The use of innovative higher-performance highly reactive resin systems requires an enhancement of the established method of fiber impregnation (open bath) towards closed resin-injection pultrusion (CIP), due to the short pot life of the resin systems. The result is that the open bath is developed into a closed injection and impregnation chamber (“ii-chamber”). In this study, three parameters—resin viscosity, opening angle and opening factor at the injection point on the ii-chamber—are varied, each in three stages. For each set of parameters, a pultrusion trial is conducted and the process pressures in the ii-chamber and pultrusion die measured. This enables direct feedback via the process conditions of the as yet uncured composite. The data obtained are used to validate a newly developed simulation model. The model is based on Darcy’s law, which has been extended to take fiber movement into account and thus represent the resulting pressure increase in the die. The flexible ii-chamber and die concept enhance our understanding of the processes taking place in the die system. The sensitivity of the process pressures can be shown for the three influencing variables. The experiment shows that of the three influencing variables investigated, viscosity has the greatest sensitivity to pressure development. In general, it can be said that over the length of the pultrusion die system, the pressure level increases across the three measuring points.
The present study investigates the effect of power ultrasonic on the expansion of fiber strands. A potential application of such expansion is in the production process known as closed injection pultrusion. The fiber strand in the pultrusion injection chamber is in compacted form, and so, any expansion of the fiber strand resulting from power ultrasonic should lead to improved fiber wetting. To investigate this, a wetted fiber strand was clamped on two sides and sonicated in the middle from below. The potential expansion of the fiber strand was visually determined through an observation window. The study concluded that power ultrasonic has a minimal to virtually negligible effect on the expansion of both glass and carbon fiber. The degree of expansion remains within a range of 3% maximum, with a standard deviation in the respective midpoint tests of up to 60% for glass fiber and over 100% for carbon fiber. This shows that the fibers are limited in their freedom of movement, and so no expansion can be achieved using power ultrasonic. A further increase in amplitude does not lead to any further expansion but to the destruction of the fibers.