During the lifespan of a Polymer Electrolyte Membrane Fuel Cell (PEMFC) system, some heterogeneities between the cells constituting the stack can appear. The voltage of one particular cell in a stack may decrease because of specific aging or local malfunctioning such as drying. As a result, more heat is generated in this cell leading to an increase in its temperature and thus an additional voltage loss. This snowball effect can result in the failure of the cell. Therefore, the lifetime of a PEMFC stack can be increased by applying energy management to its cells. Notable that the output voltage of a cell is lower than a stack. Hence, a high conversion ratio converter is necessary to implement such energy management. An efficient way to increase the output voltage is to connect the output capacitors of the converters such as the boosts in series. Ensuring the converters' controllability is a key point to implement energy management. In this paper, an equalizer system is proposed to ensure the controllability of the boost converters. The balancing speed and the low number of switches are the main advantages of this system. The validity of the proposed system is verified through simulation and experiments.
To deal with the intermittency of renewable energy resources, hydrogen as an energy carrier is a good solution. The Polymer Electrolyte Membrane Fuel Cell (PEMFC) as a device that can directly convert hydrogen energy to electricity is an important part of this solution. However, durability and cost are two hurdles that must be overcome to enable the mass deployment of the technology. In this paper, a management system is proposed for the fuel cells that can cope with the durability issue by a suitable distribution of electrical power between cell groups. The proposed power electronics architecture is studied in this paper. A dynamical average model is developed for the proposed system. The validation of the model is verified by simulation and experimental results. Then, this model is used to prove the stability and robustness of the control method. Finally, the energy management system is assessed experimentally in three different conditions. The experimental results validate the effectiveness of the proposed topology for developing a management system with which the instability of cells can be confronted. The experimental results verify that the system can supply the load profile even during the degradation mode of one stack and while trying to cure it.
This paper introduces an adaptive Hamiltonian energy control strategy for the proposed Fuel Cell (FC) hybrid power electronics architecture. The proposed controller with added integrator action is based on the Hamiltonian–Lyapunov function. In contrast to previous work, the proposed control method aims to control the output current of the Proton Exchange Membrane Fuel Cells (PEMFCs), while the DC bus voltage is controlled by the supercapacitor. Moreover, integrators are built into the control structure to eliminate steady-state errors in current and voltage, respectively. The Lyapunov candidate function is chosen to demonstrate the large-signal stability of the whole system. A nonlinear control strategy based on the flatness control theory is adopted for the energy management strategy of the hybrid system composed of fuel cell and supercapacitor. The experimental results demonstrate the effectiveness and feasibility of the proposed control method.
Contribution à l'élaboration d'un système de gestion des piles à combustible: L'intermittence des ressources constitue le principal défi de l'utilisation de la production d'électricité à partir d'énergies renouvelables. Par conséquent, de nouveaux moyens de stockage de l'électricité sont inévitables. L'hydrogène, en tant que vecteur énergétique, peut résoudre ce problème. L'hydrogène peut être produit en utilisant l'énergie excédentaire des sources d'énergie renouvelables. C'est pourquoi une pile à combustible à membrane électrolytique polymère (PEMFC), en tant que dispositif capable de convertir directement l'énergie de l'hydrogène en électricité, est un élément important de cette solution. Le coût et la durabilité sont les principaux défis à relever pour permettre la diffusion de cette technologie sur le marché de masse. Dans le cadre d'un micro-réseau multi-vecteurs, un système de gestion des piles à combustible (FCMS) est proposé et conçu dans cette thèse. Il permet d'optimiser la fiabilité et la durée de vie des PEMFC en contrôlant l'état de fonctionnement des cellules pour éviter les instabilités électrochimiques. Une méthode de diagnostic ainsi qu'une nouvelle architecture d'électronique de puissance hybride sont le cœur de ce FCMS. La méthode de diagnostic peut détecter la plupart des instabilités du FCMS grâce à un nouveau modèle en temps réel. Ce modèle peut simuler une cellule dans son environnement de pile. Une architecture d'électronique de puissance hybride est développée pour ce FCMS qui garantit un meilleur vieillissement du système en contrôlant séparément la puissance fournie par les cellules. L'architecture d'électronique de puissance proposée est hybridée par un supercondensateur (SC) qui peut compenser la faible dynamique des PEMFC en fournissant les profils de charge dynamiques rapides. Une méthode de contrôle en logique floue (FLC) est développée dans le cadre du FCMS pour modifier la puissance de référence des groupes de cellules sur la base des données du modèle. Le système proposé et ses différentes parties sont validés par les résultats de la simulation et de l'expérimentation.