre-optic sensing are selected to fulfil the mentioned objectives. The technology integration challenges are morphing, actuation integration, sensor integration, software and data integration, and control system integration. The built demonstrator shows the intended level of technology integration.