Impact indentation is believed to be an effective indication of low-velocity impact (LVI) damage for polymer matrix composites. However, it has been discovered that an indentation can partially rebound over time. Impact indentation and its rebound behavior over a period of time are significantly affected by hygrothermal conditions, especially moisture absorption. Therefore, a good understanding of the moisture-dependent impact indentation and its rebound behavior is helpful for impact damage assessment for composites. In this paper, moisture effects are considered for both the intra-laminar transverse property model and the interlaminar interface model in the simulation of impact indentation. Then, in these two models, viscosities are introduced to represent the indentation rebound over time. In order to validate the proposed models, LVI experiments with different impact energies were conducted on dry and hygrothermal conditioned carbon fiber/epoxy matrix composite laminates. For the specimens, the initial depths of impact dents and their rebounds over time were measured. The specimens of hygrothermal conditions were found with deeper dents compared with dry ones under the same impact energy; and their rebounds were also more significant. These phenomena were explained by the fact that moisture softens epoxy in composite and meanwhile elevates its viscosity. This indentation and its rebound phenomenon were simulated in ABAQUS by considering the moisture effects and viscoelasticity with user-defined material subroutines. These experiments were simulated using the proposed models, and the numerical predictions conformed well with the experimental observations.
Indentation is an effective indication of LVI damage in PMCs. However, indentation can rebound partly with time. Thus, a good understanding of the rebound behavior of the impacted pit is helpful in damage assessment for composites. In this paper, a transverse isotropic viscoelastic model and a viscoelastic cohesive interface model are proposed to represent the viscoelastic properties of ply and the interface between adjacent plies, respectively. In these models, we implement the in-plane 3D Hashin failure criterion to simulate ply level failures and the stress-based quadratic failure criterion and linear softening mixed-mode BK law to simulate cohesive interface failure initiation and propagation, respectively. LVI testing was performed on specimens at different impact energies (30 J, 40 J, and 50 J). Dents induced by impact will eventually rebound due to the viscoelastic behavior of plies and cohesive interfaces. This results in a decrease in depth with time. This indentation and its rebound phenomenon were simulated in ABAQUS by considering viscoelasticity with user-defined material subroutines. The simulation results show good agreement with the experimental observations and are validated accurately in terms of the indentation’s initial depth upon impact and its final rebound with time. From experiments, it was observed that the decrease in the original depth of indentation initially becomes faster with time after impact; then, it slows down with time and eventually stops due to viscoelasticity. While this decrease in the original depth of indentation remains invariable with time in simulation, it has a different rebound path.