CaCO3 precipitation is physical-chemical basis of biomineral formation of hard tissue (shells, skeletons) in marine calcifying organisms (=biomineralization). Processes controlling biomineralization are still not fully clarified, so the study of influence of pH on basic processes of CaCO3 precipitation should contribute to better understanding of biomineralization under climate change. This paper reports on the effect of initial pH (pH0) and type of stirring (mechanical and magnetical) on spontaneous precipitation and phase composition, size and morphology of spontaneously precipitated CaCO3 formed at the identical initial supersaturation, ionic strength and a(Ca2+)/a(CO32−) ratio. The initial pH varied in a range 8.50 ≤ pH0 ≤ 10.50 and included values relevant for mimicking the conditions related to biomineralization in marine organisms. In all systems two CaCO3 polymorphs were found: calcite and/or vaterite. The increase of pH0 favoured the formation of rhombohedral calcite no matter the type of stirring. This was exclusively influenced by the systems’ pH0 (other relevant initial parameters were identical). Furthermore, increase of pH0 caused change of vaterite morphology from cauliflower-like spheroids to regular spherulites. The mechanically stirred systems produced larger calcite and vaterite particles and higher content of calcite.
In recent years, the production and application of biochar as a soil amendment produced from pruning residues has gained attention worldwide. Since the effect of grapevine rootstock type on grapevine-pruning residues used as feedstock for biochar production had not yet been researched, the present research was performed. Two grapevine rootstocks, different in vigor, were selected, with the hypothesis that they would affect their chemical composition and, consequently, the composition of the produced biochar. In this work, grapevine-pruning residues of the indigenous variety “Istrian Malvasia” (Vitis vinifera L.) grafted on 420A and SO4 rootstocks were analyzed and used for biochar production under three peak temperature programs (400 °C, 500 °C, and 600 °C). Higher pyrolysis temperature decreased yield but increased EC, ash, and TC content, as well as the content of most of the studied elements. On the other hand, grapevine rootstock type affected biochar EC, ash content, and specific surface area. Results showed that a more vigorous rootstock affects the produced biochar qualities by enhancing the above-mentioned properties. The present research showed that biochar produced from grapevine-pruning residues, especially at 500 °C or 600 °C, could be a valuable tool for the valorization of this biomass as a soil amendment.
Amorphous calcium carbonate (ACC) and calcium phosphate (ACP) increasingly attract attention as initial solid phases in vertebrate and invertebrate hard tissue formation, as well as in materials science as a possible new synthetic route for advanced materials preparation. Although much is known about these two amorphous phases and similarities in the mechanisms of their formation are recognized, no attempt has been made to investigate their formation under defined and comparable initial experimental conditions, viz. supersaturation, the ratio of constituent ions, ionic strength and the presence of relevant inorganic additives. In this paper, the formation of ACC and ACP in three model precipitation systems of increased chemical complexity was investigated: (a) systems containing constituent ions, (b) systems containing additional co-ions, and (c) systems with higher ionic strength and addition of Mg2+. The results have shown that ACP is more stable and was formed at lower relative supersaturations in comparison to ACC. The precipitation domain of both phases expanded with increasing complexity of precipitation systems, with the ACP precipitation domains always being larger than those of ACC. In addition to stability, the presence of inorganic ions, especially Mg2+, influences the composition of both amorphous phases. The obtained results indicate that general similarity between ACC and ACP exists, but it could also be concluded that the similar chemical environment in which they form not necessarily leads to similar structural properties.
Gallic acid and its metal complexes are good antioxidants that could be used to increase the body's immune system against degenerative and viral diseases. Therefore, such complexes could be used as a good alternative to supplementary medicines and may have potential significance in clinical trials. Differential pulse voltammetry, UV/VIS spectroscopy, and potentiometry were used to analyse the complexation of gallic acid with calcium in this study. The metal : ligand ratio was determined using Job's continuous variation method and was found to be 2 : 1. The stability constant of calcium gallate was determined with potentiometric titration with a calcium electrode, which amounted to K° = 4.83 × 106 (log K° = 6.7). The combination of the results obtained in this study gives a deeper insight into the complexation of gallic acid with calcium and determines the stability constant of calcium gallate.