The paper discusses the synthesis and performance of iodine doped titania nanotube arrays exhibited under irradiation. The doping procedure was performed as an additional, electrochemical process carried out after formation of nanotube arrays via anodization of the Ti substrate. The optical and structural properties were characterized using Raman, UV-vis, photoluminescence and X-ray photoelectron spectroscopy. The surface morphology and cross-section studies performed by means of scanning electron microscopy show that the ordered tubular architecture is not influenced by the doping method. However, iodine doping causes a reduction of bandgap energy and photoluminescence intensity. The nanotubular TiO2 electrodes have been monitored by electrochemical (using cyclic voltammetry and electrochemical impedance spectroscopy) and in situ UV-vis spectroelectrochemical measurements in contact with an aqueous electrolyte. Collected results show significant differences in electrochemical activity between pure and doped titania exhibited as i.e. change of Mott–Schottky relation or shift in the onset potential when a decrease in reflectance is initiated. The photocurrent density reached 155.2 and 142.2 μA cm−2 for iodine doped materials when KI and HIO4 were used as iodine precursors whereas only 25.6 μA cm−2 was registered for pure titania nanotubes under UV-vis illumination. Moreover, doped samples are far more efficient for the photodegradation progress than undoped material leading to decomposition of over 70% of methylene blue used as a model organic pollutant. The reported studies demonstrate for the first time the detailed optical, electrochemical and photoelectrochemical studies of iodine doped nanotube arrays.
Nitrogen doped titania nanotubes were successfully sensitized by the electrochemical method, i.e. as-anodized titania was immersed in different amine (diethylenetriamine – DETA, triethylamine – TEA, and ethylenediamine – EDA) and urea (U) solutions and a constant potential was applied. The highly ordered morphology of fabricated N-TiO2 was investigated by scanning electron microscopy. Spectroscopic techniques, i.e. UV-Vis spectroscopy, Raman spectroscopy, X-ray photoelectron spectroscopy and photoluminescence spectroscopy, were utilized to characterize absorbance capability and the crystalline phase, to confirm the presence of nitrogen atoms and to study charge recombination, respectively. The highest photocurrent under both UV-Vis and visible illumination (λ > 420 nm) was registered for the N-TiO2 sample obtained from diethylenetriamine solution, used as a nitrogen precursor. The photocurrent density exhibited during UV-Vis irradiation by the most active nitrogen doped titania was 2.83 times higher compared to pure TiO2 nanotubes. The photocatalytic activity studies demonstrated a significant improvement when N-TiO2–DETA (52%) and N-TiO2–U samples (49%) where used instead of undoped TiO2 (27%). The presented results show that electrochemical doping with 0.5 M amine or urea solutions is a simple, cheap and effective strategy to introduce nitrogen atoms into the titania structure without affecting its morphology.