The last decade has seen a flurry of studies related to graphene nanoribbons owing to their potential applications in the quantum realm. However, little experimental work has been reported towards nanoribbons of other 2D materials. Here, we propose a universal approach to synthesize high-quality networks of nanoribbons from arbitrary 2D materials while maintaining high crystallinity, narrow size distribution, and straightforward device integrability. The wide applicability of this technique is demonstrated by fabricating molybednum disulphide, tungsten disulphide, tungsten diselenide, and graphene nanoribbon field effect transistors that inherently do not suffer from interconnection resistance. By relying on self-aligning organic nanostructures as masks, we demonstrate the possibility of controlling the predominant crystallographic direction of the nanoribbon’s edges. Electrical characterization shows record mobilities and very high ON currents despite extreme width scaling. Lastly, we explore decoration of nanoribbon edges with plasmonic particles paving the way for nanoribbon-based opto-electronic devices.
Biocompatible poly(lactide-co-glycolide) scaffolds fabricated via electrospinning are having promising properties as implants for the regeneration of fast-growing tissues, which are able to degrade in the body. The hereby-presented research work investigates the surface modification of these scaffolds in order to improve antibacterial properties of this type of scaffolds, as it can increase their application possibilities in medicine. Therefore, the scaffolds were surface-modified by means of pulsed direct current magnetron co-sputtering of copper and titanium targets in an inert atmosphere of argon. In order to obtain different amounts of copper and titanium in the resulting coatings, three different surface-modified scaffold samples were produced by changing the magnetron sputtering process parameters. The success of the antibacterial properties’ improvement was tested with the methicillin-resistant bacterium Staphylococcus aureus. In addition, the resulting cell toxicity of the surface modification by copper and titanium was examined using mouse embryonic and human gingival fibroblasts. As a result, the scaffold samples surface-modified with the highest copper to titanium ratio show the best antibacterial properties and no toxicity against mouse fibroblasts, but have a toxic effect to human gingival fibroblasts. The scaffold samples with the lowest copper to titanium ratio display no antibacterial effect and toxicity. The optimal poly(lactide-co-glycolide) scaffold sample is surface-modified with a medium ratio of copper and titanium that has antibacterial properties and is non-toxic to both cell cultures.
9 October 2023 in Journal of Colloid and Interface Science
In this work, the effects of weight concentration on the properties of poly(lactide-co-glycolide) polymeric scaffolds prepared by electrospinning are investigated, using four different weight concentrations of poly(lactide-co-glycolide) for the electrospinning solutions (2, 3, 4, 5 wt.%). With increasing concentration of poly(lactide-co-glycolide) in the electrospinning solutions, their viscosity increases significantly. The average fiber diameter of the scaffolds also increases with increasing concentration. Moreover, the tensile strength and maximum elongation at break of the scaffold increase with increasing electrospinning concentration. The prepared scaffolds have hydrophobic properties and their wetting angle does not change with the concentration of the electrospinning solution. All poly(lactide-co-glycolide) scaffolds are non-toxic toward fibroblasts of the cell line 3T3-L1, with the highest numbers of cells observed on the surface of scaffolds prepared from the 2-, 3- and 4-wt.% electrospinning solutions. The results of the analysis of mechanical and biological properties indicate that the poly(lactide-co-glycolide) scaffolds prepared from the 4 wt.% electrospinning solution have optimal properties for future applications in skin tissue engineering. This is due to the fact that the poly(lactide-co-glycolide) scaffolds prepared from the 2 wt.% and 3 wt.% electrospinning solution exhibit low mechanical properties, and 5 wt.% have the lowest porosity values, which might be the cause of their lowest biological properties.