This paper presents a method for modeling the dynamic properties of steel–polymer concrete beams, the basic structural components of machine tools, assembly lines, vibratory machines, and other structures subjected to time-varying loads during operation. The presented method of modeling steel–polymer concrete beams was developed using the finite element method. Three models of beams differing in cross-sectional dimensions showed high agreement with experimental data: relative error in the case of natural frequencies did not exceed 5% (2.2% on average), the models were characterized by the full agreement of mode shapes and high agreement of frequency response functions with the results of experimental tests. Additionally, the developed beam models supported the reliable description of complex structures, as demonstrated on a spatial frame, obtaining a relative error for natural frequencies of less than 3% (on average 1.7%). Full agreement with the mode shapes and high agreement with the frequency response functions were achieved in the analyzed frequency range.
15 April 2019 in Journal of Theoretical and Applied Mechanics
The article presents results of both experimental and FEM model-based investigations on chatter phenomena that occur in the end milling process. On the basis of chatter symptoms observed during machining, the mechanism of its occurrence has been identified. Then, a FEM model has been built to...
Modeling of dynamic properties of machine tools has a significant influence on improvement of its construction. This process is extremely important when a new construction of machine tool is under development. Experimental modal analysis provides information about frequency bandwidths with significant amplitudes of resonances, damping values and mode shapes. This information can be used in FEM model updating, stability prediction or finding weak elements of the machine tool structure as well. In the paper the modal model of prototype of the micro machining center is presented. Polymax algorithm was used to estimate the poles (frequency, damping) of modal model and modal shapes. Modal model was built on the basis of the impact test results. Methodology of conducted experimental test is presented. Tested machine tool was made of different materials (steel, aluminum, stone and others) which causes difficulties during experimental investigations. In the construction different types of guideways were implemented — rolling, slide and pneumatic ones. Maximum rotational speed of the tool is about 100 000 rev/min, so the frequency range where poles of modal model are estimated is wide (high frequencies of excitation during machining). Weight of sensors used during testing is an important issue due to a low mass of the structure. Also the excitation of the structure is troublesome because of vulnerability of precise guideways and forces sensors used in machine tool construction. Validation of the modal model is also presented in the paper and practical problems of modal testing are discussed.
Water-hammer transients in pressurized pipelines are governed by the coupled compressibility of the liquid and the elastic response of the pipe wall. This study quantifies the sensitivity of transient pressure responses to variations in pipe material, system geometry, and liquid properties using a one-dimensional Method of Characteristics (MOC) model incorporating a convolution-based formulation of unsteady friction. The model is applied to an experimental copper-pipe system under laminar and turbulent flow conditions. A one-factor-at-a-time (OFAT) sensitivity analysis is performed by independently varying selected parameters by ±5% and ±10%, including Young’s modulus, Poisson’s ratio, pipe-wall thickness, internal radius, liquid density, bulk modulus, and kinematic viscosity. The results show that liquid density, liquid bulk modulus, and pipe Young’s modulus significantly affect pressure-wave celerity and the temporal evolution of the transient response. Pipe internal radius has a pronounced influence on the pressure response, while the effects of viscosity and bulk modulus become more significant under turbulent-flow conditions. Combined variations in material, pipeline geometry, and liquid properties yield pressure-wave celerities ranging from approximately 1159 to 1479 m/s, demonstrating the substantial influence of input-property uncertainty on predicted transient behavior. The OFAT results are further analyzed using multiple-valued logic (MVL) decision trees and classification and regression tree (CART) models to identify dominant parameter–response relationships and threshold values. The findings highlight the importance of accurately characterizing pipe-material and liquid properties for reliable water-hammer prediction and the assessment of pressurized pipeline systems.