La Fossa cone is an active stratovolcano located on Vulcano Island in the Aeolian Archipelago (southern Italy). Its activity is characterized by explosive phreatic and phreatomagmatic eruptions producing wet and dry pyroclastic surges, pumice fall deposits, and highly viscous lava flows. Nine 2‐D electrical resistivity tomograms (ERTs; electrode spacing 20 m, with a depth of investigation >200 m) were obtained to image the edifice. In addition, we also measured the self‐potential, the CO₂ flux from the soil, and the temperature along these profiles at the same locations. These data provide complementary information to interpret the ERT profiles. The ERT profiles allow us to identify the main structural boundaries (and their associated fluid circulations) defining the shallow architecture of the Fossa cone. The hydrothermal system is identified by very low values of the electrical resistivity (400 Ω m). Inside the crater it is possible to follow the plumbing system of the main fumarolic areas. On the flank of the edifice a thick layer of tuff is also marked by very low resistivity values (in the range 1–20 Ω m) because of its composition in clays and zeolites. The ashes and pyroclastic materials ejected during the nineteenth‐century eruptions and partially covering the flank of the volcano correspond to relatively resistive materials (several hundreds to several thousands Ω m). We carried out laboratory measurements of the electrical resistivity and the streaming potential coupling coefficient of the main materials forming the volcanic edifice. A 2‐D simulation of the groundwater flow is performed over the edifice using a commercial finite element code. Input parameters are the topography, the ERT cross section, and the value of the measured streaming current coupling coefficient. From this simulation we computed the self‐potential field, and we found good agreement with the measured self‐potential data by adjusting the boundary conditions for the flux of water. Inverse modeling shows that self‐potential data can be used to determine the pattern of groundwater flow and potentially to assess water budget at the scale of the volcanic edifice.

Identifying accurate topographic variations associated with volcanic eruptions plays a key role in obtaining information on eruptive parameters, volcano structure, input data for volcano processes modelling, and civil protection and recovery actions. The 2021 eruption of Cumbre Vieja volcano is the largest eruptive event in the recorded history for La Palma Island. Over the course of almost 3 months, the volcano produced profound morphological changes in the landscape affecting both the natural and the anthropic environment over an area of tens of km². We present the results of a UAS (Unoccupied Aircraft System) survey consisting of >12,000 photographs coupled with Structure-from-Motion photogrammetry that allowed us to produce a very-high-resolution (0.2 m/pixel) Digital Surface Model (DSM). We characterised the surface topography of the newly formed volcanic landforms and produced an elevation difference map by differencing our survey and a pre-event surface, identifying morphological changes in detail. The present DSM, the first one with such a high resolution to our knowledge, represents a relevant contribution to both the scientific community and the local authorities.