This paper presents a high‐speed simultaneous bidirectional transceiver (SBT) for on‐chip wireline communications. A MOS hybrid transistor is utilized to split the received data from the superimposed signal at both ends of the on‐chip interconnection with the assistance of two drivers, namely main and auxiliary. Moreover, a high‐pass filter (HPF) is used as a differentiator to generate the echo cancelation signal. Consequently, the echo‐cancelation for simultaneous bidirectional signaling (SBS) is realized by the combination of the hybrid device and the differentiator. The proposed SBT has been designed and evaluated using 28‐nm CMOS technology over a narrow 5‐mm on‐chip interconnection, which possesses 11.9‐dB loss at the Nyquist frequency (half a bit rate). The energy‐efficiency of the proposed full‐duplex transceiver (FDT) for 20‐Gbps simultaneous bidirectional data transmission is 0.147 PJ/b/mm. The performance results show that the proposed SBT has better overall performance compared to the previous architectures reported in the literature to date. The layout of the presented SBT occupies a low area of 1574 μm2.
Performance of a high-speed network on a chip is mainly affected by the performance of the global on-chip interconnects. This paper investigates a point-to-point transmission line interconnect to address the performance limitations due to the scaling problems of on-chip global interconnects in new CMOS technologies. A brief explanation is given about the basic properties of the transmission lines that should be considered. Moreover, the design methodology is given for designing the on-chip interconnect and understanding its behavior. Based on the different transmission line geometry, 3D EM simulations are done and S-parameters are carried out to analyze the effects of the different metal layers, width of the signal line, and space to shield layers of the interconnect. This results in a systematic understanding of the design of the on-chip interconnect and its performance dependence on various parameters. Finally, a 5 mm length on-chip lossy transmission line with serpentine shape and shielding layers is implemented in 8-metal-layer 28 nm CMOS standard technology.
A high-speed full-duplex transceiver (FDT) over lossy on-chip interconnects is presented. The FDT employs a hybrid circuit to separate the inbound and outbound signals from each other and also performs echo-cancellation with the help of the main and the auxiliary drivers. A hybrid MOS device is utilized for impedance matching and conversion of the received voltage signal into a current signal for amplification. Moreover, a compensation capacitance ( ) is used at the output of the main driver to minimize the residual echo signal and achieve a higher data rate. The entire FDT architecture has been designed in TSMC 28 nm CMOS standard process with 0.9 V supply voltage. The performance results validate a 16 Gbps FD operation with a root-mean-square (RMS) jitter of 16.4 ps, and a power efficiency of 0.16 pJ/b/mm over a 5 mm on-chip interconnect without significant effect due to process-voltage-temperature (PVT) variations. To the best knowledge of the authors, this work shows the highest achievable full-duplex data rate, among the solutions reported in the literature to date, yet with low complexity, low layout area of 1581 and competitive power efficiency.