High-frequency surface wave radar (HFSWR) has been successfully developed for early warning, especially for monitoring the moving vessels. However, it can be blinded by space spread clutter (SSC) which can cover a wide looking directions, such as sea clutter and ionospheric clutter in HFSWR. A few methods have made great efforts for SSC cancellation, but these efforts make no sense for the clutter in main-lobe that is a long-standing problem. In this paper, a spread clutter estimated canceller (SCEC) based on single notch space filter has been developed for SSC cancellation to cancel the clutter in the main-lobe with the idea of estimating the SSC in the looking direction through the ones in side-lobes. The feasibility of the idea has been described and demonstrated by the results of simulations and measured data which make great significance for target detection and tracking.

High Frequency Surface Wave Radar (HFSWR) can perform the functions of ocean environment monitoring, target detection, and target tracking over the horizon. However, its system's performance is always limited by the severe ionospheric clutter environment, especially by the nonhomogeneous component. The nonhomogeneous ionospheric clutter generally can cover a few Doppler shift units and a few angle units. Consequently, weak targets masked by the nonhomogeneous ionospheric clutter are difficult to be detected. In this paper, a novel algorithm based on angle-Doppler joint eigenvector which considers the angle-Doppler map of radar echoes is adopted to analyze the characteristics of the nonhomogeneous ionospheric clutter. Given the measured data set, we first investigate the correlation between the signal of interest (SOI) and the nonhomogeneous ionospheric clutter and then the correlation between the nonhomogeneous ionospheric clutters in different two ranges. Finally, a new strategy of training data selection is proposed to improve the joint domain localised (JDL) algorithm. Simulation results show that the improved-JDL algorithm is effective and the performance of weak target detection within nonhomogeneous ionospheric clutter is improved.

High frequency surface wave radar (HFSWR) has been successfully developed for early warning and remote sensing. However, the ionospheric clutter is a difficult challenge that can make HFSWR system inefficient. The Generalized Side-lobe Canceller (GSC) has been proved to be an effective algorithm for clutter suppression in theory, but it suffers from the performance degradation for some non-ideal conditions in practice. The most intolerable shortcoming is the signal to noise ratio (SNR) loss caused by the residual signal in the secondary data. In this paper, a knowledge-based GSC (KB-GSC) method has been proposed via an adaptive single notch filter design to reject the residual signal for reducing the SNR loss. The feasibility and availability has been demonstrated by measured data.

The frequency diverse array (FDA) multiple-input multiple-output (MIMO) radar combined with long-baseline transmit array (LBTA-FDA-MIMO) is presented for high accuracy direction-of-arrival (DOA) estimation, and the transmit array is designed in the form of a four-antenna interferometer in this letter. However, the ambiguities of both angle and range exist at the same time. To deal with this problem, a joint-disambiguation method based on ESPRIT is proposed and the uniqueness theorem is proved. The main idea of this method is that the unambiguous-rough-estimation for angle is used to solve the ambiguities of fine-estimation expressions coupled with angle and range. Compared with FDA-MIMO radar, the LBTA-FDA-MIMO radar significantly improves the angle estimation accuracy, and interestingly, it also improves the ranging accuracy via simulations.

In high-frequency surface wave radar (HFSWR), part of the radiation signal inevitably propagates upward and illuminates the target through the ionosphere due to the poor controllability of the antenna’s vertical pattern. As a result, a target may have several echoes from different propagation modes, which affect target detection and tracking and is usually unmanageable in existing HFSWR systems. Without the information of the elevation angle, it is difficult to distinguish the propagation mode of measurements during the target detection phase. This paper makes the first attempt to propose a multi-mode target tracker for HFSWR to solve this problem during the target tracking phase. The multipath probability data association (MPDA) tracker is capable of exploiting multipath target signatures of discrete propagation modes and has been widely used. Based on this, we construct a modified multi-mode probability data association tracker for HFSWR to suppress false tracks caused by multiple propagation modes. Numerical simulations demonstrate that this novel tracker can effectively and accurately track the target from the measurements under multiple propagation modes in HFSWR. The processing results of the actual data collected in Weihai, China indicate that this tracker is of great significance for practical applications.

The broadened first-order sea clutter in shipborne high frequency surface wave radar (HFSWR), which will mask the targets with low radial velocity, is a kind of classical space–time coupled clutter. Space–time adaptive processing (STAP) has been proven to be an effective clutter suppression algorithm for space-time coupled clutter. To further improve the efficiency of clutter suppression, a STAP method based on a generalized sidelobe canceller (GSC) structure, named as the auxiliary channel STAP, was introduced into shipborne HFSWR. To obtain precise clutter information for the clutter covariance matrix (CCM) estimation, an approach based on the prior knowledge to auxiliary channel selection is proposed. Auxiliary channels are selected along the clutter ridge of the first-order sea clutter, whose distribution can be determined by the system parameters and regarded as pre-knowledge. To deal with the heterogeneity of the spreading first-order sea clutter, an innovative training samples selection approach according to the Riemannian distance is presented. The range cells that had shorter Riemannian distances to the cell under test (CUT) were chosen as training samples. Experimental results with measured data verified the effectiveness of the proposed algorithm, and the comparison with the existing clutter suppression algorithms showed the superiority of the algorithm.