Natural ventilation is an effective energy-saving strategy conducive to promoting sustainable agricultural production. A comprehensive numerical simulation is performed to predict the airflow pattern and thermal behavior in different arched greenhouses. The defined arc chord angle and position angle are employed to examine the natural ventilation process and corresponding roof vent scenarios. The numerical simulation is compared with the experimental data and good agreements are observed. Various configurations of ventilated structures, wind conditions and ventilation layouts are simulated on a high-resolution polyhedral grid based on a grid sensitivity analysis, which is beneficial to the optimization of greenhouse cooling combined with the water circulation heat collection system. The cooling effect in summer is analyzed by estimating the ventilation flow rate and microclimate inhomogeneity. The results demonstrate that the position angle of 85° of the arched greenhouses is an optimum ventilation direction and its impact on the microclimate is marginally affected by the change of the ventilation structure. The designed ventilation scheme has perfect air exchange capacity and cooling effect because the average air temperature can be reduced by 1.5°C more than the existing greenhouse in 10 minutes of ventilation. Likewise, the results show that the temperature and velocity inhomogeneities are approximately decreased by 33.3% and 11.89%, respectively. The practical value of the research is expected to provide basic quantitative conclusions for evaluating the natural ventilation performance.
In order to further improve the utilization of solar energy in Chinese Solar Greenhouse (CSG), this paper systematically studied the effects of orientation and structure on solar radiation interception in CSG. A solar radiation model has been developed based on the previous research, which taking solar motion law, meteorological data, and optical properties of materials into consideration. The established model was used to optimize the orientation and structure of CSG. The analysis of structure considered two major structural parameters, which are the ridge height and the horizontal projection of the rear roof. Moreover, the widely used Liao-Shen type Chinese solar greenhouse (CSG-LS) has been taken as the prototype in the present research, and the measured data of the typical clear day was used for the model validation. The results showed that the ridge height has a remarkable influence on the solar energy captured by CSG-LS. Compared with the optimization of a single factor, the comprehensive optimization of orientation and structure can increase the solar radiation interception of the rear wall by 3.95%. Considering the limiting factor of heat storage-release capacity and the shading effect on the greenhouse structure, the optimal lighting construction of the CSG-LS (with a span of 9.0 m) was specified as 7~9° from south to west of azimuth angle, 4.5~4.7 m ridge height, and 1.4~1.6 m horizontal projection of the rear roof at 42°N latitude. The proposed solar radiation model can provide scientific guidance for the CSG-LS construction in different areas.
10 December 2024 in Energy Conversion and Management