Electric Vehicles (EV) offer eco-friendly transportation, but the growth of the electric vehicle market year over year is very minimal due to insufficient EV charging stations, slow charging time and grid instability during peak hours. This paper proposes a high gain, fast charging DC–DC converter and a control algorithm for grid integrated Solar PV based Electric Vehicle Charging Station (SPV-EVCS) with battery backup. The proposed converter and its control algorithm’s performance are investigated in three different modes using MATLAB/Simulink tool and the simulated results are validated with Real-Time Digital Simulation (RTDS) in OPAL-RT. The observed results meet the Power Quality limits of an IEC61000-3-2 standard and met the level-4 dc charging standard IEC61851.
20 March 2020 in International Transactions on Electrical Energy Systems
Solar Photovoltaic (SPV)-based power generation systems are popular among various renewable energy sources due to their flexibility in capacity addition and low maintenance cost .The output power from an SPV plant is intermittent due to inconsistent atmospheric temperature and irradiance, which influences the reliability, stability and power quality of the utility grid. To be specific the intermittency of solar plant output imposes harmonics and resonance issues in the grid. These issues can be solved by using appropriate controllers in the inverter system. In this work, a DC link voltage control-based PI controller and a rotating reference frame technique-based PR controller are used on the input side and on the grid side of the inverter, respectively .The PR controller minimizes the voltage distortion caused due to the resonance in the LCL filter employed on the grid side of the inverter . It also aids in reducing the steady-state error of the system, thus minimizing the lower order harmonics. The proposed controllers i.e. PI and PR controllers, are simulated and analyzed using MATLAB Simulink and the simulation results are validated using a 1 kW solar PV prototype model.
The component count for the multilevel inverter has been a research topic for the last few decades. The higher number of power semiconductor devices and sources leads to a higher power loss with the complex control requirement. A new multilevel inverter topology employing the concept of half-Bridge modules is suggested in this paper. It requires a lower number of dc sources and power components. The inverter is controlled using a fundamental frequency switching scheme. With the basic unit being able to produce 13 level voltage waveforms with three dc voltage sources, higher-level inverter configuration has also been discussed in the paper. The performance of the topology is analyzed in the aspects of circuit parameters and found better when compared to similar topologies proposed in recent literature. The comparison provided in the paper set the benchmark of the proposed topology in terms of lower component requirements. The topology is also optimized with two voltage fixing algorithms for maximizing the number of levels for the given number of IGBTs, drivers and dc sources, and the observations are presented. The efficiency analysis gives the peak efficiency as 98.5%. The simulations were carried out using the PLECS software tool and validated using a prototype rated at 500 W. The results with several test conditions have been reported and discussed in the paper.
15 April 2019 in Journal of the Chinese Institute of Engineers
Multilevel inverters can synthesize a high-voltage staircase waveform with low- and medium-voltage components. A new multilevel inverter topology called Asymmetric Dual Source Multilevel Inverter (ADS-MLI) is proposed. When compared to the topologies found in the literature, it can produce multiple levels in the output voltage with fewer power switches. Most of the topologies found in the literature require cascading features to achieve asymmetric operation; but the ADS-MLI can operate without the need for cascading. A simulation prototype capable of synthesizing 13 levels is developed in MATLAB Simulink environment. Its performance is evaluated in the aspects of; number of switching components, efficiency, THD, switching voltage stress and common mode voltage. The simulated efficiency and power quality of the DS-MLI is validated using a 1 kW prototype fabricated using FGA25N120-ANTD controlled by FPGA-SPARTAN 6 processor. Further, the DS-MLI is field tested with a 1 kW solar PV unit and the results are presented.