Sirona Valdueza-Felip

Dr. Sirona Valdueza-Felip

orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 May 2020 in Materials
Verified
Journal Article
Open access
PDF file
SVSirona Valdueza-Felip
Sirona Valdueza-Felip
RBRodrigo Blasco
Rodrigo Blasco
JOJavier Olea
Javier Olea
ADAlba Díaz-Lobo
Alba Díaz-Lobo
ACAlejandro Francisco Braña de Cal
Alejandro Francisco Braña de Cal
Fernando NaranjoFernando Naranjo
Fernando Naranjo
We investigate the photovoltaic performance of solar cells based on n-AlxIn1−xN (x = 0–0.56) on p-Si (100) hetero-junctions deposited by radio frequency sputtering. The AlxIn1−xN layers own an optical bandgap absorption edge tuneable from 1.73 eV to 2.56 eV within the Al content range. This increase of Al content results in more resistive layers (≈10−4–1 Ω·cm) while the residual carrier concentration drops from ~1021 to ~1019 cm−3. As a result, the top n-contact resistance varies from ≈10−1 to 1 MΩ for InN to Al0.56In0.44N-based devices, respectively. Best results are obtained for devices with 28% Al that exhibit a broad external quantum efficiency covering the full solar spectrum with a maximum of 80% at 750 nm, an open-circuit voltage of 0.39 V, a short-circuit current density of 17.1 mA/cm2 and a conversion efficiency of 2.12% under air mass 1.5 global (AM1.5G) illumination (1 sun), rendering them promising for novel low-cost III-nitride on Si photovoltaic devices. For Al contents above 28%, the electrical performance of the structures lessens due to the high top-contact resistivity.

9 January 2020 in Physica Status Solidi (b)
Verified
Journal Article
Closed access
PDF file
RBRodrigo Blasco
Rodrigo Blasco
SVSirona Valdueza-Felip
Sirona Valdueza-Felip
DMDaniel Montero
Daniel Montero
MSMichael Sun
Michael Sun
JOJavier Olea
Javier Olea
FNFernando B. Naranjo
Fernando B. Naranjo

21 October 2022 in Materials
Verified
Journal Article
Open access
PDF file
MSMichael Sun
Michael Sun
RBRodrigo Blasco
Rodrigo Blasco
Julian NwodoJulian Nwodo
Julian Nwodo
María De La MataMaría De La Mata
María De La Mata
Sergio I MolinaSergio I Molina
Sergio I Molina
Fernando NaranjoFernando Naranjo
Fernando Naranjo
AlxIn1−xN ternary semiconductors have attracted much interest for application in photovoltaic devices. Here, we compare the material quality of AlxIn1−xN layers deposited on Si with different crystallographic orientations, (100) and (111), via radio-frequency (RF) sputtering. To modulate their Al content, the Al RF power was varied from 0 to 225 W, whereas the In RF power and deposition temperature were fixed at 30 W and 300 °C, respectively. X-ray diffraction measurements reveal a c-axis-oriented wurtzite structure with no phase separation regardless of the Al content (x = 0–0.50), which increases with the Al power supply. The surface morphology of the AlxIn1−xN layers improves with increasing Al content (the root-mean-square roughness decreases from ≈12 to 2.5 nm), and it is similar for samples grown on both Si substrates. The amorphous layer (~2.5 nm thick) found at the interface with the substrates explains the weak influence of their orientation on the properties of the AlxIn1−xN films. Simultaneously grown AlxIn1−xN-on-sapphire samples point to a residual n-type carrier concentration in the 1020–1021 cm−3 range. The optical band gap energy of these layers evolves from 1.75 to 2.56 eV with the increase in the Al. PL measurements of AlxIn1−xN show a blue shift in the peak emission when adding the Al, as expected. We also observe an increase in the FWHM of the main peak and a decrease in the integrated emission with the Al content in room-temperature PL measurements. In general, the material quality of the AlxIn1-xN films on Si is similar for both crystallographic orientations.

4 October 2012 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
SVSirona Valdueza-Felip
Sirona Valdueza-Felip
LMLaura Monteagudo-Lerma
Laura Monteagudo-Lerma
JMJuliette Mangeney
Juliette Mangeney
MHMiguel González Herráez
Miguel González Herráez
FJFrançois H. Julien
François H. Julien
FNFernando B. Naranjo
Fernando B. Naranjo
We report on the nonlinear optical absorption of InN films deposited on GaN templates by radio-frequency (RF) sputtering. The layers are characterized through the pump-probe technique at 1.55 μm, by obtaining a nonlinear absorption coefficient of 167±30 cm/GW with a nonlinear response recovery time of 380 fs. This nonlinear behavior is attributed to a two-photon absorption process followed by a free carrier absorption by the photogenerated carriers. These results render InN films deposited by RF sputtering particularly suitable for ultrafast all-optical devices based on low-cost technology.

29 August 2025 in Micromachines
Verified
Journal Article
Open access
PDF file
MCMiriam Cadenas
Miriam Cadenas
MSMichael Sun
Michael Sun
Susana FernándezSusana Fernández
Susana Fernández
SVSirona Valdueza-Felip
Sirona Valdueza-Felip
Ana Maria Diez-PascualAna Maria Diez-Pascual
Ana Maria Diez-Pascual
Fernando NaranjoFernando Naranjo
Fernando Naranjo
Aluminum nitride (AlN) is a material of wide interest in the optoelectronics and high-power electronics industry. The deposition of AlN thin films at elevated temperatures is a well-established process, but its implementation on flexible substrates with conductive oxides, such as ITO-glass or ITO-PET, poses challenges due to the thermal degradation of these materials. In this work, the deposition and characterization of AlN thin films by reactive sputtering at a low temperature (RT and 100 °C) on ITO-glass and ITO-PET substrates are presented. The structural, optical, and electrical properties of the samples have been analysed as a function of the sputtering power and the deposition temperature. XRD analysis revealed the absence of peaks of crystalline AlN, indicative of the formation of an amorphous phase. EDX measurements performed on the ITO-glass substrate with a radiofrequency power applied to the Al target of 175 W confirmed the presence of Al and N, corroborating the deposition of AlN. SEM analyses showed the formation of homogeneous and compact layers, and transmission optical measurements revealed a bandgap of around 5.82 eV, depending on the deposition conditions. Electrical resistivity measurements indicated an insulating character. Overall, these findings confirm the potential of amorphous AlN for applications in flexible optoelectronic devices.

24 October 2016 in arXiv
Verified
Preprint
Open access
PDF file
SVSirona Valdueza-Felip
Sirona Valdueza-Felip
AAA. Ajay
A. Ajay
LRL. Redaelli
L. Redaelli
MCM. P. Chauvat
M. P. Chauvat
PRP. Ruterana
P. Ruterana
EME. Monroy
E. Monroy
We report the influence of the In mole fraction on the material and electrical characteristics of p-i-n InxGa1-xN homojunctions (x = 0.10-0.40) synthesized by plasma-assisted molecular-beam epitaxy on GaN-on-sapphire substrates. Junctions terminated with p-InGaN present improved carrier extraction efficiency in comparison with devices capped with p-GaN, due to the deleterious effect of polarization discontinuities on the device performance. We demonstrate that the presence of Mg does not perturb the In incorporation in InGaN, and it leads to a significant reduction of the stacking fault density. p-In0.3Ga0.7N layers with a hole concentration of 3.2x1018 cm-3 are demonstrated. InGaN homojunction devices show a peak EQE = 14+-2% in the blue-to-orange spectral region, and an extended cutoff to 600 nm.