Changyeop Lee

Mr. Changyeop Lee


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 May 2020 in Sensors
Verified
Journal Article
Open access
PDF file
CLChangyeop Lee
Changyeop Lee
GCGyuseong Cho
Gyuseong Cho
TUTroy Unruh
Troy Unruh
SHSeop Hur
Seop Hur
IKInyong Kwon
Inyong Kwon
According to the continuous development of metal-oxide semiconductor (MOS) fabrication technology, transistors have naturally become more radiation-tolerant through steadily decreasing gate-oxide thickness, increasing the tunneling probability between gate-oxide and channel. Unfortunately, despite this radiation-hardened property of developed transistors, the field of nuclear power plants (NPPs) requires even higher radiation hardness levels. Particularly, total ionizing dose (TID) of approximately 1 Mrad could be required for readout circuitry under severe accident conditions with 100 Mrad around a reactor in-core required. In harsh radiating environments such as NPPs, sensors such as micro-pocket-fission detectors (MPFD) would be a promising technology to be operated for detecting neutrons in reactor cores. For those sensors, readout circuits should be fundamentally placed close to sensing devices for minimizing signal interferences and white noise. Therefore, radiation hardening ability is necessary for the circuits under high radiation environments. This paper presents various integrated circuit designs for a radiation hardened charge-sensitive amplifier (CSA) by using SiGe 130 nm and Si 180 nm fabrication processes with different channel widths and transistor types of complementary metal-oxide-semiconductor (CMOS) and bipolar CMOS (BiCMOS). These circuits were tested under γ–ray environment with Cobalt-60 of high level activity: 490 kCi. The experiment results indicate amplitude degradation of 2.85%–34.3%, fall time increase of 201–1730 ns, as well as a signal-to-noise ratio (SNR) of 0.07–11.6 dB decrease with irradiation dose increase. These results can provide design guidelines for radiation hardening operational amplifiers in terms of transistor sizes and structures.

1 November 2024 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
CTCharlie Tahar
Charlie Tahar
CLChangyeop Lee
Changyeop Lee
HKHyojun Kim
Hyojun Kim
KKKi-Ho Kwon
Ki-Ho Kwon
SRSeung-Tak Ryu
Seung-Tak Ryu
This work presents radiation hardened by design (RHBD) on a high voltage (HV) digital-to-analog converter (DAC). A 12-bit HV DAC aiming at satellite-applications is configured as a current-steering-assisted R-2R ladder with common-level control resistors and parallel switches. The DAC structure employs current sources to mitigate the total ionizing dose (TID) sensitivity from switch resistance in a conventional R-2R ladder. PMOS current sources and polysilicon-based R-2R networks are utilized to avoid TID-induced leakage. Common-level control resistors are introduced to increase voltage headroom for the current sources. To reduce single event effect (SEE)-induced bit-flip in control signals, parallel switches scheme in every unit current source is proposed. An on-chip amplifier facilitates current-to-voltage conversion and output driving. The chip, manufactured in a 0.35 μm HV CMOS technology, occupies 2.97 mm 2 . TID test was conducted in two phases (up to 116 krad(Si) and 226 krad(Si)) with Co-60 source. After being exposed to irradiation, the DAC exhibits less than 2 least significant bit (LSB) of integral nonlinearity (INL) degradation at 116 krad(Si), then recovers to within 1 LSB and 1.5 LSB from pre-irradiation at 116 krad(Si) and 226 krad(Si) of total dose, respectively, after 24 hours of room-temperature annealing. SEE test with 20 minutes of 100 MeV proton irradiation shows no evidence of bit upset or fluctuation at the DAC output nodes.

11 January 2024 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
CLChangyeop Lee
Changyeop Lee
IKInyong Kwon
Inyong Kwon
This article presents a self-compensated charge-sensitive amplifier (CSA) for total ionizing dose (TID) effects, which directly compensates for the nonlinearity characteristic of the preamplifier, caused by radiation. The proposed circuit is operated by monitoring on amplitude degradation of a replicated CSA from a constant pulse and compensating the main CSA from the gain bandwidth product (GBWP) equation with current steering DAC control. The proposed technique was evaluated under a gamma-ray irradiation environment using Cobalt-60 with an activity of 490 kCi at Korea Atomic Energy Research Institute (KAERI) in Korea and provided a linear output with an amplitude degradation of 0.9%. In contrast, a noncompensated CSA showed a 70% decrease in amplitude after irradiation exposed to up to 5 Mrad (SiO2). The proposed technique was fabricated in a 180-nm standard BiCMOS technology. This direct compensation approach offers a promising solution to reduce radiation effects on the preamplifier for applications of radiation-hardened electronics.

1 January 2026 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
CTCharlie Tahar
Charlie Tahar
CLChangyeop Lee
Changyeop Lee
KPKun-Woo Park
Kun-Woo Park
KLKent Edrian Lozada
Kent Edrian Lozada
HKHyojun Kim
Hyojun Kim
SRSeung-Tak Ryu
Seung-Tak Ryu